Summary of the content on the page No. 1
Summary of the content on the page No. 2
Summary of the content on the page No. 3
CONTENTS TABLE DES MATIÈRES Thank you for choosing a UV7i product. We hope you will find the instructions in this owner’s Merci d'avoir choisi un produit Phase Linear. Nous espérons que vous allez trouver les manual clear and easy to follow. If you take a few minutes to look through it, you’ll learn how to instructions dans ce guide de propriétaire claires et faciles à suivre. Prenez quelques minutes use all the features of your new Phase Linear UV7i Mobile Multimedia AM/FM/DVD Receiver à le c
Summary of the content on the page No. 4
ii
Summary of the content on the page No. 5
UV7i PREPARATION Congratulations on your purchase of the Phase Linear UV7i • Heat management system - Incorporates forced air- Mobile Multimedia Receiver. cooling to keep the chip-sets operating at nominal WARNING! Never install this unit where operation and viewing could interfere with safe driving temperatures It’s a good idea to read all of the instructions before beginning conditions. • Heavy duty galvanized chassis the installation. We recommend having your Phase Linear UV7i installed b
Summary of the content on the page No. 6
UV7i Optional Accessories 3 iAUX READY (Sold Separately) • Can connect to any portable media device or multimedia device using a standard 3.5mm plug. • Converts 3.5mm auxiliary input to RCA stereo outputs for easy connection to the radio’s auxiliary inputs. Disconnecting the Battery To prevent a short circuit, be sure to turn off the ignition and remove the negative (-) battery cable prior to installation. NOTE: If the UV7i is to be installed in a car equipped with an on-board drive or navig
Summary of the content on the page No. 7
UV7i WIRING DIAGRAM LINK BLUE SUB.W RED TO HEAD UNIT External Power Amplifier FRONT R jLink II WHITE FRONT L VIDEO INPUT YELLOW RED REAR R LINK jLINK II FRONT VIEW WHITE REAR L WHITE AUX IN/L 3 3 AUDIO VIDEO INPUT iAUX RED 3.5mm 3.5mm (Sold Separately) AUX IN/R Antenna Jack YELLOW AUX IN VIDEO Rear Video 1 Antenna YELLOW Harness Cord REAR VIDEO OUT 1 Auto antenna control (connect to antenna control lead & power supply of antenna amplifier) BLUE ANT.CONT PARKING BRAKE NOTE: Please refer to Extern
Summary of the content on the page No. 8
Pus Pus TF T T D T 7-INCH DIGITAL TFT AM/FM/DVD/MP3 RECEIVER OPEN 7-INCH 7-INCH BAND TF TFT T AS/PS DISP h h ENTER POWER MODE MUTE AM/FM/DVD/MP3 RECEIVER OPEN 7-INCH 7-INCH BANDFT AS/PS DISP 7-INCH IGITAL TF Push Push POWER ENTER MODE MUTE UV7i INSTALLATION 5. Replace any items you removed from the dashboard. Pre-installation CAUTION! Be careful not to damage the car 1. Press the metal levers on both sides to remove the half- wiring. sleeve from the radio. FINAL INSTALLATION 3. Place the radio
Summary of the content on the page No. 9
UV7i CONTROLS AND INDICATORS Button Operation 14 26 23 5 1 1. OPEN Press the OPEN button (1) to activate the automatic mechanical system and move the TFT monitor into viewing position. Press again to close the TFT. BAND AS DISP CLOSE 2. WIDE/PIC Press the WIDE/PIC button (2) to adjust the display aspect of the picture to one of three settings: Cinema, Normal or Off. Press and hold to access picture settings. 3. ( ) Press the button (3) to adjust the upward tilt angle of the screen one ste
Summary of the content on the page No. 10
UV7i CONTROLS AND INDICATORS 10. 3/SCN 1 14 26 23 5 DVD Mode: Press once to start scan playback. TUNER Mode: Press once to play preset radio station channel 3. Press and hold to store the current radio station in preset channel 3. OPEN 11. 4/REP 7-INCH 7-INCH TF TFT T BAND AS DISP DVD Mode: Press once to start repeat playback. TUNER Mode: Press once to play preset radio station AM/FM/DVD/MP3 RECEIVER UV7i 7-INCH TFT LCD 21 channel 4. Press and hold to store the current radio station in EJECT
Summary of the content on the page No. 11
UV7i CONTROLS AND INDICATORS LCD Display/Indicators 1. Disc Indicator Illuminated when disc is loaded 2. DVD Playback Indicators (SCN/RPT/RDM/ALL) The following DVD playback indicators become Illuminated when the corresponding function is active: • SCN: scan playback • RPT: repeat playback 1 2 3 4 5 6 • RDM: random playback • ALL: playback all chapters 3. Loudness Indicator (LOUD) The loudness indicator becomes illuminated when the LOUD function is activated. 4. Main Display The main disp
Summary of the content on the page No. 12
