Summary of the content on the page No. 1
JLTDC11
Condenser dryer with heat pump
Instruction manual
Summary of the content on the page No. 2
Important safety information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings. These warnings have been provided in the interest of safety. You MUST read them careful
Summary of the content on the page No. 3
• If you have washed your laundry with stain • Any electrical work required to install this remover you must execute an extra rinse appliance should be carried out by a cycle before loading your tumble dryer. qualified electrician or competent person. • Please make sure that no gas lighters or • If the machine is situated on a carpeted matches have accidentally been left in floor, please adjust the feet in order to pockets of garments incase they are loaded allow air to circulate freely under th
Summary of the content on the page No. 4
• Fabric softeners, or similar products should – Ensure you have good ventilation in the be used as specified by the fabric softener installation room; instructions. – Clean the micro-fine filter and fine • Caution - hot surface : Do not touch the strainer after each drying cycle; door light cover surface when the light is – Spin the laundry well before drying. switched on. Energy consumption depends on (Only dryers equipped with internal drum spinning speed set in washing machine. light) Higher
Summary of the content on the page No. 5
product is disposed of correctly, you will help detailed information about recycling of this prevent potential negative consequences for product, please contact your local council, the environment and human health, which your household waste disposal service or the could otherwise be caused by inappropriate shop where you purchased the product. waste handling of this product. For more 5
Summary of the content on the page No. 6
Contents For the user For the installer Important safety information 2 Technical specifications 23 Description of the appliance 7 Installation 24 Transporting the appliance 24 Control panel 8 Appliance positioning 24 Removing transport safety packaging 25 Before first use 8 Electrical connection 25 Programme chart 9 Door reversal 27 Sorting and preparing laundry 10 Repairs - after sales service 27 Daily use 11 Switching machine on 11 Door opening and laundry loadi
Summary of the content on the page No. 7
Description of the appliance 1 2 3 4 5 6 8 7 9 11 10 12 1 Control panel 7 Rating plate 2 Water reservoir 8 Course fluff filter 3 Drum light 9 Heat exchanger cover 4 Fine fluff filter 10 Push button for base door opening 5 Fluff filter 11 Ventilation grille 6 Loading door (reversible) 12 Adjustable feet 7
Summary of the content on the page No. 8
Control panel 1 234 5 6 7 8 910 1 Programme selector and Off switch 7 Display ( Dry time ) 2 Extra delicate button 8 Start/Pause button 3 Intensive button 9 Warning lights: Condenser , Filter , Full tank 4 Anti-crease button 10 Delay start button 5 Alarm button 6 Time button Before first use In order to remove any residues which may Warning! If the appliance was not have been produced during production, wipe transported in an upright position, the dryer drum with a damp cloth or carry out leave
Summary of the content on the page No. 9
Programme chart Additional functions/options Programmes Application/properties Thorough drying of thick or multi- layered fabrics, Cottons Extra dry 7 kg - • • • - • e.g. terry towelling items, bathrobes, cottons. Cottons Store Thorough drying of thick fabrics, e.g. terry 7 kg - • • • - • dry towelling items, towels, cottons. Thorough drying of fabrics of even thicknesses, Cottons 7 kg - • • • - • e.g. terry towelling items, knitwear, towels, cotton Cupboard dry shirts. Cottons Damp For thin tex
Summary of the content on the page No. 10
Additional functions/options Programmes Application/properties For briefly treating woollens with warm air, after they have been dried naturally, worn or stored for Wool care 1 kg - - - • - • long periods. Wool becomes soft and cosy. Recommendation: remove fabrics immediately after drying. For refreshing or airing clothing that has been in Refresh 1 kg - - • • - • storage. Sorting and preparing laundry • Do not dry new, coloured textiles together Sorting laundry with light-coloured laundry items
Summary of the content on the page No. 11
Daily use Switching machine on Selecting the programme Turn the programme selector to any programme. The machine switches on. When the loading door is open, the internal lamp illuminates the drum. Door opening and laundry loading 1. Open loading door: Push against the loading door (push point) Use the programme selector to set the programme you require. The estimated time to end of the programme appears in the LCD in h:mm format (hours:minutes). During the cycle time elapses by steps of one minu
