Summary of the content on the page No. 1
'9'
In-Dash Single Disc
DVD/CD Player
Before operating the unit, please read these
instructions carefully
128-5987
Summary of the content on the page No. 2
Operating Instructions Welcome Thank you for purchasing this DVD/CD player. Before operating the unit, please read this manual thoroughly and retain it for future reference. IMPORTANT NOTES To prevent an electrical system short which could cause serious damage to the unit, the vehicle, or cause personal injury, please follow the safety recommendations below: • Should there be requirement to replace a blown fuse, remember to first disconnect all power and switch off the unit before fuse replaceme
Summary of the content on the page No. 3
Operating Instructions • Depending on reception quality of the TV, noise interference may appear while a broadcast is being received with the DVD powered on. This is not a malfunction of the DVD or the TV. To watch a TV broadcast, turn off the DVD. • To prevent an operational malfunction, do not play discs other than DVD audio discs, DVD-ROMs, CD-ROMs, Photo CDs and DVDs with region numbers other than this player’s region number. • Only use the correct size of fasteners or cable connectors durin
Summary of the content on the page No. 4
Operating Instructions INSTALLATION GUIDE Precautions: 1. This DVD/CD player should be install by qualified technician or service personnel. 2. The DVD/CD is designed to operate with a 12 Vdc, negative ground battery system. 3. Disconnect the ground wire from the battery terminal before connecting the unit to the electrical system. 4. The wiring from other units or accessories might display a similar color code to this product; however, they may not perform the same function. It is always advisa
Summary of the content on the page No. 5
Operating Instructions Back Panel The figure below shows the back panel design for the player. It also indicates the wire definition for interconnections. Control Unit Interface Yellow : BATT Red : ACC Audio Output Blue : SIDEBRAKE Red : Audio R Black : GND White : Audio L Yellow : Video Output Optical Connector 3 pin Con : Rear IR 5 128-5987
Summary of the content on the page No. 6
Operating Instructions 2.1 Remote Control Reference Guide 1. Power Button 15. Mute Button 2. Setup Button 16. Title Button 3. Display Button 17. Menu/PBC Button 4. Up Cursor Key 18. Return Button 5. Left Cursor Key 19. Right Cursor Key 6. Enter Key 20. Slow Button 7. Previous/Reverse Skip Button 21. Next/Forward Skip Button 8. Down Cursor Key 22. Stop Button 9. Reverse Scan Button 23. Forward Scan Button 10. Play/Pause Button 24. Audio Select Button 11. Subtitle On/Off Button 25. Angle Select Bu
Summary of the content on the page No. 7
¡s ¡t Operating Instructions 2.2 Front Panel Control Reference Guide 1 2 3 4 D XWR HPRL EO GYG F G O\ HDSU QH FY R[ ’9; $ SENSOR RETURN STOP PAUSE PLAY SEL MUTE AUDIO FR FF MENU TITLE ’9’ OFF 0$ 0 7 VIDEO 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 1. Power Indicator 11. TITLE Button 2. Disc slot 12. MENU Button 3.
Summary of the content on the page No. 8
Operating Instructions 3. Basic Functions 3.1 DVD Playback (DVD) 1) Press the POWER( ) button on the remote control, or the DVD/CD player front panel POWER ( ) button to switch on unit power. 2) Insert a disc into the unit. 3) DVD playback commences: • The disc will start to play if the disc does not have any menu recorded on it. • If the disc has one or more titles recorded on it, a menu screen will appear on the TV monitor. NOTE: When “INVALID” appears, it means that the corresponding oper
Summary of the content on the page No. 9
Operating Instructions 3.2.2 Playback Video CDs with Playback Control Without Using Menus (VCD) 1) Press the MENU/PBC button to set PCB off. 2) “PBC OFF” will be displayed on the TV screen. 3) Press the required track number button to select the preferred track, or press the PLAY/PAUSE ( ) button to commence playback. To return to menu playback: 1) Press the MENU/PBC button: “PBC ON” will be displayed on the TV screen. 2) The menu (if available) will be displayed on the TV monitor. 3.3 Fast Forw
Summary of the content on the page No. 10
Operating Instructions 3.4 Next track or previous track (CD/VCD/DVD) Press during playback. Audio CD and Video CD: The player will skip forward to the next track each time the button is pressed. “SKIP FW” will be displayed on the TV screen. DVD: The player will skip forward to the next title/chapter each time the button is pressed. “SKIP FW” will be displayed on the TV screen. Press during playback. Audio CD and Video CD: The player will skip to the beginning of the current track each time the
Summary of the content on the page No. 11
