Summary of the content on the page No. 1
3-858-521-11(1)
CD Radio
Cassette-Corder
EN
EN
Operating Instructions page 2
D
D
Bedienungsanleitung Seite 2
CFD-360
1996 by Sony Corporation
CFD-360.E.G_3-858-521-1X.CED/CEE/CEK/EE1
Summary of the content on the page No. 2
Notice for customers in the United Warning Kingdom To prevent fire or shock hazard, do A moulded plug complying with BS 1363 is not expose the player to rain or fitted to this equipment for your safety and moisture. convenience. Should the fuse in the plug supplied need to To avoid electrical shock, do not open be replaced, same rating fuse approved by the cabinet. Refer servicing to ASTA or BSI to BS 1362, (i.e. marked with qualified personnel only. or mark) must be used. If the plug supplied
Summary of the content on the page No. 3
Basic Operations Table of contents Basic Operations 4 Playing a CD 6 Listening to the radio 8 Playing a tape 10 Recording on a tape The CD Player Setting Up 12 Using the display 22 Choosing the power sources EN 13 Locating a specific point in a 23 Selecting the audio emphasis track (Sound Mode/MEGA BASS) 14 Playing tracks repeatedly (Repeat Play) Additional Information 15 Creating your own program 24 Precautions (Program Play) 26 Troubleshooting 28 Maintenance The Radio 29 Specifications 16 Pres
Summary of the content on the page No. 4
Basic Operations Playing a CD 3 1,2 Connect the supplied AC power cord (see page 22). 1 Press OPEN/CLOSE down to open the CD compartment and place the CD on the CD compartment. With the label side up 2 Close the lid of the CD compartment. Display 3 Press ^ (direct power on). The player plays all the tracks once. Track number Playing time EN 4 Basic Operations CFD-360.E.G_3-858-521-1X.CED/CEE/CEK/EE1
Summary of the content on the page No. 5
Basic Operations Use these buttons for additional operations POWER OPEN/CLOSE VOLUME +/– + p ^ = Tip To Press Next time you want to listen to a CD, just press Adjust the volume VOLUME +/– ^. The player turns on Stop playback p automatically and starts playing the CD. Pause playback ^ Press again to resume play after pause. Go to the next track + Go back to the previous track = Remove the CD OPEN/CLOSE Turn on/off the player POWER EN Basic Operations 5 CFD-360.E.G_3-858-521-1X.CED/CEE/CEK/EE1
Summary of the content on the page No. 6
Listening to the radio 1 2 Connect the supplied AC power cord (see page 22). Display 1 Press BAND until the band you want appears in the display (direct power-on). 2 Hold down TUNING/TIME SET Indicates an FM stereo +/– until the frequency digits broadcast. begin to change in the display. The player automatically scans the radio frequencies and stops when it finds a clear station. If you can't tune in a station, press the button once at a time. EN 6 Basic Operations CFD-360.E.G_3-858-521-1X.CED/C
Summary of the content on the page No. 7
Basic Operations Use these buttons for additional operations POWER VOLUME +/– Tips To Press • If the FM broadcast is noisy, press MODE until Adjust the volume VOLUME +/– “Mono” appears in the Turn on/off the radio POWER display and the radio will play in monaural. • Next time you want to To improve broadcast reception listen to the radio, just Reorient the antenna for FM. Reorient the player itself press BAND. The player for AM. turns on automatically and starts playing the previous station. for
Summary of the content on the page No. 8
Playing a tape 1 2 Connect the supplied AC power cord (see page 22). 1 Press p6 to open the tape compartment and insert a recorded tape. Use TYPE I (normal) tape only. Close the compartment. With the side you want to play facing forward 2 Press 9. Display The player turns on (direct power-on) and starts playing. EN 8 Basic Operations CFD-360.E.G_3-858-521-1X.CED/CEE/CEK/EE1 PLAY
Summary of the content on the page No. 9
Basic Operations Use these buttons for additional operations POWER P p6 0 ) VOLUME +/– Tip To Press Next time you want to listen to a tape, just Adjust the volume VOLUME +/– press 9. The player Stop playback p6 turns on automatically and starts playing the Fast-forward or rewind the tape 0 or ) tape. Pause playback P Press the button again to resume play after pause. Eject the cassette p6 Turn on/off the player POWER EN Basic Operations 9 CFD-360.E.G_3-858-521-1X.CED/CEE/CEK/EE1
Summary of the content on the page No. 10
Recording on a tape 13 Connect the supplied AC power cord (see page 22). 1 Press p6 to open the tape compartment and insert a blank tape. Use TYPE I (normal) tape only. With the side you want to record on facing forward 2 Select the program source you want to record. Display To record from the CD player, insert a CD (see page 4) and press p on the CD section. To record from the radio, press BAND and tune in the station you want (see page 6.) EN 10 Basic Operations CFD-360.E.G_3-858-521-1X.CED/CE
Summary of the content on the page No. 11
