Honeywell TS13C user manual

Summary of the content on the page No. 1

TABLE OF CONTENTS
Honeywell
INTRODUCTION 3
PRODUCT OVERVIEW 4
Temperature Sensor with LCD
BEFORE YOU BEGIN 5
BATTERY INSTALLATION 7

LOW BATTERY WARNING 7

PLACEMENT OF THE REMOTE SENSOR 7

GETTING STARTED 8

TRANSMISSION COLLISION 9

PRECAUTIONS 9

SPECIFICATIONS 10

FCC STATEMENT 11

DECLARATION OF CONFORMITY 12

STANDARD WARRANTY INFORMATION 13












(TS13C)
USER MANUAL


2

Summary of the content on the page No. 2

INTRODUCTION PRODUCT OVERVIEW Thank you for selecting the Honeywell Temperature Sensor with LCD. FEATURES This device registers, display and transmits the temperature data from • Remote temperature transmission to the main unit via 433 the remote location to the designated main unit (receiver). MHz signal In this package you will find: • Temperature LCD display • One remote sensor (transmitter) TS13C • Case can be wall mounted using built-in hanger • One User Manual • 100 feet (30 meter

Summary of the content on the page No. 3

B. BATTERY COMPARTMENT • During an initial setup, place the main unit as close as possible to the remote sensor. • Holds two AA-size batteries C. RESET • After reception is established (the remote temperature will appear on the main unit’s display), position the remote sensor • Resets all readings D. CHANNEL SWITCH and the main unit within the effective transmission range of 100 • Selects the desired channel feet (30 meters). E. WALL-MOUNT RECESSED HOLE • Keeps the remote sensor o

Summary of the content on the page No. 4

BATTERY INSTALLATION GETTING STARTED NOTE: Install the batteries; select the channel and temperature in After batteries are installed; remote sensor will transmit temperature C° or F° before mounting the remote sensor. readings at 45 second intervals. The main unit may take up to two minutes to receive the initial readings. • Remove the screws from the battery compartment with a small Phillips screwdriver. Upon successful reception, remote temperature will appear on the main • Set the cha

Summary of the content on the page No. 5

SPECIFICATIONS • Remove the batteries from the main unit and reinstall them in Remote Temperature the same manner. Proposed operating range with alkaline batteries: -20.0°C to + 70.0°C/-4.0°F to + 158°F • The remote temperature appeared on the main unit’s display will Proposed operating range with lithium batteries: show that transmission is being received successfully. -38.8°C to + 70.0°C/-38.0°F to +158°F Temperature resolution: 0.1°C/0.2°F LCD display of registered temperature

Summary of the content on the page No. 6

FCC STATEMENT DECLARATION OF CONFORMITY This device complies with Part 15 of the FCC Rules. Operation is We subject to the following two conditions: (1) This device may not cause Name: Hideki Electronics, Inc. harmful interference, and (2) This device must accept any interference Address: 7865 SW Mohawk, Tualatin, OR 97062 received, including interference that may cause undesired operation. Telephone No.: 1-503-612-8395 Warning: Changes or modification to this unit not expressly approved d

Summary of the content on the page No. 7

STANDARD WARRANTY INFORMATION This product is warranted from manufacturing defects for one year from date of retail purchase. It does not cover damages or wear resulting from accident, misuse, abuse, commercial use, or unauthorized adjustment and repair. Note that online product registration is required to ensure valid warranty protection. To register your product, go to our Company website at: www.honeywellweatherstations.com. Click Online Product Registration under the Customer Servic