UV7i REMOTE CONTROL Table 1: Remote Control Functions Button Function Name/Ref # DVD VCD AM/FM CD/MP3 iPod MENU 1 Enters the main Turns on PBC when Selects Photo mode menu of the disc playing VCD TITLE 2 Enters the title menu Plays first ten sec- Selects Music mode of the disc onds of each chapter/ title MUTE 3 Toggles on/off audio Toggles on/off audio Toggles on/off audio Toggles on/off audio Toggles on/off audio output output output output output 4 Turns the power on/ Turns the power on/ Turn
Summary of the content on the page No. 13
UV7i Table 1: Remote Control Functions Button Function Name/Ref # DVD VCD AM/FM CD/MP3 iPod PIC 24 Displays set-up Displays set-up Displays set-up Displays set-up Displays set-up parameters parameters parameters parameters parameters OPEN/ 25 Opens/Closes the Opens/Closes the Opens/Closes the Opens/Closes the Opens/Closes the CLOSE TFT monitor TFT monitor TFT monitor TFT monitor TFT monitor 26 Decreases monitor tilt Decreases monitor tilt Decreases monitor tilt Decreases monitor tilt Decreases
Summary of the content on the page No. 14
UV7i USING THE TFT MONITOR c. Video should be displayed on the TFT monitor Open/Close TFT Monitor Image Setting within 1 ~ 2 seconds. Press the OPEN button (1) on the front panel or press the Table 2 shows the video output mode for each playing • Parking break is disengaged (off) when the vehicle is ( ) button (25) of the remote control to activate the source. started or the accessory/ignition is turned on. To mechanism that moves the display panel into the viewing activate video, the fol
Summary of the content on the page No. 15
UV7i OPERATING INSTRUCTIONS the screen. The unit will beep two times to confirm your turn- Power On / Off on volume setting. NOTE: The Bass and Treble levels are only Press the /MUTE button (1) to turn the unit on. The buttons adjustable when EQ is set to “User” mode. on the front of the unit light up and “WELCOME” appears Audio Control Menu briefly in the LCD panel (17), followed by the current mode The Audio Control feature allows you to easily adjust your Loudness status. If the TFT scre
Summary of the content on the page No. 16
UV7i SYSTEM SETUP MENU In “System Setup” mode, “ASP CONFIG” and “GENERAL Adjusting a Feature Table 5: General Setup Menu Features SETUP” are available for adjustment. Setup can be 1. Enter the option field for the feature you want to adjust performed by pressing the dedicated button on the remote by pressing the >/|| button (18) on the remote or by Setting Options Function control or on the front panel. For system settings, press the pressing the ENTER (joystick) button (20) on the unit. A Chi
Summary of the content on the page No. 17
UV7i Adjusting the Clock Table 6: ASP Config Menu Features Method 1 – TFT screen open: Setting Options Function 1. Access the “Clock” setting under the General Setup menu. Sub Filter 80Hz Selecting a crossover frequency sets a cut-off frequency of the subwoofer's 2. Press the >> or << buttons (14, 22) on the remote 120Hz LPF (low-pass filter) and the control or the /\ or V buttons (18, 19) on the joystick to “SMALL” speakers' HPF (high-pass 160Hz filter). The Crossover frequency set- mov
Summary of the content on the page No. 18
UV7i AM/FM TUNER OPERATION remote control once (short press) or push in on the joystick Tuner TFT Display Switch to Radio Tuner source once (short press). Press again to stop preview scan. Press the SRC button (15) on the front panel or remote control (8) to switch to the RADIO TUNER source. The Tuner Local Radio Station Seeking (LOC) TFT or LCD display appears. When the Local function is on, only radio stations with a strong radio signal are played. To activate the Local function, Select F
Summary of the content on the page No. 19
UV7i DVD/VCD VIDEO OPERATION NOTE: When properly installed, DVD video cannot be Sectional Repeat Function (A-B) Ejecting a Disc displayed on the main TFT screen unless the parking break is Use the A-B function to define a specific area of a disc to Press the button (21) on the front panel or remote control applied. If you attempt to play a DVD while the vehicle is repeat. (25) to eject the disc. The unit automatically reverts to Tuner moving, the TFT screen displays “PARKING” with a blue
Summary of the content on the page No. 20
UV7i 1. Press the GOTO button (21) on remote control to enter • T : 5/8 – “5 / 8" indicates the fifth of 8 titles on the DVD is Zooming “GO TO” mode. currently playing. Press the ZOOM button (23) on the remote control to enlarge 2. Press the >> or << buttons (14, 22) on the remote • C : 2/16 – “2 / 16" indicates the second of 16 titles on the and pan through the video image using the following options: control or the /\ or V buttons (18, 19) on the joystick to DVD is currently playing. “Q1”,
