Summary of the content on the page No. 1
2-515-314-22 (1)
FM/AM
Compact Disc
Player
GB
Operating Instructions
RU
Инструкция по эксплуатации
For installation and connections, see the supplied installation/connections manual.
Перед установкой и подсоединениями прочитайте прилагаемую инструкцию
по установке и подсоединению.
CDX-F5550EE
© 2005 Sony Corporation
Summary of the content on the page No. 2
Welcome ! Warning if your car’s ignition has no ACC position Thank you for purchasing this Sony Compact After turning the ignition off, be sure to press Disc Player. You can enjoy your drive with the and hold (OFF) on the unit until the display following functions. disappears. • CD playback: Otherwise, the display does not turn off and You can play CD-DA (also containing CD this causes battery drain. TEXT*), CD-R/CD-RW (MP3 files also containing Multi Session (page 13)) and ATRAC CD (A
Summary of the content on the page No. 3
Table of Contents Getting Started Other functions Resetting the unit. . . . . . . . . . . . . . . . . . . . . . . . 4 Changing the sound settings . . . . . . . . . . . . . . . 9 Setting the clock . . . . . . . . . . . . . . . . . . . . . . . . 4 Adjusting the sound characteristics DEMO mode . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 — BAL/FAD/SUB . . . . . . . . . . . . . . . . . . . 9 Detaching the front panel . . . . . . . . . . . . . . . . . 4 Adjusting the equalizer curve — EQ
Summary of the content on the page No. 4
Detaching the front panel Getting Started Resetting the unit You can detach the front panel of this unit to prevent theft. Before operating the unit for the first time, or Caution alarm after replacing the car battery or changing the If you turn the ignition switch to the OFF connections, you must reset the unit. position without detaching the front panel, the Detach the front panel and press the RESET caution alarm will sound for a few seconds. button with a pointed object, such as a ball
Summary of the content on the page No. 5
Inserting the disc in the Attaching the front panel Place the hole A of the front panel onto the unit spindle B on the unit, then lightly push the left side in. 1 Press (OPEN). Press (SOURCE) on the unit (or insert a disc) to 2 Insert the disc (label side up). operate the unit. A B 3 Close the front panel. Playback starts automatically. Ejecting the disc 1 Press (OPEN). 2 Press Z. x The disc is ejected. 3 Close the front panel. Note Do not put anything on the inner surface of the front pane
Summary of the content on the page No. 6
T C E L E S M T L O A S I D D I L H E S U P T E S E Location of controls and basic operations Main unit 1234 5 6 7 8 OPEN DSO SEEK SEEK EQ3 REP SHUF BBE MP BBE SENS BTM 1 2 3 4 5 6 OFF CDX-F5550EE 90 qa qs qd qf qg qh Front panel removed qj qk ql RESET Card remote commander RM-X151 ws qh OFF ATT wd 2 SOURCE SEL MODE q; w; + wf – DSPL SCRL wg qs 13 2 wh 46 5 + VOL wa – 6 R P / P G E C D R S U P O L S
Summary of the content on the page No. 7
Refer to the pages listed for details. The p OFF button corresponding buttons on the card remote To power off/stop the source. commander control the same functions as those q RESET button 4 on the unit. r Z (eject) button 5 To eject the disc. a DSO button 2 s Disc slot 5 To select the DSO mode (1, 2, 3 or OFF). To insert the disc. The larger the number, the more enhanced the effect. The following buttons on the card remote b SOURCE button commander have also different buttons/functions
Summary of the content on the page No. 8
CD Radio For details on connecting to a CD/MD changer, Storing and receiving see page 11. stations Caution Display items When tuning in stations while driving, use Best AB Tuning Memory (BTM) to prevent an accident. Storing automatically — BTM 1 Press (SOURCE) repeatedly until “TUNER” appears. A Source To change the band, press (MODE) B Track number/Elapsed playing time, 1 repeatedly. You can select from FM1, FM2, Disc/artist name, Group number* , FM3, AM1 or AM2. Group name, Track name,
Summary of the content on the page No. 9
Receiving a station through a Other functions list — list-up Changing the sound You can list up the frequency or the name. For details on labelling a station, see page 10. settings 1 Select the band, then press (LIST). The frequency or station name appears. Adjusting the sound 2 Press (LIST) repeatedly until the characteristics — BAL/FAD/SUB desired station appears. You can adjust the balance, fader, and subwoofer volume. 1 Press the select button repeatedly until “BAL,” “FAD” or “SUB” app
Summary of the content on the page No. 10
To restore the factory-set equalizer curve, 2 Press and hold (DSPL). press and hold the select button before the The stored name will flash. setting is complete. 3 Rotate the volume control dial repeatedly to After 3 seconds, the setting is complete and select the name you want to delete. the display returns to normal play/reception 4 Press and hold the select button. mode. The name is deleted. Repeat steps 3 and 4 to With the card remote commander delete other names. In step 3, to adjust th
Summary of the content on the page No. 11
