Revolabs Inc.95 MXP user manual

Summary of the content on the page No. 1

Revolabs Fusion™ Wireless Microphone System- Tandberg Edge 75/85/95
MXP Setup Guide
NOTES AND CAUTIONS:


This setup guide will guide you through the steps needed to properly connect a
Revolabs Fusion System to a Tandberg Edge 75/85/95 MXP video codec.

1. Connecting the Cables
2. Configuring the Edge MXP Video Codec

Note: It is important to carefully follow these instructions in order and completely.
Otherwise your Fusion System and/or the video codec may not function properly.

Summary of the content on the page No. 2

Connecting the Cables CONNECTING A REVOLABS FUSION TO TANDBERG EDGE 75/85/95 MXP VIDEO CODEC 1. Connect a Male RCA-RCA audio cable between the “Conf. In” port on the Fusion and the “VCR 1” port on the Edge MXP. 2. Connect a Male XLR audio cable between the “Mic Conf. Out” port on the Fusion and the “Mic 1” port on the Edge MXP. 3. Connect a Male RCA audio cable between the “Room Out” port on the Fusion and the Speakers. Note: The speakers used for

Summary of the content on the page No. 3

Configuring the Edge 75/85/95 MXP Video Codec CONFIGURING THE AUDIO MENUS OF THE EDGE MXP VIDEO CODEC 1. Go to AUDIO SETTINGS 2. Select INPUTS 3. Confirm that MIC 1 is ON 4. Adjust the audio Input Type Level if necessary (recommend +0dB) 5. Speak into the Revolabs microphones that are connected to MIC 1. The audio meter should peak at about 5dB for normal speech.

Summary of the content on the page No. 4

6. Return to previous menu and select OUTPUTS 7. Confirm that Out1 is ON 8. Adjust the audio Output Type Level if necessary (recommend +0dB) 9. Return to previous menu and select ECHO CONTROL 10. Enable MIC 1 Echo Canceller (ON) 11. Return to previous menu and select AUDIO LEVELING (AGC) 12. Turn MIC Audio Leveling (AGC) OFF NOTE: You must use your Fusion remote control to control the room volume for both the audio and video conference calls. Adjusting the