Clifford Sabre user manual

Summary of the content on the page No. 1

TM
World-Class Auto Security
Sabre
Owner's Manual

Summary of the content on the page No. 2

Using Your Sabre Security System 2-Button/3-Channel Remote Control The 2-button/3-channel remote control is a miniature radio transmitter with a range of up to 100 feet. Obstructions, interference or a weak battery will reduce the range. Your 2-button/3-channel remote control is the key to your security system. It is an ingenious user-friendly device that transmits three distinct and unique digital codes. Use it to arm or disarm the system, lock or unlock the doors, activate its panic feature or

Summary of the content on the page No. 3

AutoArming™ If you forget to remotely arm, the system will arm itself automatically (“passively”) 30 seconds after the vehicle doors are closed. If you re-open any door(s) within the 30-second countdown, AutoArming will restart from the beginning once all doors are closed. This ensures you’ll never accidentally leave your vehicle unprotected. AutoArming Enable/Disable: If you prefer, you may deactivate or reactivate AutoArming. To do, see User-Selectable Features on pages 5-6. AutoArm & Lock: To

Summary of the content on the page No. 4

Tampering Warning Normally, the system immediately sounds its siren at the first inkling of an intru- sion attempt. However, you may set the system to issue a rapid five-chirp warning whenever the system detects tampering to the exterior of your vehicle. If there is any further tampering within the next 30 seconds, or if a door, the hood or trunk is opened at any time, your system will sound a continuous 125dB siren blast. To select the mode of your choice, see User-Selectable Features on pages

Summary of the content on the page No. 5

TotalRecall™ The system’s non-volatile memory records the identity of the last activated or malfunctioning trigger or sensor, which allows your installer to instantly track down a malfunction and save you servicing costs. To identify the trigger or sensor held in the system’s non-volatile memory, simply perform the following procedure: 1. With the ignition OFF, flick the valet switch to one side. 2. Press button I to “arm” the system, then again to “disarm.” 3. The LED will blink several times,

Summary of the content on the page No. 6

User-Selectable Features Your Sabre vehicle security system allows you to set many of its features to your own personal preferences. We have made the programming procedures very simple: to make a change, you just flick the valet switch a few times. The system comes from the factory with all of its features pre-programmed as noted in the table below and on page 6. To change any of the settings, use the procedure noted. To restore the feature to its factory setting, just repeat the procedure: 1. S

Summary of the content on the page No. 7

# of Program Factory Secondary flicks & completion Feature setting action Result chirps confirmation Add a New Remote to Button II/channel 2 code of Channel 2 Press remote control button II 10 — 3 chirps new remote control (optional re- has been memorized mote accessory) Add a New Remote to Press remote control buttons I+II Button I+II/channel 3 code Channel 3 (si- 9 — (or button III of the optional 2 chirps of new remote control lent arm/dis- 4-channel remote control) has been memorized arm)