Basic Operations 3 Press r to start recording. (9 is depressed automatically). Tips Use these buttons for additional operations • Adjusting the volume or the audio emphasis (see POWER P page 23) will not affect p6 the recording level. • If the AM program makes a whistling sound after you've pressed r in step 3, press MODE to select the position that most decreases the noise. • For the best results, use the AC power as a power source. • To erase a recording, proceed as follows: 1 Press 9 and then
Summary of the content on the page No. 12
The CD Player Using the display DISPLAY/ENTER You can check information about the CD using the display. Checking the total track numbers and playing time Press DISPLAY/ENTER in stop mode. If the CD has more than 12 tracks, “OVER 12” appears in the display. Total playing time Total track numbers Music calendar Checking the remaining time Press DISPLAY/ENTER while playing a CD. The track numbers in the music calendar disappear after they are played. To display Press ENTER/DISP The current track nu
Summary of the content on the page No. 13
The CD Player Locating a specific = + point in a track You can locate a specific point in a track while playing a CD using + or =. To locate Press a point while listening to + (forward) or = the sound (backward) while playing and hold down until you find the point. a point while observing + (forward) or = the display (backward) in pause and hold down until you find the point. EN The CD Player 13 CFD-360.E.G_3-858-521-1X.CED/CEE/CEK/EE1
Summary of the content on the page No. 14
Playing tracks =^+ MODE p repeatedly (Repeat Play) You can play tracks repeatedly in normal, shuffle or program play modes (see page 15). 1 Press p. “Cd” appears in the display. 2 Press MODE until the repeat mode you want appears in the display. To repeat Select a single track REP 1 all the tracks REP ALL tracks in random order SHUF REP programed tracks PGM REP and then progam tracks (see step 3 on page 15). 3 Do either of the following to start repeat play: • When you’ve selected REP1, select
Summary of the content on the page No. 15
The CD Player Creating your DISPLAY/ENTER ^ MODE p own program =+ (Program Play) You can make a program of up to 20 tracks in the order you want them to be played. Tips 1 Press p. • You can play the same “Cd” appears in the display. program again, since the program is saved 2 Press MODE until “PGM” appears in the display. until you open the CD compartment. 3 Press = or + and press DISPLAY/ENTER for • You can record your the tracks you want to program in the order you own program. After want. You
Summary of the content on the page No. 16
The Radio Presetting radio DISPLAY/ PRESET +/– BAND TUNING/TIME stations ENTER SET +/– You can store radio stations into the player's memory. You can preset up to 20 radio stations, 10 for each FM or AM in any order. 1 Press BAND until the band you want appears in the display. 2 Tune in a station you want. 3 Hold down DISPLAY/ENTER for about 2 seconds. 4 Press PRESET +/– until the preset number (1 to 10) you want for the station flashes in the music calendar. 5 Press DISPLAY/ENTER again. The new
Summary of the content on the page No. 17
The Radio Playing preset BAND PRESET +/– radio stations Once you've preset the stations, use the number buttons to tune in your favorite stations. 1 Press BAND to select the band. 2 Press PRESET +/– to tune in a stored station. EN The Radio 17 CFD-360.E.G_3-858-521-1X.CED/CEE/CEK/EE1
Summary of the content on the page No. 18
The Timer Setting the clock DISPLAY/ENTER TUNING/TIME SET +/– CLOCK/TIMER Before you set the clock, insert four R6 (size AA) batteries and connect the AC power cord (see page 22.) Before you set the clock, “0:00” flashes. Tip 1 Press CLOCK/TIMER until “CLOCK” appears in The time display the display. system: 24-hour system 2 Press CLOCK/TIMER for about 2 seconds until the hour digit flash. 3 Press TUNING/TIME SET +/– until you set the current hour. Then press DISPLAY/ENTER. The minute digits fla
Summary of the content on the page No. 19
The Timer Waking up to DISPLAY/ CLOCK/ TUNING/ music ENTER TIMER TIME SET+/– STANDBY You can wake up to music or a radio program at a preset time. Make sure you have set the clock (“Setting the clock” on page 18). 1 Prepare the music source you want to play. To play Do this the radio Tune in a station a CD Insert a CD. 2 Press CLOCK/TIMER until “TIMER” appears in the display. 3 Press CLOCK/TIMER for about 2 seconds. The t (clock) and the music source (“Cd” or “RAdiO”) flash. 4 Select the music s
Summary of the content on the page No. 20
Waking up to music (continued) Tip 7 Press STANDBY. You can have the player go on the next The t indication lights up and the power goes off. day at the same time. At the preset time, the power will go on, “TIMER” Just press STANDBY appears in the display and music will play, and until the t indication appears in the display. will shut off automatically after about 60 minutes. The preset settings remain until you reset them. To check/change when the playback will start Press CLOCK/TIMER, then DI