DSPL MODE SEL 2 M.DSPL* To select the Motion Display To skip Press (GP/PRESET) (Motion mode. discs then, press again within 2 Display) –“SA” (z): to show moving continuously seconds and hold. patterns and spectrum analyzer. Repeat and shuffle play – “ON”: to show moving patterns. 1 During playback, press (3) (REP) or (4) – “OFF”: to deactivate the (SHUF) repeatedly until the desired setting Motion Display. appears. CONTRAST To adjust the contrast of the Select To play display. 1 The cont
Summary of the content on the page No. 12
Location of controls The corresponding buttons on the rotary Additional Information commander control the same functions as those on this unit. Precautions ATT If your car has been parked in direct sunlight, SEL allow the unit to cool off before operating it. PRESET Power aerial will extend automatically while the unit is operating. MODE Moisture condensation SOURCE On a rainy day or in a very damp area, moisture DSPL condensation may occur inside the lenses and display of the unit. Sho
Summary of the content on the page No. 13
Before playing, clean the Playback order of MP3 files discs with a commercially Folder MP3 available cleaning cloth. Wipe (group) each disc from the centre out. MP3 file Do not use solvents such as (track) benzine, thinner, commercially available cleaners, or antistatic spray intended for analogue discs. Notes on CD-R/CD-RW discs Some CD-Rs/CD-RWs (depending on the equipment used for its recording or the condition of the disc) may not play on this unit. You cannot play a CD-R/a
Summary of the content on the page No. 14
Note Cleaning the connectors Be sure to create the ATRAC CD using authorized The unit may not function properly if the software, such as SonicStage 2.0 or later, or connectors between the unit and the front panel SonicStage Simple Burner 1.0 or 1.1, which are are not clean. In order to prevent this, detach the supplied with Sony Network products. front panel (page 4) and clean the connectors If you have any questions or problems with a cotton swab dipped in alcohol. Do not concerning you
Summary of the content on the page No. 15
2 Remove the unit. Power amplifier section Outputs: Speaker outputs (sure seal connectors) 1Insert both release keys simultaneously Speaker impedance: 4 – 8 ohms until they click. Maximum power output: 50 W × 4 (at 4 ohms) General Hook facing Outputs: inwards. Audio outputs terminal (front, sub/rear switchable) Power aerial relay control terminal Power amplifier control terminal Inputs: Telephone ATT control terminal Illumination control terminal BUS control input terminal BUS audio input te
Summary of the content on the page No. 16
CD/MD playback Troubleshooting The disc cannot be loaded. Another disc is already loaded. The following checklist will help you remedy The disc has been forcibly inserted upside problems you may encounter with your unit. down or in the wrong way. Before going through the checklist below, check The disc does not playback. the connection and operating procedures. Defective or dirty disc. The CD-Rs/CD-RWs are not for audio use General (page 13). No power is being supplied to the unit. M
Summary of the content on the page No. 17
The auto aerial will not go up. NO ID3 t Check the connection of the power aerial ID3 tag information is not written in the MP3 control lead. file. Check the frequency. NO INFO When the DSO mode is on, the sound is Text information is not written in the ATRAC3/ sometimes hampered by noises. ATRAC3plus file. t Set the DSO mode to “OFF” (page 7). NO MAG Preset tuning is not possible. The disc magazine is not inserted in the CD Store the correct frequency in the memory. changer. The br
Summary of the content on the page No. 18
Использование дополнительного Поздравляем с устройства. Кроме воспроизведения на данном покупкой! устройстве, можно также управлять дополнительными проигрывателями Благодарим Вас за то, что Вы остановили компакт-/мини-дисков. свой выбор на проигрывателе компакт- * Диск с CD TEXT - это компакт-диск CD-DA, дисков Sony. В поездке Вы сможете содержащий такую информацию, как название использовать следующие функции диска, имя исполнителя и названия композиций. проигрывателя. Воспроизведе
Summary of the content on the page No. 19
Содержание Начало работы Другие функции Сброс параметров устройства . . . . . . . . . . 4 Изменение настроек звука . . . . . . . . . . . . 10 Установка часов . . . . . . . . . . . . . . . . . . . . . . 4 Настройка характеристик звука Режим DEMO . . . . . . . . . . . . . . . . . . . . . . . . 4 — BAL/FAD/SUB . . . . . . . . . . . . . . . . . 10 Снятие передней панели . . . . . . . . . . . . . . . 4 Настройка кривой эквалайзера Установка передней панели . . . . . . . . . 5 — EQ3 . . . . . . .
Summary of the content on the page No. 20
Режим DEMO Начало работы Сброс параметров При выключении устройства сначала отобразится индикация времени, а затем устройства на дисплее появится демонстрационное изображение (режим демонстрации Перед первым включением устройства (DEMO)). или после замены автомобильного Для отмены режима DEMO выключите аккумулятора, а также после изменения устройство и выберите в установках схемы подключения следует сбросить (стр. 12) параметр “DEMO-OFF”. параметры устройства. Снимите переднюю панель и
