Summary of the content on the page No. 1
KDC-X895
KDC-BT848U
KDC-X595
KDC-448U
CD-RECEIVER
Quick Start Guide
AMPLI-TUNER LECTEUR DE CD
Guide de démarrage rapide
REPRODUCTOR DE DISCOS COMPACTOS RECEPTOR DE FM/AM
Guía de inicio rápido
Take the time to read through this instruction manual.
Familiarity with installation and operation procedures will help you obtain the best
performance from your new CD-Receiver.
For your records
Record the serial number, found on the back of the unit, in the spaces designated on the
warranty card, and in
Summary of the content on the page No. 2
Contents About the Quick Start Guide About the Quick Start Guide............... 2 This Quick Start Guide explains the basic Before use .................................................. 3 functions of this unit. For functions that are not explained here, refer to the Preparations .............................................. 4 relevant Instruction Manual which can be downloaded at http://manual.kenwood. Basic operations ....................................... 5 com/edition/im327. To refer
Summary of the content on the page No. 3
Before use 2 WARNING About discs used with this unit • This unit can only play the CDs with To prevent injury or fire, take the following precautions: . • Stop the car before operating the unit. • The following discs cannot be used: • To prevent a short circuit, never put or - Discs that are not round leave any metallic objects (such as coins - Discs with coloring on the recording or metal tools) inside the unit. surface or discs that are dirty - Recordable/Rewritable disc that has ¤ CAUT
Summary of the content on the page No. 4
Preparations Release Control knob (Volume knob) [DISP] Exit Demonstration Mode Detaching/ Reattaching the Turn off the demonstration mode Faceplate when you use it for the first time after installation. Press the Control knob to quit the demonstration mode when the messages “To Cancel DEMO Press the Press the Release volume knob” are displayed (approx. 15 button. seconds). Turn the Control knob and press it when the “YES” is displayed. The demonstration mode can also be canceled i
Summary of the content on the page No. 5
Basic operations KDC-X595 KDC-X895 KDC-448U KDC-BT848U USB terminal [ ] [SRC] Control knob [iPod] [ ] [ ] [DISP] [LOG] Auxiliary input Power Auxiliary input Turn the power ON by pressing the Portable audio device can be connected [SRC] button. with the stereo mini-plug (3.5 mm ø). Press the [SRC] button for at least 1 Display selection second to turn the power OFF. Every time the [DISP] button is pressed, Source selection the display switches among 5 types. Press the [SRC] button e
Summary of the content on the page No. 6
Playing music (CD/USB/iPod) [ ] [SRC] [ ] Control knob Disc slot 0 [ ] USB Terminal Playing disc Music search Insert the disc in the Disc slot. Searching for the song you want to play. When inserted, the source is switched Press the [ ] button. automatically and a song starts playing. Search for music. Playing USB device/ iPod Operation type Operation Connect a USB device or iPod to the USB Movement between items Turn the Control knob. terminal. Selection of item Press the Control
Summary of the content on the page No. 7
Listening to the radio [SRC] Control knob [PRESET] number (FM: “01” – “18”, AM: “01” – “06”), Selecting a tuner source and then press the Control knob for at Press the [SRC] button to select “TUNER”. least 2 seconds. Selecting the band Recalling the stations in the Push the Control knob towards down to change the band (FM or AM). memory Push the Control knob towards down to Selecting a station change the band (FM or AM). Push the Control knob leftward and rightward to select the station
Summary of the content on the page No. 8
Function of KDC-X895, KDC-BT848U, KCA-BT200/BT300 (Optional Accessory) Hands-free phoning KDC-X895 KDC-X595 KDC-BT848U KDC-448U [SRC] Control knob [ ] [ ] [iPod] [LOG] KDC-X595 KDC-448U Registering c ell-phone Register your Bluetooth cell-phone in By operating the cell-phone, register this unit. the hands-free unit (pairing). Select “KCA-BT200” or “KCA-BT300” from the list KDC-X895 KDC-BT848U of connected units. Press the [ ] button for at least 1 Enter the PIN code
Summary of the content on the page No. 9
Calling a number in the Phone Answering a phone call KDC-X895 KDC-BT848U book Press the [ ] button. Dial the phone number in the phone book of your cell phone. KDC-X595 KDC-448U If the phone book has not been Press the Control knob. downloaded to this unit, operate the cell- Disconnecting a call phone to download it. KDC-X895 KDC-BT848U KDC-X895 KDC-BT848U Press the [ ] button. Press the [ ] button. KDC-X595 KDC-448U KDC-X595 KDC-448U Press the [SRC] button. Press
Summary of the content on the page No. 10
Installation accessories Before installation 2 WARNING 1 • The unit can only be installed in a car with a 12V DC power supply, negative ground. .....1 • If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground), you may cause a short 2 circuit, that in turn may start a fire. Always connect those wires to the power source running through the fuse box. .....2 ¤ CAUTION 3 • Install this unit in the console of your vehicle. • Do not touch the met
Summary of the content on the page No. 11
