Fisher-Price GEOTRAX R2771 user manual

Summary of the content on the page No. 1

R2771 R2771
www.fisher-price.com
Please keep this instruction sheet for future reference, as it contains important information.
Requires three button cell batteries (included) for operation.
Adult assembly is required.
Tool required for assembly: Phillips screwdriver (not included).
1

Summary of the content on the page No. 2

Assembled Parts 2 Upper Ramps 2 Lower Ramps Mountain Track Trestle 2 Small Ramps Mountain #4 x ½” Screw - 4 Shown Actual Size Tighten and loosen all screws with a Phillips screwdriver. Do not over-tighten. ©Disney/Pixar Disney/Pixar elements ©Disney/Pixar, not including underlying vehicles owned by third parties: Hudson Hornet™, Chevrolet Impala™, ® Porsche™, Mercury™, and Jeep . Sarge’s rank insignia design used with the approval of the U.S. Army Fisher-Price, Inc., a subsidiary of Mattel, Inc

Summary of the content on the page No. 3

Battery Replacement • Protect the environment by not disposing of this product with household waste (2002/96/EC). Check your local authority for 1.5V x 3 recycling advice and facilities LR44 or equivalent (Europe only). • Loosen the screws in the bottom of the vehicle. Remove the top of the vehicle off of the chassis to access the battery compartment. • Remove the exhausted batteries and throw them away. • Insert three, new button cell (LR44) alkaline batteries. Hint: We recommend u

Summary of the content on the page No. 4

Consumer Information FCC Statement (United States Only) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio co

Summary of the content on the page No. 5

Assembly and Setup Mountain Upper Ramp Lower Ramp Mountain Track Trestle 1 2 3 • Fit the mountain onto the bridge track. Push to “snap” • At an angle, fi t the tab on a trestle into the slot on the • Fit the tabs on the upper ramp into the slots in the in place. mountain. Push to “snap” in place. lower ramp. • Repeat this procedure to assemble the other trestle to • Insert two screws into the upper ramp. Tighten the screws the mountain. with a Phillips screwdriver. Do not over-tighten. • Repeat