Sharp XE-A102 user manual

Summary of the content on the page No. 1

WARNING
SHARP ELECTRONIC CASH REGISTER
FCC Regulations state that any unauthorized changes or modifications to this equipment not
MODEL
expressly approved by the manufacturer could void the user’s authority to operate this equipment.
Note: This equipment has been tested and found to comply with the limits for a Class A digital device,
XE-A102
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when this equipment is operat

Summary of the content on the page No. 2

Entries TAX1 SHIFT transactions. Non-add code numbers can be entered To make all entries up to that point non-taxable, press /RA 5 7 in the REG or VOID mode. @/TM 3 @/TM 3 TAX2 #/ SHIFT 1 3 and , then SBTL , and v. Subsequent entries in the /PO Operation Examples #/ transaction remain unaffected and will be taxed normally. CHK SBTL Non-add code number entry procedure: When Paid by Cash Manual Tax a code number of up to 8 digits ➝ s. 1. Turn the mode switch to the REG position. Single Item Cash S

Summary of the content on the page No. 3

Programming where R, M and Q represent the following: B, C, D and E: Choice of taxable status Before you begin programming, turn the mode switch to Tax Programming Enter 0000 for non-taxable, 0001 for taxable 1, R: Tax rate (0.0000% to 99.9999%) x 10000 the Z/PGM position. 0010 for taxable 2, 0100 for taxable 3, 1000 for REG If the rate is fractional, it should be converted to its X/Flash OFF Tax Table Programming taxable 4 or 0011 for taxable 1 and 2. decimal equivalent before entering. Z/PGM I

Summary of the content on the page No. 4

5. Install three new “AA” batteries into the 5. Remove the used journal paper roll (if used) Maintenance Drawer Handling battery compartment. from the take-up spool. Batteries Locking the Drawer This cash register provides a low battery symbol Develop the habit of locking the drawer when not (l) and a no battery symbol ( ) which appears on using the register for any extended period of time. the far left of the display in one of the following situations: To lock: Insert the key into the drawer l

Summary of the content on the page No. 5

aproximadamente un año. Cuando llegue el momento Precauciones para el uso CAJA REGISTRADORA ELECTRONICA DE SHARP para cambiar las pilas, el símbolo “l l l l l” aparecerá en la MODELO pantalla indicando que las pilas están gastadas. Si Coloque la caja registradora en un lugar alejado de los aparece este símbolo, las pilas deben ser cambiadas rayos directos del sol, las variaciones extremas de dentro del plazo de dos días. XE-A102 temperatura, humedad alta o salpicaduras de agua. Instale las pilas

Summary of the content on the page No. 6

5. Cuando la cantidad de un artículo supera los 3 Operación de anulación en el modo X/Flash Número de código de no suma Programación dígitos en el registro de la multiplicación: Los registros de recibido a cuenta (RA) y de pagos CL (PO) pueden ser corregidos en el modo de X/Flash. Pulse la tecla y vuelva a registrar un número Los números de código de no suma pueden ser Antes de empezar la programación, gire el interruptor correcto. registrados e imprimidos en el registro diario (o del modo a l