Summary of the content on the page No. 1
Summary of the content on the page No. 2
Summary of the content on the page No. 3
Limited Consumer Warranty For a period of one calendar year from the date of purchase of this device, Directed Electronics, Inc. promises to the ORIGINAL PURCHASER to repair or replace (with a comparable reconditioned model), free of cost, any electronic con- trol module which proves to be defective in workmanship or material under nor- mal use, SO LONG AS THE SYSTEM WAS SOLD, INSTALLED, AND SERVICED BY A PROFESSIONAL AUTO INSTALLER, AND REMAINS IN THE CAR IN WHICH THE SYS- TEM WAS ORIGINALLY IN
Summary of the content on the page No. 4
TO THE MAXIMUM EXTENT ALLOWED BY LAW, ANY AND ALL WARRANTIES ARE EXCLUDED BY THE MANUFACTURER AND EACH ENTITY PARTICIPATING IN THE STREAM OF COMMERCE THEREWITH. THIS EXCLUSION INCLUDES BUT IS NOT LIMITED TO THE EXCLUSION OF ANY AND ALL WARRANTY OF MERCHANTABIL- ITY AND/OR ANY AND ALL WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE AND/OR ANY AND ALL WARRANTY OF NON-INFRINGEMENT OF PATENTS, IN THE UNITED STATES OF AMERICA AND/OR ABROAD. NEITHER THE MANUFACTURER OR ANY ENTITIES CONNECTED THEREWITH SH
Summary of the content on the page No. 5
contents limited lifetime consumer warran- nuisance prevention circuitry® . .7 ty . . . . . . . . . . . . . . . . . . . . . . . . . .i diagnostics . . . . . . . . . . . . . . . . . .9 arming diagnostics . . . . . . . . .9 trademarks and copyrights . . . . .1 disarming diagnostics . . . . . . .9 what is included . . . . . . . . . . . . .2 table of zones . . . . . . . . . . . .10 important information . . . . . . . .2 rapid resume logic . . . . . . . . . . .10 using your system . . . . . . . . .
Summary of the content on the page No. 6
what is included Control module and harness ® Pre-wired Valet switch with integrated red status LED ® Failsafe Starter Kill relay (if equipped) important information Congratulations on the purchase of your system. Due to the complex- ity of this system, it must be installed by an authorized dealer only. Installation of this product by anyone other than an authorized dealer voids the warranty. All dealers are provided with a preprinted dealer certificate to verify that they are authorized. By
Summary of the content on the page No. 7
using your system manual (active) arming The factory default is active arming. In this mode you can activate, or arm, the system by locking the doors with your factory keyless entry transmitter. When the system arms, you will hear a short horn honk and see the parking lights (optional) flash once. While the system is armed, the status LED will flash about twice a second, showing that the system is actively protecting your vehicle. If you hear a second short horn honk after arming, and see the st
Summary of the content on the page No. 8
n no otte e:: If any protected doors are left open, the system will not passively arm. Additionally, each time door is triggered during the arming countdown, the 30-second countdown starts over. armed protection When armed, your vehicle is protected as follows: (This feature is optional and requires extra labour) If a door is opened, the system will immediately start pulsing the horn and flashing the parking lights (optional). Three seconds later, the horn output changes to a continuous blast
Summary of the content on the page No. 9
disarming To disarm the system, unlock the doors using your factory keyless trans- mitter. The horn will sound twice, and the parking lights (optional) will flash twice. If the horn sounds either four or five times when disarm- ing, refer to the Diagnostics section of this guide. This is called Tamper Alert. disarming without a transmitter This feature allows you to override the system without the transmitter should it be lost, damaged or disabled. To do this, you must have the ve- ® hicle's ign
Summary of the content on the page No. 10
® valet mode ® You can prevent your system from arming, by using Valet Mode. This ® is very useful when washing the vehicle or having it serviced. In Valet Mode, the system will not arm, even with the transmitter, but all con- venience functions (door locks, trunk release, etc.) will work normally. ® ® To enter or exit Valet Mode with the integrated LED/Valet switch: Turn ignition to “on” position, then turn to “off” position. Press and release the integrated ® LED/Valet switch within 10 DRW-35
Summary of the content on the page No. 11
® n no otte e:: The remote Valet feature will not work with all factory keyless entry systems. Some keyless entry systems do not work with a door open. panic mode (This feature is optional and requires extra labour and parts) If you are threatened in or near your vehicle, you can attract attention by trig- gering the system with your transmitter! If your factory keyless trans- mitter does not have a panic button, this system can be programmed to enable a panic feature. If enabled, just press the
Summary of the content on the page No. 12
diagnostics The microprocessor at the heart of your system is constantly monitoring all of the switches and sensors connected to it. It detects any faulty switches and sensors and prevents them from disabling the entire sys- tem. The microprocessor will also record and report any triggers that occurred during your absence. arming diagnostics If the system is armed with an input active (door open or ignition) the unit will chirp once when arming and then one more time a few seconds later. This is
Summary of the content on the page No. 13
table of zones The zone number is the number of LED flashes used by the system to identify that input. The standard input assignments are listed below. ZONE (Number LED Flashes) DESCRIPTION 1 Not available - 22CX only 2 Not available - 22CX only 3 Door switch trigger 4 Not available - 22CX only 5 Ignition trigger rapid resume logic This system will store its current state to non-volatile memory. If power is lost and then reconnected the system will recall the stored state from ® memory. This
Summary of the content on the page No. 14
glossary of terms Control Module : The “brain” of your system. Usually hidden under- neath the dash area of the vehicle. It houses the microprocessor which monitors your vehicle and controls all of the alarm’s functions. ® Failsafe Starter Kill : An automatic switch controlled by the system which prevents the vehicle’s starter from cranking whenever the system is armed. The vehicle is never prevented from cranking when the sys- ® tem is disarmed, in Valet Mode, or should the starter kill switch
Summary of the content on the page No. 15
notes © 2004 directed electronics, inc. 11
Summary of the content on the page No. 16
© 2004 directed electronics, inc. 12
Summary of the content on the page No. 17
✂ ✂ QUICK REFERENCE GUIDE: To arm the system ■ You can arm the system by locking the doors with your factory keyless entry transmitter. When the system arms, your will hear a short horn honk, and see the parking lights flash (optional) once. To disarm the system ■ To disarm the system, unlock the doors using your factory keyless trans- mitter. You will hear two horn honks, and the parking lights (optional) will flash twice. Disarming without a transmitter ■ Turn on the ignition. Press the integr
Summary of the content on the page No. 18
The company behind this system is Directed Electronics, Inc. Since its inception, Directed Electronics has had one purpose, to provide consumers with the finest vehicle security and car stereo products and accessories available. The recipient of nearly 100 patents and Innovations Awards in the field of advanced electronic technology, DIRECTED is ISO 9001 registered. Quality Directed Electronics products are sold and serviced throughout North America and around the world. Call ( (8 80 00 0) ) 3
