Summary of the content on the page No. 1
712
WELLSBLOOMFIELD,LLC
2 ERIK CIRCLE, P. O. Box 280 Verdi, NV 89439
fax: 775-689-5976
telephone: 775-689-5707
www.wellsbloomfield.com
OWNERS MANUAL
for
HOT WATER
DISPENSER
2 GALLON MODELS:
1222
1222CA
5 GALLON MODELS:
1225
1226
Includes:
Installation
Operation
Use & Care
Servicing Instructions
Model 1222 Dispenser
PRINTED IN UNITED STATES OF AMERICA
p/n 76580 Rev. G ECN-13387 M712 071120 cps
Summary of the content on the page No. 2
712 76580 Owners Manual Hot Water Dispenser WARRANTY STATEMENT All electrical equipment manufactured by WELLS It also does no t apply if the serial nameplate has been BLOOMFIELD, LLC is warranted against defects in materials removed or unauthorized service personnel perform service. and workmanship for a period of one year from the date of The prices charged by Bloomfield Industries for its products original installation or eighteen (18) months from the date of are based up
Summary of the content on the page No. 3
TABLE OF CONTENTS WARRANTY STATEMENT xi Thank You for purchasing this Wells Bloomfield appliance. SPECIFICATIONS 1 FEATURES & OPERATING CONTROLS 2 Proper installation, professional PRECAUTIONS & GENERAL INFORMATION 3 operation and consistent AGENCY LISTING INFORMATION 3 maintenance of this appliance will INSTALLATION INSTRUCTIONS 4 ensure that it gives you the very best performance and a long, OPERATION 6 economical service life. CLEA
Summary of the content on the page No. 4
712 76580 Owners Manual Hot Water Dispenser FEATURES AND OPERATING CONTROLS 2
Summary of the content on the page No. 5
PRECAUTIONS AND GENERAL INFORMATION WARNING: ELECTRIC SHOCK HAZARD All servicing requiring access to non-insulated components must be performed by qualified service personnel. Do not open any access panels which require the use of tools. Failure to heed this warning can result in electrical shock. WARNING: INJURY HAZARD All installation procedures must be performed by qualified personnel with full knowledge of all applicable electrical and plumbing codes. Failure could result in pr
Summary of the content on the page No. 6
712 76580 Owners Manual Hot Water Dispenser INSTALLATION READ THIS CAREFULLY BEFORE STARTING THE INSTALLATION IMPORTANT: REFER TO EXPLODED VIEWS PAGE 14 FOR COMPONENT To enable the installer to make NAMES/NUMBERS. a quality installation and to Unpack the unit. Inspect all components for completeness and minimize installation time, the condition. Ensure that all packing materials have been removed following suggestions and tests from the unit. should be done before the
Summary of the content on the page No. 7
INSTALLATION (continued) NSF requires that the unit be able to be moved for cleaning NOTE: This equipment must be underneath. A flex line or loops of copper tubing will satisfy this installed to comply with requirement. See Figure 2 below. applicable federal, state and local plumbing codes and ordinances. CAUTION: SHOCK HAZARD Dispenser must be properly grounded to prevent possible shock hazard. DO NOT assume a plumbing line w
Summary of the content on the page No. 8
712 76580 Owners Manual Hot Water Dispenser OPERATION WATER HEATER Water temperature is sensed by thermobulb inserted into the water tank. Temperature is controlled by a mechanical thermostat. The setpoint temperature is adjustable by turning the thermostat shaft. Excessive temperature will trip the hi-limit safety switch, disabling the heating element. The hi-limit will automatically reset when the dispenser cools. WATER LEVEL Water level is controlled by an electron
Summary of the content on the page No. 9
CLEANING INSTRUCTIONS PROCEDURE: Clean Hot Water Dispenser CAUTION: BURN HAZARD PRECAUTIONS: Disconnect dispenser from electric power. Allow dispenser to cool. Dispensed water is extremely hot. Hot water will cause FREQUENCY: Daily serious skin burns. TOOLS: Mild Detergent, Clean Soft Cloth or Sponge Bristle Brush CAUTION: SHOCK HAZARD 1. Disconnect dispenser from electric power. Do not submerge or immerse Allow to cool before cleaning. dispens
Summary of the content on the page No. 10
712 76580 Owners Manual Hot Water Dispenser TROUBLESHOOTING SUGGESTIONS SYMPTOM POSSIBLE CAUSE SUGGESTED REMEDY Water won’t heat Dispenser unplugged or circuit Check power supply cord breaker tripped Check / reset circuit breaker Tank heater switch "OFF" Press switch to "ON" Temperature setpoint too low Adjust thermostat for desired temperature Hi-Limit safety switch tripped Allow to cool hi-limit will self- reset Damaged internal component Examine wiri
Summary of the content on the page No. 11
