Audiovox Prestige 128-8615 user manual

Summary of the content on the page No. 1

Model APS-101N
Installation Manual
Programmable Features
Select By Operating Transmitter Press Lock Button Press Unlock Button
Siren Indications 1 Chirp 2 Chirps Factory Default
1) Arming Method Passive Arm Active Arm Passive Arm
2) Ignition Control Lock/Unlock Off On Off
3) Passive Or Active Door Locks Active Passive Active
4) Single Or Double Pulse U/L Single Pulse Double Pulse Single
5) Door Lock/Unlock Pulse Duration 1 Second 3 Seconds 1 Second
6) Siren Ch

Summary of the content on the page No. 2

Once a location has been selected, check behind the panel for wire routing access, and to confirm the drill will not damage any existing components as it passes through the panel. Drill a ¼ “ diameter hole, and pass the red and blue wires from the LED through the hole, from the front of the panel. Firmly press the body of the LED into the hole until fully seated. Valet/Programming Switch: Select a covert location for this switch within reach of the driver of the vehicle. This switch can be moun

Summary of the content on the page No. 3

Dark Blue Wire: DELAYED 200 mA PULSED OUTPUT / CHANNEL 2 The dark blue wire pulses to ground via an independent RF channel from the keychain transmitter. This is a transistorized, low current output, and should only be used to drive an external relay coil. WARNING: Connecting the dark blue wire to the high current switched output of trunk release circuits, and some remote start trigger inputs, will damage the control module. In these cases connect the dark blue wire to terminal 86 of the AS-9256

Summary of the content on the page No. 4

COMPLETING THE INSTALLATION NOTE: This unit has the ability to learn the dome light delay time, up to 60 seconds. If the vehicle has delay interior lights, and you wish to avoid three chirp, defect zone, indication normally associated with this type of interior light, we suggest you learn the interior light delay. To learn the light delay, start with all doors closed: (1) Use the transmitter to Lock / Unlock / Lock / Unlock / Lock / Unlock / Lock, the system. The LED turns on solid to confirm th

Summary of the content on the page No. 5

THIS PAGE LEFT BLANK INTENTIONALLY Page 5 128-8615 5 of 8

Summary of the content on the page No. 6

Page 6 128-8615 6 of 8

Summary of the content on the page No. 7

THIS PAGE LEFT BLANK INTENTIONALLY Page 7 128-8615 7 of 8

Summary of the content on the page No. 8

© 2009 Audiovox Electronics Corporation, 150 Marcus Blvd., Hauppauge, NY 11788 128-8615 Page 8 128-8615 8 of 8