connector of the left speaker to a front For Good Reception output terminal, do not connect the - To assure good reception, note the connector to a rear output terminal. following: • Connect the speaker wires correctly to the • Communicate with the cell-phone within terminals to which they correspond. The the line-of-sight distance of 10 m (30 unit may be damaged or fail to work if ft). The communication range becomes you share the - wires or ground them to shorter depending on the sur
Summary of the content on the page No. 12
Connecting wires to terminals To Kenwood disc changer/ External optional accessory To connect these leads, refer to the ⁄ relevant instruction manuals. ⁄ • Speaker Impedance: 4 – 8 Ω • USB terminal Maximum Supply current: 500 mA White To front left speaker White/Black Gray To front right speaker Gray/Black Green To rear left speaker Green/Black Purple To rear right speaker Purple/Black Ignition key switch Car fuse box ACC Red (Ignition wire) Yellow (Battery wire) Car fuse box (Main fuse)
Summary of the content on the page No. 13
Rear output R L Front output Sub Woofer output Fuse (10A) FM/AM antenna input R L Microphone (Accessory5) (KDC-X895, KDC-BT848U only) Wiring harness (Accessory1) If no connections are made, do not let the wire come out from the tab. Blue/White (Power control wire) When using the optional power amplifier, connect to its power control terminal. P.CONT Depending on what antenna you are using, connect either to the control Blue (Antenna control wire) terminal of the motor antenna, or to the
Summary of the content on the page No. 14
Installation/Removal of the unit Non-Japanese cars Removing the hard rubber frame Engage the catch pins on the removal tool and remove the two locks on the upper level. Lift up and pull the frame forward as shown in the figure. Catch Bend the tabs of the mounting sleeve Lock with a screwdriver or similar utensil and attach it in place. Removal tool (Accessory2) ⁄ When the upper level is removed, • Make sure that the unit is installed remove the lower two locations. securely in place. I
Summary of the content on the page No. 15
KDC-X895, KDC-BT848U only Installation of the A p pendix Microphone Unit About Audio file • Playable Audio file Check the installation position of the AAC-LC (.m4a), MP3 (.mp3), WMA (.wma) microphone (accessory 5). • Playable disc media Remove oil and other dirt from the CD-R/RW/ROM installation surface. • Playable disc file format Install the microphone. ISO 9660 Level 1/2, Joliet, Romeo, Long Wire the cable up to the unit with it file name. secured at several positions using ta
Summary of the content on the page No. 16
Table des matières À propos du Guide de démarrage rapide À propos du Guide de démarrage rapide ..........................................................16 Ce Guide de démarrage rapide décrit les Avant utilisation ..........................................17 fonctions de base de cet appareil. Pour les fonctions qui ne sont pas expliquées ici, voir le Préparatifs .....................................................18 Mode d'emploi correspondant qui peut être téléchargé sur http://manual.ke
Summary of the content on the page No. 17
Avant utilisation À propos des disques utilisables avec 2 AVERTISSEMENT cet appareil Pour éviter toute blessure et/ • Cet appareil ne peut lire que les CD comportant ou incendie, veuillez prendre les précautions suivantes : . • Arrêtez le véhicule avant de manipuler les • Les disques suivants sont incompatibles avec commandes de l'appareil. cet appareil : • Pour éviter tout court-circuit, ne posez jamais - Les disques qui ne sont pas ronds d'objets métalliques (telles que pièces ou outils
Summary of the content on the page No. 18
Préparatifs Libération Bouton de commande (réglage du volume) [DISP] Sortie du mode démonstration Détachement/Remise en place de la La première fois que vous utilisez l'appareil façade après l'avoir installé, vous devez désactiver le mode de démonstration. 1 Pour quitter le mode démonstration, appuyez sur le bouton de commande lorsque le message “To Cancel DEMO Press the volume knob” (Appuyez sur le bouton Appuyez sur la touche de libération. de volume pour annuler la démo) apparaît (pe
Summary of the content on the page No. 19
Commande de base KDC-X895 KDC-X595 Bouton de KDC-448U KDC-BT848U Prise USB [ ] [SRC] commande [iPod] [ ] [ ] [DISP] [LOG] Entrée auxiliaire Alimentation Entrée auxiliaire Appuyez sur la touche [SRC] pour mettre Un baladeur audio peut être branché sur la l'appareil en marche. prise pour minijack stéréo (ø 3,5 mm). Appuyez sur la touche [SRC] pendant au Sélection de l'affichage moins 1 seconde pour arrêter l'appareil. Chaque pression sur la touche [DISP] Sélection de la source comm
Summary of the content on the page No. 20
Reproduction de la musique (CD/USB/iPod) Bouton de Fente pour [ ] [SRC] [0] commande le disque [ ] Prise USB Lecture d'un disque Recherche de morceau Insérez le disque dans la fente. Recherche du morceau que vous souhaitez Une fois le disque inséré, la source change écouter. automatiquement et la lecture d'un 1 Appuyez sur la touche [ ]. morceau commence. 2 Recherche du morceau. Lecture à partir d'un périphérique Type de commande Commande USB ou d'un iPod Mouvement entre les Tournez
