Bogen CommunicationsBRG1R user manual

Summary of the content on the page No. 1

Block Diagram
BUS
ASSIGNMENT BRG1R
DUCKING
GAIN
BUFFER GATING
BUS A
THRESH DUR
G
LINE
A
INPUT
T
E
BUS B
BRG1R
DUCK GAIN
GATE
CONTROL
PRIORITY
MUTE HIGH
Amp-Bridging Input
LEVEL
BUFFERED
LINE
MUTE MED
OUTPUT
IN
Module
MUTE LOW
BUFFER
OUT
GATE
ENABLE/
DISABLE
Features
• Buffered input signal feed available
• Gain/Trim control
• Output signal gating
• Gating threshold and duration adjustments
• Variable signal ducking when muted
• Fade back from mute level
• 4 levels of available priority
• Can

Summary of the content on the page No. 2

Module Installation Jumper Selections BUS Bus Assignment 1. Turn off all power to the unit. ASSIGNMENT The module can be set to operate so that the mono signal 2. Make all necessary jumper selections. Bus GATING can be sent to the main unit’s A bus, B bus, or both buses. A B Both 3. Position module in front of desired module bay J3 J3 J3 opening, making sure that the module is right- Enabled Gating side up. J8 J3 4. Slide module on to card guide rails. Make sure Gating (turning off) of the modul

Summary of the content on the page No. 3

Block Diagram BUS ASSIGNMENT BRG1R DUCKING GAIN BUFFER GATING BUS A THRESH DUR G LINE A INPUT T E BUS B BRG1R DUCK GAIN GATE CONTROL PRIORITY MUTE HIGH Amp-Bridging Input LEVEL BUFFERED LINE MUTE MED OUTPUT IN Module MUTE LOW BUFFER OUT GATE ENABLE/ DISABLE Features • Buffered input signal feed available • Gain/Trim control • Output signal gating • Gating threshold and duration adjustments • Variable signal ducking when muted • Fade back from mute level • 4 levels of available priority • Can