Summary of the content on the page No. 1
DRYER
SÉCHEUSE
USE AND CARE GUIDE
GUIDE D’UTILISATION ET
D’ENTRETIEN
Para una version de estas instrucciones en español, visite www.Whirlpool.com
Table of Contents Table des matières
DRYER SAFETY ............................................................2 SÉCURITÉ DE LA SÉCHEUSE ...................................14
CHECK YOUR VENT SYSTEM VÉRIFICATION D’UNE CIRCULATION D’AIR
FOR GOOD AIR FLOW .................................................4 ADÉQUATE POUR LE SYSTÈME D’ÉVACUATI
Summary of the content on the page No. 2
DRYER SAFETY 2
Summary of the content on the page No. 3
3
Summary of the content on the page No. 4
CHECK YOUR VENT SYSTEM FOR GOOD AIR FLOW Maintain good air flow by: n Cleaning your lint screen before each load. n Replace plastic or foil vent material with 4" (102 mm) diameter heavy, rigid vent material. 4" (102 mm) n Use the shortest length of vent possible. n Use no more than four 90° elbows in a vent system; each bend and curve reduces air flow. Good Better Good Air Flow Along with heat, dryers require good air flow to efficiently dry laundry. Proper venting will reduce your dr
Summary of the content on the page No. 5
CONTROL PANEL & FEATURES 1 2 3 4 7 6 5 9 8 Not all features and options are available on all models. Appearance may vary. 1 POWER BUTTON 5 CYCLE SIGNAL Press to turn the dryer on and off. The Cycle Signal produces an audible sound when the drying cycle is finished. Promptly removing clothes at the end of the cycle reduces wrinkling. 2 DRYER CYCLE KNOB Use your Dryer Cycle Knob to select available cycles on Press CYCLE SIGNAL until the desired volume (Loud, Soft, your dryer. Turn the knob
Summary of the content on the page No. 6
CYCLE GUIDE — AUTOMATIC CYCLES Not all cycles and settings are available on all models. Settings and options shown in bold are default settings for that cycle. AUTOMATIC DRY - Senses moisture in the load or air temperature and shuts off when the load reaches the selected dryness level. Gives the best drying in the shortest time. Drying time varies based on fabric type, load size, and dryness setting. The dryer will default to Normal Dryness Level to save energy. Depending on model, temperatur
Summary of the content on the page No. 7
USING YOUR DRYER 1. Clean the lint screen 2. Load the dryer Clean the lint screen before each load. Pull the lint screen Place laundry in the dryer. Close the door. Do not tightly pack straight up. Roll lint off the screen with your fingers. Do not rinse the dryer; clothes should be able to tumble freely. or wash screen to remove lint. Push the lint screen firmly back into place. For additional cleaning information, see “Dryer Care.” 3. Press POWER Press the POWER button to turn on the dry
Summary of the content on the page No. 8
4. Select the desired cycle 6. Select cycle options (if desired) Add additional options by pressing the button. NOTE: Not all options and settings are available with all cycles. 7. Press START/PAUSE to begin cycle Select the desired cycle for your load. See the “Cycle Guide” or the display for more information about each cycle. NOTE: Not all options and settings are available with all cycles. 5. Set cycle settings Press the START/PAUSE button to begin the cycle. 8. Remove garments promptly
Summary of the content on the page No. 9
DRYER CARE Cleaning the dryer location Cleaning the lint screen Every load cleaning Keep dryer area clear and free from items that would block the air flow for proper dryer operation. This includes The lint screen is located in the door opening of the dryer. clearing piles of laundry in front of the dryer. A screen blocked by lint can increase drying time. To clean: 1. Pull the lint screen straight up. Roll lint off the screen with your fingers. Do not rinse or wash screen to remove lint.