Summary of the content on the page No. 12
To deselect the function press the Extra removed at any time during the anti-crease delicate button again. LED above is off. phase. To deselect the function press the Anti- crease button again. The LED above is off. Intensive Press the Anti-crease button. A 90 minute anti- If the laundry is still damp after a standard crease phase is set. The display now shows drying programme, you can increase the the anti-crease icon. If this additional function drying result by using the Intensive function. i
Summary of the content on the page No. 13
1. Turn the programme selector to the If the display is showing 20h and you Time programme. The flashing 10' above press the button again, the time delay the Time button is on. will be cancelled. The display will show 0'and then the duration of the selected programme. 3. To activate the delay timer, press the Start/Pause button. The amount of time remaining until the programme is set to start is continuously displayed (e.g. 15h, 14h, 13h, … 30' etc). 2. Press the Time button repeatedly until the
Summary of the content on the page No. 14
Starting the programme Putting in extra items or Press the Start/Pause button. The taking items out before programme starts. end of programme The programme progress is shown by elapsing Dry time on LCD. 1. Open loading door. Warning! Laundry and drum can become hot. Risk of burns! 2. Load or remove laundry items. 3. Close loading securely. Lock must audibly lock. 4. Press the Start/Pause button to continue the drying cycle. Changing programme Drying cycle complete / To change a programme which h
Summary of the content on the page No. 15
2. Before removing the laundry, remove fluff The drying cycles are automatically from the micro-fine filter. It is best to use followed by an anti-crease phase a damp hand for this purpose. (See which lasts around 30 minutes. The “Maintenance and cleaning” chapter.) drum rotates at intervals during this 3. Remove laundry. phase. This keeps the laundry loose and free of creases. The laundry can be 4. Turn the programme selector to Off . removed at any time during the anti- Important! After each d
Summary of the content on the page No. 16
6. Remove the fluff from fine filter. It is best to use a damp hand for this purpose. Clean the entire filter area The filter area does not have to be cleaned after every drying cycle, but should be checked regularly and cleaned of fluff if necessary. 7. To do this, grip the top of the large mesh filter and pull it forwards until it comes loose from the two brackets. 4. Push down the unlock button on the large mesh filter. The large mesh filter pops up. 8. Remove fluff from the entire filter are
Summary of the content on the page No. 17
2. 1. 2. Pour the condensed water out into a basin or similar receptacle. If the fine filter is not fitted, the large mesh filter will not snap into place and the loading door cannot be closed. Cleaning the door seal Wipe the door seal with a damp cloth immediately after the drying cycle has finished. Emptying the water 3. Slide the outlet connections in and refit reservoir the water reservoir. If the programme has been interrupted as Empty the water reservoir after every drying a result of the
Summary of the content on the page No. 18
Cleaning heat exchanger filters If the warning lamp Condenser lights, the heat exchanger fluff filters in the base of the appliance must be cleaned, i.e. after each 5 drying cycles. Both filters are located in the appliance base. Water can collect in the filter housing therefore it is normal for the heat 2. Pull the filter housing out of the base by exchanger fluff filters to become wet. the handle. Important! • Never operate the dryer without the fluff 1 filters. 2 • Clogged filters cause highe
Summary of the content on the page No. 19
6. As necessary, approx. once every 6 months, remove the fluff from the heat exchanger using the sponge supplied. When doing this, please use rubber gloves. Tip: The fluff can be removed more easily if it is first dampened (e. g. with a laundry dampener) or with help of vacuum cleaner. Cleaning the drum Caution! Do not use abrasives or steel wool to clean the drum. Lime in the water or cleaning agents 4. Use a damp hand to remove the fluff from may form a barely visible lining on the the filter
Summary of the content on the page No. 20
Clean operating screen and housing Caution! Do not use furniture cleaners or aggressive cleaning agents to clean the machine. Use a damp cloth to wipe down the operating screen and housing. What to do if ... 1) Problem Possible cause Remedy Plug in at mains socket. Check fuse in fuse Dryer not connected to mains supply. box (domestic installation). Dryer does not work. Loading door opened. Close loading door The Start/Pause button not pressed. Press the Start/Pause button. 2) Incorrect programme