Summary of the content on the page No. 1
JLBIUCL 01
built-in refrigerator
Instruction manual
Summary of the content on the page No. 2
Important Safety Information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings. These warnings have been provided in the interest of safety.You MUST read them carefully
Summary of the content on the page No. 3
Environmental Information When disposing of your appliance, use an authorised disposal site. Remove the plug and ensure that any locks or catches are removed, to prevent young children being trapped inside. The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly
Summary of the content on the page No. 4
Contents For the Installer For the User Installation 6 Important Safety Information 2 Description of the appliance 5 Technical Specification 6 Operation 13 Electrical Connection 6 Before using 13 Positioning 7 Start your appliance 13 Door Reversal 8 Temperature control 13 Building In 9 Fresh food refrigeration 13 Normal operating sounds 13 Movable shelves 14 Guide to use the Instruction Positioning the door shelves 14 Manual Hints and Tips 15 The following symbols will be found in the text to
Summary of the content on the page No. 5
Description of the Appliance 1 Dairy compartments 2 Movable storage shelf 3 Bottle storage shelf 4 Interior light 5 Storage shelves 6 Salad crispers 5
Summary of the content on the page No. 6
Installation It is dangerous to alter the specifications or Any electrical work required to install this attempt to modify this product in any way. appliance should be carried out by a qualified electrician or competent person. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Technical Data Heating elements rating Dimensions of recess Supply voltage (50 Hz) 220-240 V Height 820 mm Connected load, 70 W Width 600 mm Fridge light 15 W Depth 550 mm Dime
Summary of the content on the page No. 7
Important Warning IF YOU ARE DISCARDING AN OLD APPLIANCE It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily THAT HAS A LOCK OR CATCH ON THE DOOR, accessible after installation. YOU MUST ENSURE THAT IT IS MADE UNUSABLE TO PREVENT YOUNG CHILDREN BEING TRAPPED INSIDE. Depending upon the position which you choose for your appliance, you may wish to reverse the way in which the door opens.To do this, refer to instructions on “Door reversal d
Summary of the content on the page No. 8
Door Reversal To reverse the opening direction of the door, proceed as shown in the figures: 6 6 4 1 7 8 5 6 2 3 1 2 Warning 6 10 After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is 13 cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdryer on a low setting. 9 6 1
Summary of the content on the page No. 9
600 550 min. Building In Before carrying out any work, remove the plug from Building in the appliance the power socket. under a worktop Grid preparation The dimensions of the recessed installation area must correspond with those indicated in the figure. Left door opening: Remove the left side (A) of the grid cutting it from the rear (see figure). A B DO013 Installation kit DO002/2 Right door opening: Remove the right side (B) of the grid cutting it from
the rear (see figure). To
Summary of the content on the page No. 10
2. Push the appliance into place.The plug socket 4. The joint cover (B) is to be assembled after having necessary for connection of the appliance to the installed the appliance in the recess. electricity supply should be positioned, so that the plug is not placed in the recess. 3. To adjust the height proceed as follows: - Loosen or tighten the two front feet. - The rear feet are adjusted by turning the screw in the front kick plate to the left or right. 5. Screw appliance into pla
Summary of the content on the page No. 11
% !" # !" # Upper part of kitchen furniture panel $ $ 11 $ $
Summary of the content on the page No. 12
Fitting the plinth Important For the efficient operation of the appliance, it is important that the original ventilation grid is used. For an opening height dimension A=820 mm and a plinth height dimension a=100 mm, the plinth may be fitted without adjustments.The same applies to an opening height dimension B=870 mm and a plinth height dimension b=150 mm. For plinth heights greater than a=100 mm, b=150 mm, a cut should be made in the plinth, 580 mm wide, in the centre of the
Summary of the content on the page No. 13
OPERATION Before using Remove all securing tapes.Wash inside the appliance Important with lukewarm water and bicarbonate of soda (5 ml to 0.5 litre of water). During prolonged periods of abnormally hot weather, if the thermostat is set on too high a Do not use soap or detergent as the smell number, the cooling system may operate may linger. Dry thoroughly. continuously and the fridge cooling plate may not defrost.Turning the knob to a lower number will Start your appliance cause the automatic de
Summary of the content on the page No. 14
Movable shelves The walls of the refrigerator have runners so that the shelves can be positioned as desired . For better use of space, the front half-shelves can lie over the rear ones. Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be adjusted in height.To make these adjustments proceed as follows: Remove the top door shelf by pulling them in the direction of the arrows, then gradually slide the shelf sideways until it comes off.Then
Summary of the content on the page No. 15
Hints and Tips Food Storage Energy Saving Advice To obtain the best results from your appliance, Do not install the cabinet close to sources of neither hot foods nor liquids which may heat, i.e. boiler or radiator. evaporate, should be placed in the larder Locate the appliance in a cool well ventilated compartment. room and make sure that the air openings of the Keep the time between buying chilled food and cabinet are not obstructed. placing it in your fridge as short as possible. Av
Summary of the content on the page No. 16
Maintenance and Cleaning Before any maintenance or cleaning work is carried Defrosting out, DISCONNECT the appliance from the ELECTRICITY supply. The refrigerator automatically defrosts every time the compressor stops.The water is discharged, via Internal cleaning the pipe, into a tray located below the appliance, Clean the inside and accessories with warm water where it evaporates. and bicarbonate of soda (5ml to 0.5 litre of water). Important Rinse and dry thoroughly. To avoid defrost water ov
Summary of the content on the page No. 17
Something not working Important: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation a charge will be made, even if the appliance is under guarantee. Before contacting your local Service Force Centre, check the following points: SYMPTOM SOLUTION 4 No power to the appliance Check there is power at the socket. Check there is not a power cut by checking the household lights. Check the fuse has not blown. 4 The light does not come on Ens
Summary of the content on the page No. 18
Repairs - After Sales Service If your appliance is not performing satisfactorily; Spare parts consult the fault finding guide within this instruction This product should be serviced by an authorised book (Something not working). In the event of a service engineer, and only genuine spare parts should fault occurring which you cannot resolve yourself be used. from advice given within this instruction manual your first step is to contact our extended warranty Under no circumstances should you atte
Summary of the content on the page No. 19
Summary of the content on the page No. 20
John Lewis Partnership 171 Victoria Street London SW1E 5NN www.johnlewis.com 09/06 2222 676-24
