Audiovox APS-15KB user manual

Summary of the content on the page No. 1

Model APS-15KB
REMOTE CONTROL
AUTO SECURITY SYSTEM
Installation Manual
PRE-INSTALLATION NOTES:
PASSIVE / ACTIVE ARMING SELECTION:
This alarm can be programmed to operate as either a “PASSIVE” or “ACTIVE” arming security system.
As a “Passive” alarm, the system will automatically arm itself approximately 30 seconds after the ignition key is turned
off, one door is opened, then all vehicle doors are closed, (arming is suspended until the last door is closed). This
feature protects the vehicle i

Summary of the content on the page No. 2

In addition, the garage door interface receiver can be directly wired into the vehicle to offer a 3rd remote control option. Since this is a set of relay contacts, the receiver can be used to provide a selectable positive or negative pulse. TRANSMITTER PROGRAMMING: The transmitters included in this kit have been programmed at the factory for channel 1 (arm, disarm, and panic function) only. Any additional functions of the system must be programmed at the time of installation. These functions c

Summary of the content on the page No. 3

and mount the sensor using the two screws provided. The shock sensor can also be secured to any fixed brace behind the dash using tie straps. Whichever mounting method is selected, make certain that the sensitivity adjustment is accessible for use later in the installation. WIRING THE SYSTEM: WHITE WIRE: + 12 VDC PULSED PARKING LIGHT OUTPUT ( 15 A MAX ) This wire is provided to flash the vehicle’s parking lights. Connect the white wire to the positive side of one of the vehicle’s parking lights

Summary of the content on the page No. 4

only need to be connected to one door switch, no matter how many doors the vehicle has. WARNING: Do not use the brown wire if the vehicle has + 12 Volt output type door switches. (see PURPLE WIRE) PURPLE WIRE: + DOOR TRIGGER If the vehicle’s door courtesy light switches have a + 12 volt output when the door is opened ( most Fords and some Imports ), you must connect this wire to the positive output from one of the door switches. In most cases, the purple wire will only need to be connected to on

Summary of the content on the page No. 5

In these applications, the AS 9159 Door Lock Interface ( or equivalent 30A automotive relays ) must be used. Refer to the AUDIOVOX Door Lock Wiring Supplement for proper connection to these types of circuits. COMPLETING THE INSTALLATION: Antenna Wire: Be sure to extend the thin black antenna wire to it’s full length and cable tie into place where it cannot be damaged. Avoid wrapping this wire around major, high current wire looms. Adjusting the Shock Sensor: Using a small screwdriver, gently tur

Summary of the content on the page No. 6

© 2000 Audiovox Corporation, Hauppauge NY 11788 128-5745A