Summary of the content on the page No. 1
M Mo od de ell R RS SX X1 1..2 2
O Ow wn ne er r’’s s G Gu uiid de e
➤
Summary of the content on the page No. 2
lliim miitte ed d lliiffe ettiim me e c co on ns su um me er r w wa ar rr ra an ntty y Directed Electronics ("Directed") promises to the original purchaser to repair or replace with a comparable reconditioned model any Directed unit (hereafter the "unit"), exclud- ing without limitation the siren, the remote transmitters, the associated sensors and acces- sories, which proves to be defective in workmanship or material under reasonable use dur- ing the lifetime of the vehicle provided the foll
Summary of the content on the page No. 3
CONSEQUENTIAL DAMAGES OF ANY KIND. IN THE EVENT OF A CLAIM OR A DISPUTE INVOLVING DIRECTED OR ITS SUBSIDIARY, THE PROPER VENUE SHALL BE SAN DIEGO COUNTY IN THE STATE OF CALIFORNIA. CALIFORNIA STATE LAWS AND APPLICABLE FEDERAL LAWS SHALL APPLY AND GOVERN THE DISPUTE. THE MAXIMUM RECOVERY UNDER ANY CLAIM AGAINST DIRECTED SHALL BE STRICTLY LIMITED TO THE AUTHORIZED DIRECTED DEALER'S PURCHASE PRICE OF THE UNIT. DIRECTED SHALL NOT BE RESPONSIBLE FOR ANY DAMAGES WHATSOEV- ER, INCLUDING BUT NOT LIMITED
Summary of the content on the page No. 4
tta ab blle e o off c co on ntte en ntts s lli im mi it te ed d lli if fe et ti im me e c co on ns su um me er r w wa ar rr ra an nt ty y .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. i i w wh ha at t i is s i in nc cllu ud de ed d.. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. ..
Summary of the content on the page No. 5
© 2005 directed electronics—all rights reserved 2
Summary of the content on the page No. 6
w wh ha att iis s iin nc cllu ud de ed d ➤ A control module ➤ An XHF2 receiver/antenna ➤ One 4-button 2-way remote ➤ One 4-button remote ➤ A in-vehicle status LED indicator light ➤ A push-button Valet switch ➤ Your warranty registration ➤ A shut-down toggle switch iim mp po or rtta an ntt iin nffo or rm ma attiio on n Congratulations on the purchase of your 2-way remote start keyless entry system. Due to the complexity of this system, it must be installed by an authorized dealer only. Install
Summary of the content on the page No. 7
your warranty ➜ Your warranty registration must be completely filled out and returned within 10 days of purchase. Your product warranty will not be validated if your warranty registration is not returned. Make sure you receive the warranty registration from your dealer. It is also necessary to keep your proof of purchase, which reflects that the product was installed by an authorized dealer. fcc/id notice ➜ This device complies with Part 15 of FCC rules. Operation is subject to the following co
Summary of the content on the page No. 8
2 2- -w wa ay y r re em mo otte e d diia ag gr ra am m 2 3 4 1 5 6 8 7 s stta an nd da ar rd d r re em mo otte e c co on nffiig gu ur ra attiio on n 1. Unlock/Lock Indicator (Orange) 2. Receive/Transmit Indicator (Green) 3. Remote Start/Auxiliary Indicator (Yellow) 4. Panic Indicator (Red) 5. Lock Button 6. Unlock Button 7. Remote Start Button 8. Auxiliary Channel Button © 2005 directed electronics—all rights reserved 5
Summary of the content on the page No. 9
s sy ys stte em m m ma aiin ntte en na an nc ce e This system needs no specific maintenance beyond remote control battery replacement. The remote is powered by a 1.5V AAA battery. Low Battery Notification If the battery is low (and this feature is programmed On) the 2- way remote will emit 2 long beeps 5-seconds after a transmission is completed. The 2 long beeps will repeat every 25 seconds up to 3 times (or until a 2-way remote button is pressed). Battery Replacement Gently pull the end of th
Summary of the content on the page No. 10
standard configuration ➜ Button Controls the system Lock function by briefly pressing this button. Button Controls the system Unlock function by briefly pressing this button. Button Controls an optional auxiliary function, such as trunk release, can be controlled by pressing this button for 1.5 seconds.) The auxiliary output controls __________________________. Button The remote start feature is turned On/Off by pressing this button twice. and Buttons The remote start timer mode function of the
Summary of the content on the page No. 11
Button Press and hold this button for 3-seconds to enter Panic Mode. and and Buttons When simultaneously pressed these buttons control the rear window defogger during remote starting. r re em mo otte e o op pe er ra attiio on n The remote start system operates at 434 MHz and incorporates Directed’s proprietary XHF2 out-board technology transceiver. The high frequency combined with Binary Data communication achieves superior range with two-way communication. system signal paging features ➜ A p
Summary of the content on the page No. 12
