Summary of the content on the page No. 1
3-861-412-33(1)
CD Radio
Cassette-Corder
EN
EN
Operating Instructions page 2
ES
ES
Manual de instrucciones página 2
CFD-V25
CFD-V34
CFD-V34L
CFD-V37
CFD-V37L
CFD-930L
1998 by Sony Corporation
Summary of the content on the page No. 2
Notice for customers in the United Warning Kingdom To prevent fire or shock hazard, do A moulded plug complying with BS 1363 is not expose the player to rain or fitted to this equipment for your safety and moisture. convenience. Should the fuse in the plug supplied need to To avoid electrical shock, do not open be replaced, same rating fuse approved by the cabinet. Refer servicing to ASTA or BSI to BS 1362, (i.e. marked with qualified personnel only. or mark) must be used. Information If the p
Summary of the content on the page No. 3
Basic Operations Table of contents Basic Operations 4 Playing a CD 6 Listening to the radio 8 Playing a tape 10 Recording on a tape The CD Player Additional Information 12 Using the display 21 Precautions 13 Locating a specific track 23 Troubleshooting 14 Playing tracks repeatedly 25 Maintenance (Repeat Play) 26 Specifications 15 Playing tracks in random order 28 Index (Shuffle Play) 16 Creating your own program (Program Play) Setting Up 18 Choosing the power sources 20 Adjusting the sound empha
Summary of the content on the page No. 4
Basic Operations Playing a CD 3 1,2 Connect the supplied AC power cord (see page 18). 1 Press 6 PUSH OPEN/CLOSE down to open the CD compartment and place a CD on the CD compartment. With the label side up 2 Close the CD compartment. Display 3 Press ^ (direct power-on). The player plays all the tracks once. Track number Playing time EN 4 Basic Operations
Summary of the content on the page No. 5
Basic Operations Use these buttons for additional operations OPERATE VOL +/– 6 PUSH OPEN/CLOSE (or POWER) ^ =/+ p Tip To Press Next time you want to Adjust the volume VOL +/– listen to a CD, just press ^. The player turns on Stop playback p automatically and starts playing the CD. Pause playback ^ Press again to resume play after pause. Go to the next track + Go back to the previous track = Remove the CD 6 PUSH OPEN/CLOSE Turn on/off the player OPERATE (or POWER, see page 2) EN Basic Operations
Summary of the content on the page No. 6
Listening to the radio 1 2 3 Connect the supplied AC power cord (see page 18). 1 CFD-V25/V34/V37: Press FM or Display CFD-V25/V34/V37 AM (direct power-on). CFD-V34L/V37L/930L: Press RADIO (direct power-on). CFD-V34L/V37L/930L 2 CFD-V34L/V37L/930L only: Select the band. 3 Turn TUNING to tune in a radio station. If the received FM stereo is too weak, the reception becomes monaural. EN 6 Basic Operations
Summary of the content on the page No. 7
Basic Operations Use these buttons for additional operations OPERATE VOL +/– (or POWER) Tip To Press CFD-V34L/V37L/930L Adjust the volume VOL +/– only: To receive an FM stereo Turn on/off the radio OPERATE (or POWER, see program page 2) Set the FM MODE selector at the rear to STEREO. If the FM To improve broadcast reception broadcast is noisy, set Reorient the antenna for FM. Reorient the player itself the selector to MONO for AM or MW/LW. and the radio will play in monaural. For FM For AM/MW/LW
Summary of the content on the page No. 8
Playing a tape 2 1 Connect the supplied AC power cord (see page 18). 1 Press p6 to open the tape compartment and insert a recorded tape. Use TYPE I (normal) tape only. Close the compartment. With the side you want to play facing upward Display 2 Press (. The player turns on (direct power-on) and starts playing. EN 8 Basic Operations
Summary of the content on the page No. 9
Basic Operations Use these buttons for additional operations 0/) P p6 OPERATE (or POWER) VOL +/– Tip To Press Next time you want to Adjust the volume VOL +/– listen to a tape, just press (. The player Stop playback p6 turns on automatically and starts playing the Fast-forward or rewind the tape ) or 0 tape. Pause playback P Press the button again to resume play after pause. Eject the cassette p6 Turn on/off the player OPERATE (or POWER, see page 2) EN Basic Operations 9
Summary of the content on the page No. 10
Recording on a tape 1 3 Connect the supplied AC power cord (see page 18). 1 Press p6 to open the tape compartment and insert a blank tape. Use TYPE I (normal) tape only. With the side you want to record on facing upward 2 Select the program source you want to record. Display To record from the CD player, press CD and insert a CD (see page 4). CFD-V25/V34/V37 To record from the radio, press FM or AM (CFD-V25/V34/V37) or RADIO (CFD-V34L/V37L/ CFD-V34L/V37L/930L 930L) and tune in the station you w
Summary of the content on the page No. 11
