Firestone Sport Rite 9127 user manual

Summary of the content on the page No. 1

2047 / 2232
AIR COMMAND
AIR COMPRESSOR ACCESSORY KIT
INSTALLATION INSTRUCTIONS
NOTE:
Congratulations on your purchase of a new Ride-Rite
Air Compressor Accessory Kit. This kit will be an asset to
If you are planning to install the Ride-Rite Fully
your vehicle, meeting nearly any of your air supply needs.
Automatic control or Cab Control Height Adjustment
systems, the Air Compressor Accessory Kit and the Ride-
Please take a few minutes to read through the
Rite air helper springs kit designed to

Summary of the content on the page No. 2

VEHICLE PANEL Air Tank Attachment Air Compressor Accessory Kit WR1-760-2047 INFLATION VALVE AIR TANK PUSH-TO-CONNECT PUSH-TO-CONNECT MALE CONNECTOR MALE CONNECTOR AIR TANK BRACKET RED WIRE TO FUSE BOX OR OTHER POWER SOURCE PRESSURE 25' Extension Hose SWITCH + BRASS "T" FITTING AIR COMPRESSOR BLACK WIRE Figure “A” 3/8”-16 X 1-1/2 HEX BOLTS 3/8” FLAT WASHER AIR TANK BRACKET 3/8” LOCK NUT AIR LINE RED WIRE AIR LINE

Summary of the content on the page No. 3

NOTE ON CONNECTING AIR LINE TUBING BRASS SLEEVE COMPRESSOR FOOT Cut the air line tubing as squarely as possible. To connect the air line tubing to the fittings push the tubing into the fittings as far as possible. If for any reason the tubing must be removed the collar of RUBBER the fitting can be pushed toward the body of the fitting and the tubing ISOLATOR can be removed. Make sure the air helper springs are deflated. To reassemble make sure the tubing is cut squarely and push back into th

Summary of the content on the page No. 4

STEP 5 Select a point on your vehicle for the inflation valve. This should be a rigid surface, easily accessible and convenient (examples might be a wheel well or bumper). Drill a 5/16" hole and install the inflation valve as shown in Figure "C". Tighten the inflation valve securely and replace the cap. NOTE: The cap should always be replaced to protect the inflation valve from dirt and debris. STEP 6 Measure a length of remaining air line tubing to run from the tank to the inflation valve.