Black & Decker Power Series 90515795 user manual

Summary of the content on the page No. 1

SL102B_ManualEN_051007.qxp 5/10/07 9:13 AM Page i
™
V-1 MILLION POWER SERIES SPOTLIGHT
INSTRUCTION MANUAL
Catalog Number SL102B
Thank you for choosing Black & Decker!
Go to www.BlackandDecker.com/NewOwner
to register your new product
BEFORE RETURNING THIS PRODUCT
FOR ANY REASON PLEASE CALL
1-800-544-6986
BEFORE YOU CALL, HAVE THE CATALOG No, AND DATE CODE
AVAILABLE. IN MOST CASES, A BLACK & DECKER REPRESENTATIVE
CAN RESOLVE THE PROBLEM OVER THE PHONE. IF YOU HAVE A
SUGGESTION OR COMMENT, GI

Summary of the content on the page No. 2

SL102B_ManualEN_051007.qxp 5/10/07 9:13 AM Page 1 GENERAL SAFETY WARNINGS AND INSTRUCTIONS FOR ALL APPLIANCES READ ALL INSTRUCTIONS WARNING: Read all instructions before operating product. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. • AVOID DANGEROUS ENVIRONMENTS Don’t use appliances in damp or wet locations. Don’t use appliances in the rain. • KEEP CHILDREN AWAY. All visitors should be kept at a distance from work area. • STORE ID

Summary of the content on the page No. 3

SL102B_ManualEN_051007.qxp 5/10/07 9:13 AM Page 2 • EXTENSION CORDS. Make sure your extension cord is in good condition. When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating. The following table shows the correct size to use depending on cord length and nameplate ampere rating. If in doubt, use the next heavier gage. The smaller the gage number,

Summary of the content on the page No. 4

SL102B_ManualEN_051007.qxp 5/10/07 9:13 AM Page 3 • Position charging adapter cords so they do not become entangled or become a safety hazard. Keep charging adapter cords away from sharp edges. • Use in a dry location only. • Do not open body casing. There are no user-serviceable parts inside. • To reduce risk of damage to electric plug and cord, pull by plug rather than cord when disconnecting from the 120 Volt AC Charger. • Do not attempt to charge the unit if the 120 Volt AC Charger plug i

Summary of the content on the page No. 5

SL102B_ManualEN_051007.qxp 5/10/07 9:13 AM Page 4 Charge until the Battery Status LED Indicator red LED flashes (approximately 12-14 hours). DO NOT CHARGE FOR LONGER THAN 14 HOURS. Charging/Recharging Using the 12 Volt DC Charging Adapter Plug the barrel tip of the supplied 12 Volt DC Charging Adapter into the 12 Volt DC Charging Port. 12 VOLT DC CHARGING PORT 12 VOLT DC CHARGING ADAPTER Insert the 12 volt DC plug end into the accessory outlet of your vehicle or other 12 volt DC power source.

Summary of the content on the page No. 6

SL102B_ManualEN_051007.qxp 5/10/07 9:13 AM Page 5 1. Disconnect the unit from any charging adapters. 2. Push the rubber bezel forward toward the front of the spotlight to reveal two small Phillips screws in the retaining ring. 3. Using the screwdriver, remove (counterclockwise) the two screws. Set them aside. 4. Lift off the retaining ring, glass lens and rubber “O” ring and set them aside. 5. Carefully remove the reflector and bulb assembly. HAIRPIN RETAINING WIRES PHILLIPS HEAD SCREWS BULB

Summary of the content on the page No. 7

SL102B_ManualEN_051007.qxp 5/10/07 9:13 AM Page 6 TROUBLESHOOTING The Battery Status Indicator LED Does Not Light When Charging 1. Check connection to the 120 Volt AC Charger or 12 Volt DC Charging Port. 2. Check connection to AC or DC power source. 3. Confirm there is a functioning AC or DC current. Unit Will Not Operate 1. The Spotlight will not operate when charging. Be sure all adapters are disconnected before Spotlight use. 2. If you suspect the bulb is blown, check the filament. If the

Summary of the content on the page No. 8

SL102B_ManualEN_051007.qxp 5/10/07 9:13 AM Page 7 SPECIFICATIONS Spotlight Bulb: 6 volt, H3 series, 55 watt Battery: Maintenance-free, sealed lead acid, 6 volt, 3 amp hour AC Charger: UL Listed Class 2, 12 volt DC (300 mA) DC Plug Fuse: 0.5A/250 V Imported by Black & Decker (U.S.) Inc., 701 E. Joppa Rd. Towson, MD 21286 U.S.A. Vector Products, Inc. 4140 S.W. 30th Ave. Fort Lauderdale, FL 33312 7