Basic Operations 3 Press r to start recording. (( is depressed automatically). Use these buttons for additional operations OPERATE p6 P (or POWER) Tips • Adjusting the volume or the audio emphasis (page 20) will not affect To Press the recording level. • CFD-V34L/V37L/930L Stop recording p6 only: Pause recording P If the MW/LW program Press the button again to makes a whistling resume recording. sound after you’ve pressed r in step 3, Turn on/off the power OPERATE (or POWER, see press PLAY MODE
Summary of the content on the page No. 12
The CD Player Using the display DISPLAY/ENTER You can check information about the CD using the display. Checking the total track number and playing time Check the display in stop mode. Total track number Total playing time Checking the remaining time Press DISPLAY/ENTER while playing a CD. To display Press DISPLAY/ENTER Remaining time on the Once current track* Remaining time on the CD Twice and the number of tracks left Playing time and the current Three times track number * For a track whose n
Summary of the content on the page No. 13
The CD Player Locating a specific track You can quickly locate any track using the number buttons. You can also find a Number specific point in a track while playing a buttons CD. =/+ Note To locate Press You cannot locate a a specific track directly a number button of the specific track if “SHUF” track. or ”PGM” is lit in the display. Turn off the a point while listening to + (forward) or = indication by pressing the sound (backward) while playing p. and hold down until you find the point. Ti
Summary of the content on the page No. 14
Playing tracks repeatedly (Repeat Play) Number You can play tracks repeatedly in buttons normal, shuffle or program play modes (see page 16). MODE ( CD Tip 1 Press CD. To enjoy a short repeat play, use LOOP. 2 Press MODE (PLAY MODE on the player) As soon as you press repeatedly until the repeat mode you want and hold LOOP during appears in the display. play, the player starts a loop play of the part To repeat Select between the point a single track “REP 1” where you pressed LOOP and a point all
Summary of the content on the page No. 15
The CD Player Playing tracks in random order (Shuffle Play) You can play tracks in random order. MODE ( CD On the player 1 Press CD. 1 Press CD. 2 Press MODE repeatedly until “SHUF” appears in 2 Press PLAY MODE repeatedly until the display. “SHUF” appears in 3 Press ( to start shuffle play. the display. 3 Press ^. To cancel Shuffle Play Press MODE until “SHUF” disappears from the display. EN The CD Player 15
Summary of the content on the page No. 16
Creating your own program (Program Play) Number You can arrange the playing order of up buttons to 20 tracks on a CD. MODE ( CD On the player 1 Press CD. 1 Press CD. 2 Press MODE until “PGM” appears in the display. 2 Press PLAY MODE until “PGM” appears 3 Press the number buttons on the remote for the in the display. tracks you want to program in the order you want. 3 Press the = or You can program up to 20 tracks. + then press DISPLAY/ENTER for the tracks you want to program in Programed track t
Summary of the content on the page No. 17
The CD Player Tips To cancel Program Play • You can play the same Press MODE until “PGM” disappears from the program again, since display. the program is saved until you turn off the To check the order of tracks before play power or open the CD compartment. Press DISPLAY/ENTER. • The current program Every time you press the button, the track number will be erased if you appears in the programed order. open the CD compartment. To change the current program • You can record your own program. After
Summary of the content on the page No. 18
Setting Up Choosing the AC IN power sources You can use the AC power or batteries as a power source. Use the AC power source whenever you record since recording consumes much power. Battery compartment to a wall outlet Tip Connecting the AC power cord Only for the Insert one end of the supplied AC power cord to the customers supplied AC IN socket located at the rear of the player, and the with an AC plug other end to the wall outlet. adaptor: Use the supplied AC plug adaptor if the plug Adjustin
Summary of the content on the page No. 19
Setting Up Tip Using the player on batteries Replace the batteries Insert six R20 (size D) batteries (not supplied) into the when the OPR/BATT battery compartment. indicator dims or when the player stops To use the player on batteries, disconnect the AC operating. Replace all power cord from the player. the batteries with new ones. Before you replace the batteries, be sure to take out the CD from the player. EN Setting Up 19
Summary of the content on the page No. 20
Adjusting the MEGA BASS TONE H/L sound emphasis (TONE/MEGA BASS) You can adjust the audio emphasis of the sound you are listening to. Adjusting the tone Press TONE H or L. Press TONE H to enhance the high tone and TONE L to enhance the low tone. Reinforcing the bass sound Press MEGA BASS. To return to normal sound, press the button again. EN 20 Setting Up
