Summary of the content on the page No. 1
XD5210
INSTALLATION/OWNERS MANUAL
AM/FM/CD Receiver
Summary of the content on the page No. 2
XD5210 INSTALLATION Preparation Please read entire manual before installation. Before You Start • Disconnect negative battery terminal. (consult a qualified technician for instructions) •Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration. Getting Started • Remove 2 transit screws located on top of the unit. • Remove trim ring by pulling up gently in the center. • Insert the sup
Summary of the content on the page No. 3
XD5210 INSTALLATION Installation TYPICAL MOUNTING METHOD 3
Summary of the content on the page No. 4
XD5210 INSTALLATION Wiring Diagram Antenna Connector RCA Cable (sold separately) GRAY Rear Preamp Output Connect to amplifier RCA Input BLUE Remote Turn-On Connect to amplifier or power antenna. Insulate wire if not used. BLACK Ground Connect to vehicle chassis ground. .5 AMP AGC Fuse RED Accessory Connect to existing ignition 5 AMP circuit or switched 12 volt source. AGC Fuse FUSES When replacing fuses, YELLOW Memory Connect to battery make sure new fuse is the circuit or constant 12 volt sourc
Summary of the content on the page No. 5
XD5210 OPERATION Control Locations 1 2 3 4 5 6 18 17 16 15 14 13 12 11 10 9 8 7 1 10 Release Preset 6 2 Volume 11 Preset 5 3 Tune/Track Up 12 Preset 4/CD Random 4 Band 13 Preset 3/CD Repeat 5 14 Bass Boost Preset2/CD Intro 6 15 Eject Preset 1/CD Top 7 Display Audio 16 8 Play/Pause Power 17 Auto Store/Preset Scan Tune/Track Down 9 18 5
Summary of the content on the page No. 6
XD5210 OPERATION General Operation Faceplate Removal Press REL and pull away from the left side to remove. To re-install, insert right side of faceplate first then push left side to secure. *For semi-permanent faceplate installation, remove trim ring and install supplied Phillips head #1 screw through left side of mounting frame into faceplate. Power On/Off Press PWR to turn the unit on. Inserting a CD will turn the unit on automatically. Press PWR to turn the unit off. CD Mode Insert a CD or pr
Summary of the content on the page No. 7
XD5210 OPERATION General Operation Reset Press and hold for more than 2 seconds to RESET the unit upon initial installation or if abnormal operation occurs. The RESET button is located behind the faceplate. Audio Press AUD to select between Volume (default), Bass, Treble, Balance & Fader. Bass Press AUD until BA appears Press VOLUME ▼ or ▲ to adjust (6 maximum / -6 minimum) Treble Press AUD until TR appears Press VOLUME ▼ or ▲ to adjust (6 maximum / -6 minimum) Balance Press AUD until B appears
Summary of the content on the page No. 8
XD5210 OPERATION Tuner Operation Seek Tuning Press TUNE << or >> momentarily to seek the next strong station. Manual Tuning Press TUNE << or >> for more than 2 seconds, then press TUNE << or >> momentarily to move radio frequency up or down one step at a time. Press and hold to advance quickly. If tuning is not adjusted for 2 seconds, the unit will return to seek tuning mode (default). Band Press BAND to select between FM1, FM2, FM3 and AM1, AM2 bands. Storing and Up to 18 FM stations and 12 AM
Summary of the content on the page No. 9
XD5210 OPERATION CD Player Operation With the label facing up, insert a standard 5" CD into Insert CD the CD slot. The CD will automatically begin playback. Press the EJECT button to stop and eject the CD. The Eject CD unit will change to tuner mode. Press TRACK >> to skip to the beginning of the next Track Select track. Press TRACK << to return to the beginning of the current track. Pressing TRACK << again skips to the beginning of the previous track. Press and hold TRACK << or TRACK >> to f
Summary of the content on the page No. 10
XD5210 WARRANTY Limited One-Year Warranty This warranty gives you specific legal rights. You What to do? may also have other rights which vary from state to 1. Before you call for service, check your operating state. instruction booklet. A slight adjustment of any custom controls discussed in your instruction Namsung America Inc. warrants this product to the booklet may save you a service call. original purchaser to be free from defects in material and workmanship, under normal 2. If you require
Summary of the content on the page No. 11
XD5210 OPERATION Troubleshooting Problem Cause Action Unit will not Yellow or red wire not connected or Check connections for proper turn on incorrect voltage voltage (11~16VDC) (no power) Black wire not connected Check connection to ground Fuse blown Replace fuse Speaker wires not connected Check connections at speakers Unit has power (but no sound) One or more speaker wires touching Insulate all bare speaker wires each other or touching chassis from each other and chassis ground ground Yello
Summary of the content on the page No. 12
XD5210 WARRANTY Specifications CD Player Signal-to-noise: >86dB Frequency response: 20Hz-20kHz Channel separation @ 1kHz: >65dB D/A converter: 16 Bit FM Tuner Tuning range: 87.5MHz-107.9MHz Usable sensitivity: 12dBf 50dB quieting sensitivity: 16dBf Stereo separation @ 1kHz: 40dB Frequency response: 30Hz-13kHz AM Tuner Tuning range: 530kHz-1710kHz Usable sensitivity: 30uV Frequency response: 80Hz-2kHz General Total power output: 120 Watts Peak Power output: 30Wx4 @ 4 ohm, 14.4 VDC Operating volt
Summary of the content on the page No. 13
DCS65 INSTALLATION/OWNERS MANUAL Multi-fit 6.5" 2-way Car Audio Speakers
Summary of the content on the page No. 14
DCS65 INSTALLATION Preparation/Installation Please read entire manual before installation. Before You Start • Disconnect negative battery terminal. (consult a qualified technician for instructions) Getting Started • Be sure to carefully read and understand the instructions before attempting to install the product. •For easier assembly, we recommend that if additional wiring is required, that you run all wires prior to mounting your speaker in place. • Use the highest quality connectors for a r
Summary of the content on the page No. 15
DCS65 WARRANTY Limited One-Year Warranty This warranty gives you specific legal rights. You may What to do? 1. Before you call for service, check your also have other rights which vary from state to state. operating instruction booklet. A slight adjustment of any custom controls discussed in your instruction Namsung America Inc. warrants this product to the booklet may save you a service call. original purchaser to be free from defects in material 2. If you require service during the warranty pe
Summary of the content on the page No. 16
DCS65 SPECIFICATIONS Specifications 6.75" Outside Diameter 1.7" Mounting Depth .3" Mounting Height 4.9" Cut-out Diameter 88Hz-15kHz, ±3dB Frequency Response 89dB 1W/1M Sensitivity 4 ohms Impedance 25 Watts RMS Power 65 Watts Peak Power Design and specifications subject to change without notice Namsung America Inc. 21318 64th Ave. South Kent, WA 98032 Toll Free: 1-866-626-7863 www.dualav.com ©2004 Namsung America, Inc. EVOK0604-V01
