Summary of the content on the page No. 1
Design Guide with
Installation
Instructions
Double-Drawer Built-In Refrigerator
ZIDI240
ZIDS240
monogram.com
Summary of the content on the page No. 2
Safety Information BEFORE YOU BEGIN: WARNING: • Double-Drawer Refrigerators are designed to be Read these instructions completely and carefully. built-in only. They cannot be used free-standing. • Use this appliance only for its intended purpose. IMPORTANT – Save these instructions • Immediately repair or replace electrical service cords for local inspector’s use. that become frayed or damaged. IMPORTANT – Observe all governing codes • Unplug the unit before cleaning or making repairs. and ordi
Summary of the content on the page No. 3
Important Information CONTENTS Design Guide (for ZIDI240) Important Information Step 3, Level ..................................................7 The Installation Space ..............................5 Tools, Hardware ........................................3 Step 4, Connect Power ............................8 Product Clearances....................................5 Parts Required..............................................3 Step 5, Slide Product into Cutout ........8 Side-by-Side Installations
Summary of the content on the page No. 4
Design Guide FOR MODEL ZIDS240 WITH STAINLESS STEEL DRAWERS AND HANDLES THE INSTALLATION SPACE PRODUCT CLEARANCES IMPORTANT: Double-Drawer Refrigerators are When installed Countertop designed to be built-in only. They cannot be used in a corner: free-standing. Double-Drawer Locate Outlet 8-1/2" 10-1/2" 24" 9" 9" Max. 34-1/2"-35" Max. 22" min. 1-1/2" 1-1/2" 34-1/4" 23-3/4" Min. to 34-3/4" Clearance for Door Opening 2-1/2" min. Allow 2-1⁄2″ min. clearance between Double-Drawer NOTE: 25
Summary of the content on the page No. 5
Design Guide FOR MODEL ZIDI240 WITH CUSTOM DRAWER PANELS AND HANDLES THE INSTALLATION SPACE PRODUCT CLEARANCES IMPORTANT: Double-Drawer Refrigerators are When installed Countertop designed to be built-in only. They cannot be used in a corner: free-standing. Double-Drawer Locate Outlet 8-1/2" 10-1/2" 24" 9" 9" Max. 34-1/2"-35" Max. 23-1/8" min. 1-1/2" 1-1/2" 23-3/4" Min. Clearance for Door Opening 2-1/2" min. Allow 2-1⁄2″ min. clearance between Double-Drawer and adjacent cabinet, wall
Summary of the content on the page No. 6
Installation Instructions STEP 1 REMOVE PACKAGING STEP 2 INSTALL CUSTOM 3/4″ DRAWER PANELS AND • Remove corner blocks and foam drawer stops. HANDLES (CONT.) • Remove all packing material, tape and protective plastic coverings. (ZIDI240 model only) Install custom drawer panels and handles: CAUTION: Small objects are a choke hazard • Open drawers. for children. Remove and discard any parts not used. • Remove 2 screws holding each trim; lift trims off. ATTENTION : Les petits objets peuvent Reta
Summary of the content on the page No. 7
Installation Instructions STEP 3 LEVEL STEP 2 INSTALL CUSTOM 3/4″ DRAWER PANELS AND Use an adjustable wrench to turn and raise or lower the leveling legs. HANDLES (CONT.) • Measure floor to countertop height inside the opening. (ZIDI240 model only) Adjust leveling legs until the product is approximately • Reinstall the side trims using the trim screws removed 1/8″ less than countertop height. earlier. Turn Right to Lower • Place the brushed decorative covers over the side trim Turn Left to Ra
Summary of the content on the page No. 8
Installation Instructions STEP 4 CONNECT POWER STEP 6 SET TEMPERATURE CONTROLS • Connect power cord plug to a properly grounded • The temperature controls are preset. Refer to receptacle. the Owner’s Manual for more information. Allow 12–24 hours for the temperature to stabilize. • Check to make sure power is on by opening a drawer to see if interior light turns on. NOTE: The Double-Drawer Refrigerator operates very • The interior fan runs all the time except when a quietly. You may not notic