Operating Instructions 3.8 Search Function (CD/VCD/DVD) The Search function enables you to pinpoint a specific location by entering the time/track/chapter or title. Audio CD: When the SEARCH button is pressed the following will be displayed: TRACK xx TIME xx:xx CD Use the numeric keys to enter the desired track or disc time; pressing the ENTER button will cause the player to start playing at the selected track or time. If you are not in search mode, you may use the numeric keys to enter the desi
Summary of the content on the page No. 12
Operating Instructions DVD: When the button is pressed the following will be displayed: SEARCH TITLE xx CHAPTER xxx TIME xx:xx:xx No display Use the numeric keys to enter the desired title or chapter, or chapter time; pressing the ENTER button will cause the player to start playing at the selected title, chapter or chapter time. If you are not in search mode, you may use the numeric keys to enter the desired chapter; the player will commence at the selected chapter. 3.9 Advanced Playback (CD/VC
Summary of the content on the page No. 13
Operating Instructions For DVD: When the REPEAT button is pressed: RPT CHAPT RPT TITLE REPEAT OFF RPT CHAPT = The current chapter will be repeated RPT TITLE = The current title will be repeated REPEAT OFF = Repeat mode will be switched off 3.9.2 Camera Angle (DVD) Some DVD discs may contain scenes which have more than one viewing angle. For these discs, the same scene can be viewed from a different angle by using the ANGLE button as follows: NOTE: This function will only operate on discs where
Summary of the content on the page No. 14
Operating Instructions 3.9.4 Subtitle (DVD) During DVD playback, you may change the subtitle language from the one selected at the initial setting to a different language, if available. 1) When the SUBTITLE ON/OFF button is pressed: SUBTITLE ON SUBTITLE OFF 2) During DVD playback with SUBTITLE ON, press the SUBTITLE button . “SUBTITLE x/y” will appear, where x represents the current subtitle and y represents the total available subtitle. Press the SUBTITLE button until the prefer
Summary of the content on the page No. 15
Operating Instructions 3.9.7 Display Function (CD/VCD/DVD) The display function enables you to view the status, current title number, track number and the total playing time of the disc on the TV screen. Audio CD: When the DISPLAY key is pressed, the following OSD will be shown: TRACK 1/15 TRACK 1/15 TRACK 1/15 TTIME 01:41 TRTIME 02:30 DTIME 11:37 TRACK 1/15 DRTIME 58:50 No display TTIME = Track time TRTIME = Track remaining time DTIME = Disc time DRTIME
Summary of the content on the page No. 16
Operating Instructions DVD: When the display key is pressed, the following OSD will be shown: TITLE 1/8 TITLE 1/8 TITLE 1/8 CHAPTER 1/20 CHAPTER 1/20 CHAPTER 1/20 CTIME 02:14:21 CRIME 02:14:21 TTIME 020:14:21 ANGLE 1/3 ANGLE 1/3 ANGLE 1/3 SUBTITLE 2/3 SUBTITLE 2/3 SUBTITLE 2/3 AUDIO 1/3 AUDIO 1/3 AUDIO 1/3 TITLE 1/8 CHAPTER 1/20 TRTIME 21:14:21 ANGLE 1/3 SUBTITLE
Summary of the content on the page No. 17
Operating Instructions (1) Disc Language a) During STOP, press the SETUP button; the setup menu will appear. b) Use the / buttons or numeric key to select the DISC LANGUAGE item; then press the ENTER button. The disc language menu will appear as follows: DISC LANGUAGE (1) AUDIO (2) SUBTITLE (3) MENU c) Use the / buttons or numeric key to select AUDIO/SUBTITLE/MENU, then press the ENTER button. If audio is selected, the following menu will appear: AUDIO (1) DEFAULT (2) CHINESE (3) E
Summary of the content on the page No. 18
Operating Instructions (2) Password NOTE: The factory default password is 1234 a) During STOP, press the SETUP button, the setup menu will appear. b) Use the / buttons or numeric key to select the PASSWORD item, then press the ENTER button. The change password menu will appear. CHANGE PASSWORD PARENTAL PASSWORD c) Use the numeric keys to enter the password; then press ENTER. d) If the correct password is entered, the user can now enter the new password. CHANGE PASSWORD NEW PASSWO
Summary of the content on the page No. 19
Operating Instructions (3) Parental Control a) During STOP, press the SETUP button, the setup menu will appear. b) Use the / buttons or numeric key to select the PARENTAL item; then press ENTER. The DVD/CD player will request a parental password. PARENTAL PASSWORD PASSWORD c) Use the numeric keys to enter the password; then press ENTER. d) If the correct password is entered, the parental control menu will be shown as follows: PARENTAL CONTROL (8) KIDS ONLY (7) (6) (5) (4) NO ADULT (3)
Summary of the content on the page No. 20
Operating Instructions (5) Digital Out a) During STOP, press SETUP button, the setup menu will appear. b) Use the / buttons or numeric key to select the DIGITAL OUT item, then press ENTER. The preferred digital audio output will be shown as follows: DIGITAL AUDIO OUT (1) LPCM (2) DOLBY DIGITAL (3) MPEG c) Use the / buttons or numeric key to select the preferred digital audio output, then press ENTER. d) The SETUP menu will be shown. 20 128-5987
