Chauvet 38 user manual

Summary of the content on the page No. 1

S Snapsh hot
LED-PAR R 38 Sy ystem™ ™
O OK on Dimm mer

Outdoor O OK


S Sound Activ vated

DMX512 2

Master/Sla ave

Autoswitch hing

Transform mer

R Replaceable Fuse

U User Service eable


Duty Cycle



USER MANU UAL





th
Chauvet, 3000 N 29 Ct, Holl lywood,
FL 33020 U.S.A.
(800) 7 762-1084 – (954) 929 9-1115
F FAX (954) 929-5560
LED-PA AR 38 System™ ™ User Manual 1 6/2 24/2008 3:39 PM M
ww ww.chauvetlighting.com o

Summary of the content on the page No. 2

TABLE OF CONTENTS 1. Before You Begin ............................................................................................ 2 What is included .................................................................................................... 2 Unpacking Instructions .......................................................................................... 2 Safety Instructions ................................................................................................ 3 2. Intr

Summary of the content on the page No. 3

Safety Instructions Please read these instructions carefully, which includes important information about the installation, usage and maintenance of this product. • Please keep this User Guide for future consultation. If you sell the unit to another user, be sure that they also receive this instruction booklet. • Always make sure that you are connecting to the proper voltage, and that the line voltage you are connecting to is not higher than that stated on the decal or rear panel of the

Summary of the content on the page No. 4

Product Overview Power Link Out Led PAR 38’s Switchpack Height Adjustment Channel output Sound Adjustment Fuse Holder Bracket Adjustment On/Off Switch Link In Link Out Footswitch Input LED-PAR 38 System™ User Manual 4 6/24/2008 3:39 PM

Summary of the content on the page No. 5

3. SETUP AC Power Warning! For 230V operation, you must use 230V LED par cans. To determine the power requirements for a particular fixture, see the label affixed to the back plate of the fixture or refer to the fixture’s specifications chart. A fixture’s listed current rating is its average current draw under normal conditions. All fixtures must be powered directly off a switched circuit and cannot be run off a rheostat Figure 1 - AC (variable resistor) or dimmer circuit, even if the

Summary of the content on the page No. 6

6. APPENDIX General Maintenance To maintain optimum performance and minimize wear fixtures should be cleaned frequently. Usage and environment are contributing factors in determining frequency. As a general rule, fixtures should be cleaned at least twice a month. Dust build up reduces light output performance and can cause overheating. This can lead to reduced lamp life and increased mechanical wear. Be sure to power off fixture before conducting maintenance. Unplug fixture from power.

Summary of the content on the page No. 7

Technical Support Address: Service Dept. 3000 N 29th Ct, Hollywood, FL 33020 (U.S.A.) Support (Email): tech@chauvetlighting.com Telephone: (954) 929-1115 - (Press 4) Fax: (954) 929-5560 - (Attention: Service) Website: http://www.chauvetlighting.com Contact Us World Wide General Information Chauvet Lighting th 3000 North 29 Court Hollywood, FL 33020 voice: 954.929.1115 fax: 954.929.5560 toll free: 800.762.1084) World Wide Web www.chauvetlighting.com Technical Specifications WEI