Summary of the content on the page No. 1
1
2
Tornado /AMX58 Owner's Manual 12/29/9 7
Summary of the content on the page No. 2
Standard Features Life time War ranty — We guarantee the operation of the control unit þ and remote controls for as long as you own your car (see the enclosed warranty card for details). A Pair of 2-Bu tton/3-Cha nnel Re mote Con trols — These remotes þ allow you to command your system from up to 100 feet away. Us er -Friendly Pro gram ming — All programmable features are þ accomplished with a few flicks of the valet switch. þ Starter Dis able Capability — For the ultimate in security, the syste
Summary of the content on the page No. 3
þ Multi- Zone Pro tec tion — Offers full perimeter security with separate trigger connections for the doors, hood and trunk (may require optional switches). þ Pre vi ous In tru sion Alert — Audibly warns you if the alarm was triggered while you were away. Spe cific In tru sion Iden ti fi ca tion — The flashing LED identifies þ which zone was triggered in your absence. Auto matic Mal func tion Over ride — Automatically bypasses a þ malfunctioning trigger or sensor, then monitors all other points
Summary of the content on the page No. 4
þ Chan nel 2 Ac ces sory Out put — Allows you to add a remote controlled optional accessory such as a remote engine starter, window roll-up, trunk release or fuel filler door release. þ Alarm State Mem ory — Automatically returns your system to its last state if the battery is disconnected and later reconnected. 1 Zone Im pact Sen sor (optional) — Provides precision detection of þ intrusion-related vibrations and impacts. 3 2 Tornado /AMX58 Owner's Manual 12/29/97
Summary of the content on the page No. 5
Operating Instructions n Remote Control — Each of the pair of remote controls is a miniature radio transmitter with a typical range of up to 100 feet. Obstructions, radio interference, cellular transmissions or a weak remote control battery may reduce the range or interrupt transmission. (If the system does not immediately respond, release and press the button again. This works better than holding the button down.) The second remote can be used by a second driver, or kept as a spare. (Note: AviG
Summary of the content on the page No. 6
n Si lent Arm In di ca tions. The parking lights will flash twice, the doors will lock, the starter will be disabled* and the LED will flash slowly. n Si lent Dis arm In di ca tions. The parking lights will flash once, the doors will unlock, the starter will be enabled* and the LED will turn off. n Interior Light Illumination Capability — When the alarm system is remotely disarmed, the vehicle's interior light(s) will turn on for 30 seconds or until the ignition key is turned on (requires an opt
Summary of the content on the page No. 7
n User Programmable Passive Door Locking — The system will not automatically lock the doors when the alarm passively arms to prevent the keys and remote from accidentally being locked in the vehicle. If you prefer, you can easily program the alarm to automatically lock the doors every time the alarm passively arms. See the “Programming Table for Alarm Features” on page 8. n To Activate Remote Panic — Press and hold button #1 for 3-4 seconds. The siren will sound continually and the parking li
Summary of the content on the page No. 8
n Automatic Malfunction Override — In the event of a faulty sensor or alarm input trigger zone, the alarm, when remotely armed, will alert you by a series of chirps and light flashes. n Instant Remote Control Code Deletion — In the event of a lost or stolen remote control, all remote controls can be erased from memory to prevent unauthorized alarm operation. See the "Programming Table for Remote Controls" on page 9. n Remote Control Code Learning — The alarm can be programmed to accept as many
Summary of the content on the page No. 9
Programming Alarm System Features All programmable alarm features are accomplished by turning the ignition key on (or starting the vehicle) and flicking the valet switch on and off a preset number of times. 1. Remove the alarm from Valet Mode. Programming cannot be accessed while the alarm is in Valet Mode, indicated by the LED on solid red. 2. Select the feature you wish to program from the "Programming Table for Alarm Features." Note the number of chirps. 3. Turn the ignition key to the "ON"
Summary of the content on the page No. 10
Programming Your Remote Control s 2 The Tornado allows the user to add new remote controls in one step, delete lost or stolen remote controls or rearrange the factory preset remote control configuration. All remote control programming features are accomplished by turning the ignition key on (or starting the vehicle) and flicking the valet switch on and off a preset number of times. 1. Remove the alarm from Valet Mode. Programming cannot be accessed while the alarm is in Valet Mode, indicated by
Summary of the content on the page No. 11
© Copyright 1998 Avital Technologies, Inc. 31-3273/98 2 Tornad o /AMX58 Owner's Manual 12/29/97