SERVICING INSTRUCTIONS ACCESS PANELS CAUTION: SHOCK HAZARD REAR PANEL: Remove rear panel to access hot water tank, thermostat, Opening access panels on heating elements, tubing, water level control and plumbing this dispenser may expose connections. uninsulated electrical components. Rear panel is held by four screws at the back. The flanged top Disconnect dispenser from portion fits over the body of the dispenser. electrical pow
Summary of the content on the page No. 12
712 76580 Owners Manual Hot Water Dispenser SERVICING INSTRUCTIONS (continued) TEMPERATURE ADJUSTMENT IMPORTANT: The thermostat will maintain Check temperature at discharge of faucet. temperature within ±3ºF. Remove thermostat access button plug to access thermostat. For high altitude locations, Turn thermostat shaft clockwise to increase temperature. thermostat should be adjusted to a maximum temperature equal to the local boiling temperature minus 5º. T
Summary of the content on the page No. 13
SERVICING INSTRUCTIONS (continued) IMPORTANT: REPLACE HEATING ELEMENT When replacing heating Remove tank lid assembly as detailed on page 10. element, also replace seal gaskets. Remove two hex nuts holding element to cover. Pull element from mounting holes. Reassemble in reverse order. REPLACE SOLENOID Unplug power cord. Turn OFF and disconnect water supply from dispenser inlet fitting. Remove rear panel. Remove two screws holding access do
Summary of the content on the page No. 14
712 76580 Owners Manual Hot Water Dispenser SERVICING INSTRUCTIONS (continued) CAUTION: PROCEDURE: Delime the Water Tank CHEMICAL BURN PRECAUTIONS: Disconnect dispenser from electric power. HAZARD Allow dispenser to cool. Deliming chemicals may be caustic. Wear appropriate FREQUENCY: As required (dispenser slow to heat) protective gloves and goggles during this procedure. Never TOOLS: Deliming Solution siphon deliming chemicals or Protective Gloves, Goggle
Summary of the content on the page No. 15
EXPLODED VIEWS AND PARTS LISTS SERVICE KITS FAUCET REPAIR KITS 84686 Faucet & Shank Complete 8700-25 L Seat Cup (only) SOLENOID REPAIR KITS 83612 Solenoid Complete, Single 120V (1222, 1222CA) 83760 Solenoid Complete, Single 240V (1225, 1226) 85218 Inlet Fitting Kit (includes cap, fitting, washer & screen) 85219 Inlet Strainer (only) 13 712 76580 Owners Manual Hot Water Dispenser
Summary of the content on the page No. 16
712 76580 Owners Manual Hot Water Dispenser EXPLODED VIEW & PARTS LIST 27 3 2 REQD 19 40 28 29 2 REQD 36 18 26 20 24 31 21 35 22 23 25 21 2 12 10 5 9 13 4 11 37 6 8 7 16 14 15 17 34 38 39 1 30 NOTE: Model 1225/1226 shown. Model 1222/1222CA is similar. 14
Summary of the content on the page No. 17
EXPLODED VIEW & PARTS LIST (continued) ITEM DESCRIPTION 1222 P/N 1222CA P/N 1225 P/N 1226 P/N 1 WRAP, BODY 2 TANK ASSY 3 PANEL, TOP BACK 4 PLUG, BUTTON 7/8" 8705-36 8705-36 8705-36 8705-36 5 SUPPORT, TANK 6 LIGHT, PILOT GREEN 8718-31 8718-31 8718-31 8718-31 7 LABEL, HW DISPENSER 8 LIGHT, PILOT AMBER 61178 61178 61178 61178 CONTROL, LOW WATER, 120V 66604 66604 9 CONTROL, LOW WATER, 240V 503141 503141 10 SPACER, NYLON 11 PANEL, REAR LOWER SOLENOID, SI
Summary of the content on the page No. 18
712 76580 Owners Manual Hot Water Dispenser WIRING DIAGRAM 2-GALLON MODELS 1222 and 1222CA POWER HOT WATER LIGHT READY LIGHT (GREEN) (AMBER) HI-LIMIT BLACK WHITE 7 10 THERMOSTAT BLACK 9 7 5 BLACK WHITE HEATING ELEMENT 12 1800 WATTS 1222 8 6 11 GREEN (1500 WATTS 1222CA) 4 WATER LEVEL 13 WATER CONTROL LEVEL BOARD PROBE 2 1 TANK HEATER SWITCH 3 120V POWER CORD FILL NEMA 5-15P SOLENOID BLACK GREEN WHITE MODEL 1222 and 1222CA 16 BLACK BLACK WHITE WHITE WHITE WHITE BLACK BLACK
Summary of the content on the page No. 19
WIRING DIAGRAM (continued) 5-GALLON MODELS 1225 and 1226 HOT WATER POWER READY LIGHT LIGHT (AMBER) (GREEN) BLACK BLACK BLACK 12 ga. 7 7 SCR 15 THERMOSTAT MODULE BLACK 9 A1(+) A2(-) 5 BLACK T1 L1 HEATING ELEMENT 4000 WATTS WHITE 4 COMM 8 WATER LEVEL 16 CONTROL 12 N.O. 14 TANK BOARD HEATER WATER 10 N.C. SWITCH LEVEL PROBE HI-LIMIT BLACK 3 6 MAX RED 12 ga. INPUT 11 COMM GREEN WHITE 2 BLACK 13 WHITE 1 240V POWER CORD NEMA 6-30P BLACK GREEN FILL WHITE SOLENOID MODEL 1225 and 1226 17 712 76580
Summary of the content on the page No. 20
Commercial Food Equipment Service Association Wells Bloomfield proudly supports CFESA Commercial Food Equipment Service Association SER SERVICE VICE TRAINING TRAINING - - QUALITY QUALITY SER SERVICE VICE Genuine Parts Protect - YOU - All - Ways CUST CUSTOMER OMER SA SATISF TISFACTION ACTION WELLSBLOOMFIELD,LLC 2 ERIK CIRCLE, P. O. Box 280 Verdi, NV 89439 fax: 775-689-5976 telephone: 775-689-5707 www.wellsbloomfield.com PRINTED IN UNITED STATES OF AMERICA
