Tamarack Technologies HV1600 user manual

Summary of the content on the page No. 1

HVM.07
HV Series
WHOLE hoUSE VENTILATORS
PRODUCT MANUAL & INSTALLATION GUIDE
Serial Number
Date of Purchase
Point of Purchase
The serial number is located on the shipping carton
and on a label affixed to the upper housing.
When you have unpacked your HV carefully you will find the following:
Unpacking your HV:
HV1600
HV1000
One (1) HV1600 Whole House Ventilator
One (1) HV1000 Whole House Ventilator
One (1) White Metal Grille w/(6) Screws
One (1) White Meta

Summary of the content on the page No. 2

Installation Tools and supplies needed (Not Included): You will need the following items: two pieces of 2x stock to match your existing framing, a saw to cut the hole in the ceiling, a hammer or screw gun to attach the blocking to the existing joists, a phillips head screw driver to attach the grille, weather strip material and low expansion spray foam sealant. For the HV1000, a single pole, single throw (SPST)wall switch will be needed. 1. The fan housing will fit either 16” or 24” on center f

Summary of the content on the page No. 3

HV1000 ........................................78 Watts HV1000 & HV1600.........................R-38 HV1600.......................................140 Watts HV1000.......................................1150 CFM HV1600 High..............................1600 CFM HV1600 Low...............................1150 CFM Wiring Important - Wiring the HV is different than a normal ON/OFF fan. Because the doors are motorized, they need power to open and power to close. The HV requires a constant source of p

Summary of the content on the page No. 4

Care Re-programming All the motors in the HV are permanently sealed and do not require oiling. To keep dirt, dust and debris from the fans we recommend that you periodically remove the grille from within the HV1600 Remote the living space and dust the fan blades. Please remember to make sure that the fan • Remove the cover from the control box is OFF before dusting the fan blades. • Push the Brown #1 button on the side of receiver for 3 seconds…the Green LED light will flash quickly Troubles