Summary of the content on the page No. 1
Start
Summary of the content on the page No. 2
1 Read all instructions before using this dryer. 2 The interior of the dryer should be cleaned periodically by qualified service personnel. An excessive amount of lint build up in the interior of the dryer could result in inefficient drying and pose a possible fire hazard. 3 The appliance must not be installed behind a lockable door, a sliding door or a door with a hinge on the opposite side to that of the tumble dryer in such a way that a full opening of the tu
Summary of the content on the page No. 3
15 Do not dry unwashed items in the tumble dryer. 16 Fabric softeners, or similar products, should be used as specified by the fabric softener instructions. 17 To prevent fire, do not use heat to dry items containing plastic, foam rubber or similarly textured rubber-like materials, or items containing feathers or down. Items such as foam rubber (latex foam), shower caps, waterproof textiles, rubber backed articles and clothes or pillows fitted with foam rubber pads should no
Summary of the content on the page No. 4
Start Program selector Control panel Start button Adjustable outlet Door grill and lint filter Back plate Power supply cord Air intake grill Model number and Serial number Read all instructions before using this dryer. This dryer has been designed for domestic use only. SAVE THESE INSTRUCTIONS. This diagram may be slightly different from the layout of the dryer you have just purchased due to technical imprivements. 3
Summary of the content on the page No. 5
Attention: 1.Before operation, clean off any dust and dirt inside the drum of the dryer with a damp towel 2.Clean off any debris on the lint filter and in the duct to increase the drying efficiency. Turning on power Before turning on the power of the dryer check f whether the supply voltage is in accordance with the value indicated on the name plate. Preparation of laundry load - The dryer can only dry laundry which has been spun dry. Do not put in laundry which is still dripping wet
Summary of the content on the page No. 6
OPERATING INSTRUCTIONS 1. Power up Insert the power plug into an appropriate power outlet that is properly installed and grounded. Operating power supply: 220-240V~50Hz. 2. Laundry loading Open the door and load the laundry into the drum of the dryer. For a more energy efficient and better drying result, make sure the load has been spun dried. Try to loosen the load when placing in the dryer. Note: Check labels on clothing before placing them in the dryer. Some articles are n
Summary of the content on the page No. 7
Start Please do not turn the timer knob to this gray area of the program cycle. Dryer timer: The timer will let you set the timer for up to 200 minutes to dry your clothes depending on the load of the clothes. This dryer has two program types. The light blue colour is the cool air cycle and the dark blue is the warm air cycle. During the cool air cycle the heater does not come on and the clothes are dried by cool air. During the warm air cycle the heater activates and
Summary of the content on the page No. 8
WARNING! Unplug the power cord prior to any cleaning Cleaning the surface Wipe off any dust or dirt. Note: Do not use excessive water ,a damp cloth is fine. Do not use solvent. Do not use spray cleaners when cleaning the interior. Do not use harsh or abrasive cleaners. Cleaning the filter screen To ensure good ventilation effect during drying, the filter screen must be cleaned before or after each use. 1. Remove the filter Gently push together the clip on the fil
Summary of the content on the page No. 9
UNPACKING YOUR DRYER Dimensions a=825 mm b=595 mm c=560 mm Weight=30 kg Remove the transport packaging (fig.1) and remove the dryer rack from the top packaging (fig.2). Remove the tape on the front (fig.3 and fig.4), the wall mounting kit attached to the drum with tape on the inside and the panel film, before starting the dryer. fig.1 fig.2 fig.3 fig.4 Packing accessories Check list of the accessories and materials provided with the machine: Name Owner’s manual Wall mounting kit
Summary of the content on the page No. 10
WALL MOUNTING INSTRUCTIONS The dryer can be mounted on the wall in the inverted position only by following these instructions. Invert the dryer so that the control panel is at the bottom (see figure 3) this allows easier access to the controls. 1. Determine the location of the dryer on the wall and mark the bracket position. A minimum 50 mm is needed between the top of the dryer and the celling for ease of installation; If mounting above a washing machine, allow sufficient room
Summary of the content on the page No. 11
WALL MOUNTING INSTRUCTIONS 3. Install the hooks to the dryer, in the inverted position, remove the 2 screws and 2 plastic plugs as indicated in Fig.1 . plastic plugs 4. Align the hooks as shown in Fig.2 and refit screws tightly. Install the spacers provided as Fig.2. 2 hooks 3 screws 2 spacers 10
Summary of the content on the page No. 12
WALL MOUNTING INSTRUCTIONS 5. With assistance, mount dryer on wall brackets. See Fig. 3 6. A second control panel with inverted symbols is supplied. Peel the release paper from the back of inverted film then place new control panel film on the surface so that the writing is the correct way around. Caution : Plug must be accessble after installation. 11 start
Summary of the content on the page No. 13
RACK FITTING INSTRUCTION DRYER FREE STANDING-UPRIGHT For ease of access, the rack is to be mounted near the dryer top. Firstly,hold the rack horizontally with the two end projections pointing upwards and away from yourself. Position the rack near the top of the dryer and place the end of the right rack projection into the right cabinet mounting hole (Fig.1). Then gently pull on the left rack projection until it fits around the cabinet and springs into the left cabinet mounting hole. The rack
Summary of the content on the page No. 14
RACK FITTING INSTRUCTION RACK STORAGE - DRYER INVERTED. To hold the dryer rack out of the way when not in use, it will be necessary to attach the retaining clip to the base of your dryer. To do this, firstly remove the screw located 4 cm from the right corner of the inverted dryer ( Fig.3). Then position the retaining clip over the hole so that the prong on the clip is near the cabinet corner and faces outwards (Fig.4). LOADING DRYER RACK To make use of the drying rack, firstly rotate the outl
Summary of the content on the page No. 15
The following must be confirmed before calling for service: Problem Possible Cause Is the dryer plugged in? Is the power on? Is the door closed properly? The dryer does not start Has a drying program been set? Has the Start button been pressed? Was the correct drying program set? Is the filter screen clean? The drying result is not Did the amount of the loaded laundry exceed good the rated load? Was the loaded laundry spun dry before being loaded into the dryer ？ Did
Summary of the content on the page No. 16
TYPE HDY60M ITEM 220-240)V~/50Hz Power supply 10 Maximum operating current (A) 6 Rated load (kg) Maximum power (W) 2100 825 x 560 x 595 Dimensions (HxDxW) mm 30 Weight (kg) IPX 4 Waterproof degree 15
