Summary of the content on the page No. 1
Compact disc player CD36
Summary of the content on the page No. 2
Safety guidelines CAUTION ATTENTION RISK OF ELECTRIC RISQUE DE CHOC ELECTRIQUE SHOCK DO NOT OPEN NE PAS OUVRIR CAUTION: To reduce the risk of electric shock, do not remove cover (or back). No user serviceable parts inside. Refer servicing to qualified service personnel. WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. The lightning flash with an arrowhead symbol within an equilateral triangle, is intended to alert the user to the presence
Summary of the content on the page No. 3
Using this handbook This handbook has been designed to give you all the information you need to install, connect, set up and use Contents the Arcam CD36 compact disc player. The CR-314 remote Safety guidelines................................................E-2 control handset supplied with this equipment is also Important safety instructions..........................E-2 described. Safety compliance.........................................E-2 Using this handbook ...............................
Summary of the content on the page No. 4
Installation � � � � � � � Positioning the unit Always place the CD player on a level, fi rm surface. Placing your player on a set of dedicated sorbothane isolation feet will isolate the unit from its surroundings as well as absorbing the vibrations created within the player itself. You will generally hear some sonic improvements, which makes this an extremely cost-effective upgrade. Connecting to other equipment Interconnect cables Interconnecting cables are not supplied with this CD player.
Summary of the content on the page No. 5
Using your CD player CD36 COMPACT DISC PLAYER LOAD PLAY STOP PAUSE POWER � � � � � � � POWER 7 Press this button to switch the CD player on and off. When fi rst --NO DISC-- powered up with no CD installed the display shows ‘No disc’. LOAD 1 To install a CD, press LOAD (or OPEN on the remote control). The TRACK INDEX MIN SEC CD tray opens – it accepts 12cm and 8cm discs. Place the CD in the 1 2 3 4 5 6 7 8 tray with the label facing uppermost. Press LOAD again (or press 8 1 52.19 PLAY, or
Summary of the content on the page No. 6
Using the CR-314 remote control CD/DVD 0–9 keypad Ensure that CD mode is selected using the CD/DVD This allows direct access to individual tracks on the disc. toggle button. The ‘CD’ LED above the CD/DVD To select a track, press the corresponding keypad button. button is lit briefl y when CD mode is selected. For tracks greater than 9, enter the digits in sequence. For example, to play track 15, press and hold 1 until the number on the display moves to the left, then press 5. DISP (display)
Summary of the content on the page No. 7
Remote-control codes The following table gives the IR-commands accepted by the CD36. Items shown in italics reference the buttons on the supplied CR-314 remote control. The items not in italics are additional commands accepted by the CD36. Power commands Command Decimal Code Power toggle 20–12 Power-on 20–123 Power-off 20–124 Playback control commands Command Decimal Code Track number ‘n’, (e.g., 1) 20–n (e.g., 20–1) Track selection 10+ 20–10 Time 20–66 Remain 20–11 Track forward 20–32 Track
Summary of the content on the page No. 8
Technical specifi cation Digital to Analogue conversion High performance 192kHz 24-bit sample rate converter and multiple 24-bit digital to analogue conversion Laser pick-up 3 beam Laser wavelength 780nm Numerical aperture 0.45 Signal to noise ratio 114dB Harmonic distortion, 24-bit (1kHz) 0.0008% * Frequency response (±0.5dB) 0.15Hz–20kHz Output level (0dB) 2.2Vrms Output impedance 47Ω Minimum recommended load 5kΩ * Using 16-bit, triangular p.d.f. dithered data Physical Dimensions W430 x D290
Summary of the content on the page No. 9
Guarantee Worldwide Guarantee This entitles you to have the unit repaired free of charge, during the first two years after purchase, at any authorised Arcam distributor provided that it was originally purchased from an authorised Arcam dealer or distributor. The manufacturer can take no responsibility for defects arising from accident, misuse, abuse, wear and tear, neglect or through unauthorised adjustment and/or repair, neither can they accept responsibility for damage or loss occurring du
Summary of the content on the page No. 10
Pembroke Avenue, Waterbeach, CAMBRIDGE CB5 9QR, England Issue 1 SH156