Summary of the content on the page No. 10
Vacation, storage, and moving care Changing the drum light (on some models) Non-Use or Storage Care 1. Unplug dryer or disconnect power. Operate your dryer only when you are at home. If you will 2. Open the dryer door. Locate the light bulb cover on the be on vacation or not using your dryer for an extended back wall of the dryer. Using a Phillips-head screwdriver, period of time, you should: remove the screw located in the lower right-hand corner 1. Unplug dryer or disconnect power. of th
Summary of the content on the page No. 11
TROUBLESHOOTING First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions) to possibly avoid the cost of a service call...In U.S.A. http://www.whirlpool.com/help - In Canada www.whirlpool.ca If you experience Possible Causes Solution Lint screen clogged with lint. Lint screen should be cleaned before each load. Clothes are not drying satisfactorily, drying Air Dry cycle has been selected. Select the right cycle for the types of garments being
Summary of the content on the page No. 12
TROUBLESHOOTING cont. First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions) to possibly avoid the cost of a service call...In U.S.A. http://www.whirlpool.com/help - In Canada www.whirlpool.ca If you experience Possible Causes Solution Dryer displaying code “PF” (power failure), Was the drying cycle interrupted by a power failure? message Start LED flashes Press START/PAUSE to restart the dryer. “F# E#” (F1 E1, F3 E1, etc.) variable If a cod
Summary of the content on the page No. 13
WHIRLPOOL CORPORATION LAUNDRY WARRANTY LIMITED WARRANTY For one year from the date of purchase, when this major appliance is operated and maintained according to instructions attached to or furnished with the product, Whirlpool Corporation or Whirlpool Canada LP (hereafter “Whirlpool”) will pay for Factory Specified Parts and repair labor to correct defects in materials or workmanship that existed when this major appliance was purchased. Service must be provided by a Whirlpool designated serv
Summary of the content on the page No. 14
SÉCURITÉ DE LA SÉCHEUSE 14
Summary of the content on the page No. 15
15
Summary of the content on the page No. 16
VÉRIFICATION D’UNE CIRCULATION D’AIR ADÉQUATE POUR LE SYSTÈME D’ÉVACUATION Maintenir une bonne circulation d’air en effectuant les opérations suivantes : n Nettoyer le filtre à charpie avant chaque charge. n Remplacer le matériau de conduits d’évacuation en plastique ou en aluminium par des conduits d’évacuation lourds et rigides de 4” (102 mm) de diamètre. 4" 4" (102 mm) n Toujours employer les conduits d’évacuation les plus courts possible. n Ne pas utiliser plus de quatre coudes à 9
Summary of the content on the page No. 17
TABLEAU DE COMMANDE ET CARACTÉRISTIQUES 1 2 3 4 7 6 5 9 8 Certains programmes et options ne sont pas disponibles sur certains modèles. L’apparence des appareils peut varier. 1 BOUTON POWER (Mise sous tension) TIME – MORE or LESS (temps – plus ou moins) Appuyer sur ce bouton pour mettre la sécheuse en marche (utilisation uniquement avec les programmes et pour l’éteindre. manuels) Appuyer PLUS ou MOINS pour ajouter ou soustraire le temps de séchage. BOUTON DE PROGRAMME DE LA SÉCHEUSE 2 Utilis
Summary of the content on the page No. 18
8 CYCLE STATUS LIGHTS (Témoins lumineux de programme) Ces témoins lumineux indiquent quelle portion du programme la sécheuse est en train d’effectuer. 9 ECO-MONITOR (Éco-moniteur) L’éco-moniteur indique la consommation d’énergie estimée selon les programmes et options utilisés. GUIDE DE PROGRAMMES — PROGRAMMES AUTOMATIQUES Certains programmes ne sont pas disponibles sur certains modèles. Les réglages et options indiqués en gras sont les réglages par défaut pour ce programme. SÉCHAGE AUT
Summary of the content on the page No. 19
GUIDE DE PROGRAMMES — PROGRAMMES MANUELS Certains programmes ne sont pas disponibles sur certains modèles. Les réglages et options indiqués en gras sont les réglages par défaut pour ce programme. TIMED DRY (séchage minuté) - Fait fonctionner la sécheuse pour la durée spécifiée sur le module de commande. Selon le modèle, la température peut soit être sélectionnée à partir du bouton de programme, soit constituer une commande séparée. Articles à Programme : Température de Durée par Options D
Summary of the content on the page No. 20
UTILISATION DE LA SÉCHEUSE 1. Nettoyer le filtre à charpie 3. Appuyer sur POWER (mise sous tension) Appuyer sur le bouton POWER (mise sous tension) pour mettre la sécheuse en marche. 4. Sélectionner le programme désiré Nettoyer le filtre à charpie avant chaque charge. Enlever le filtre à charpie en le tirant tout droit vers le haut. Enlever la charpie du filtre en la roulant avec les doigts. Ne pas rincer ni laver le filtre pour enlever la charpie. Remettre le filtre à charpie fermement