If the ignition is turned on while locked, the system will actuate the panic feature and an Alarm Page will be sent to the remote control. When the remote receives this Alarm Page, the remote control will generate 4 beeps 5 times and the Red LED will illu- minate for 3-seconds. This will repeat every 100 seconds to alert the user that the security feature was triggered and will continue until the alarm page is cleared. Page Recognition To clear a page alert/notification, quickly press any button
Summary of the content on the page No. 13
p pr ro og gr ra am mm miin ng g r re em mo otte e To enter programming mode Press and hold all four remote control buttons simultaneously until one long beep is heard. Programming mode is now entered. Beeps On/Off Press to select beeps On/Off. One beep is notification beeps On, Two beeps is notification beeps Off. The notification beeps are programmed On from the factory and can be programmed Off if they are not desired. When programmed Off the remote will only flash the LEDs as notification o
Summary of the content on the page No. 14
To exit programming mode The remote control will exit programming mode after 2-seconds of inactivity and will emit 2 long beeps. u us siin ng g y yo ou ur r s sy ys stte em m warning! safety first ➜ The following safety warnings must be observed at all times: ➤ Due to the complexity of this system, installation of this product must only be performed by an authorized Directed dealer. ➤ When properly installed, this system can start the vehicle via a command signal from the 2-way remote contro
Summary of the content on the page No. 15
ALL TIMES REMAIN CLOSED. These precautions are the sole responsibility of the user. ➤ Use of this product in a manner contrary to its intended mode of operation may result in property damage, personal injury, or death. (1) Never remotely start the vehicle with the vehicle in gear, and (2) Never remotely start the vehicle with the keys in the ignition. The user must also have the neutral safety feature of the vehicle periodically checked, wherein the vehicle must not remotely start while the car
Summary of the content on the page No. 16
REMOTE START SYSTEM UNDER THESE CONDI- TIONS MAY RESULT IN PROPERTY DAMAGE OR PERSONAL INJURY. YOU MUST IMMEDIATELY CEASE THE USE OF THE UNIT AND SEEK THE ASSISTANCE OF AN AUTHORIZED Directed DEALER TO REPAIR OR DISCONNECT THE INSTALLED REMOTE START MODULE. DIRECTED WILL NOT BE HELD RESPONSIBLE OR PAY FOR INSTALLA- TION OR REINSTALLATION COSTS. locking ➜ Pressing for one second arms the system by activating the starter kill and locking the doors (if the door locks are connected). The horn will h
Summary of the content on the page No. 17
If Passive Mode has been programmed on, then it is also possible to program the system for Passive Locking. With Passive Locking, the vehicle doors lock automatically at the same time that the ® Failsafe Starter Kill is activated. If Passive Locking is programmed on, care must be taken to prevent the keys from being locked in the vehicle. n no ot te e:: For Passive Mode to be effective, the Failsafe® Starter Kill relay must be installed. The remote responds to active arming with one beep and the
Summary of the content on the page No. 18
The remote will indicate unlock notification with 2 beeps and 3 flashes of the Orange LED. disabling the starter kill without a 2-way remote ➜ If your 2-way remote is lost or damaged, you can manually over- ride the starter kill. To do this, you must have the vehicle's igni- tion key and know where the Valet button is located. Be sure to check with your installer at the time of installation for the loca- tion of the Valet button. To override the starter kill, turn the ignition to the On position
Summary of the content on the page No. 19
panic mode ➜ If you are threatened in or near your vehicle, you can attract attention by triggering the system with your 2-way remote. Just press for 3-seconds, and you will enter Panic Mode. The horn will honk (if connected) and the parking lights (if connected) will flash for the programmed duration. To stop Panic Mode at any time, press or on the 2-way remote. The remote responds with one flash of the Red LED upon entering Panic Mode and two flashes of the Red LED upon exiting Panic Mode. n n
Summary of the content on the page No. 20
The in-vehicle status LED will light steadily if you are entering Valet Mode, and it turn off if you are exiting Valet Mode. The remote will respond with 3 Orange LED flashes on entering and 2 beeps and 3 Orange LED flashes on exiting Valet Mode. remote start ➜ This feature allows you to remotely start and run your vehicle for a programmable period of time. This makes it possible to warm up the engine, as well as adjust the interior temperature of the ve- hicle with the climate control system. I
