Summary of the content on the page No. 1
Summary of the content on the page No. 2
D1374201_User_Manual_T550_T770_MXP_CCM Trademarks and Copyright All rights reserved. This document contains information that is proprietary to TANDBERG. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form, or by any means, electronically, mechanically, by photocopying, or otherwise, without the prior written permission of TANDBERG. Nationally and internationally recognized trademarks and trade names are the property of their respec
Summary of the content on the page No. 3
User Manual Environmental Issues Thank you for buying a product, which contributes to a reduction in pollution, and thereby helps save the environment. Our products reduce the need for travel and transport and thereby reduce pollution. Our products have either none or few consumable parts (chemicals, toner, gas, paper). Our products are low energy consuming products. Battery handling Batteries for the Remote Control are Long Life and Alkaline batteries saving the environment;
Summary of the content on the page No. 4
D1374201_User_Manual_T550_T770_MXP_CCM Operator Safety Summary For your protection, please read these safety instructions completely before operating the equipment and keep this manual for future reference. The information in this summary is intended for operators. Carefully observe all warnings, precautions and instructions both on the apparatus and in the operating instructions. Equipment Markings The lightning flash symbol within an equilateral triangle is intended to aler
Summary of the content on the page No. 5
User Manual ISDN cables - CAUTION - To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line cord. Servicing - Do not attempt to service the apparatus yourself as opening or removing covers may expose you to dangerous voltages or other hazards, and will void the warranty. Refer all servicing to qualified service personnel. Damaged Equipment - Unplug the apparatus from the outlet and refer servicing to qualified personnel under the following conditions:
Summary of the content on the page No. 6
D1374201_User_Manual_T550_T770_MXP_CCM Table of Contents 1 Introduction............................................................................................................................... 1 1.1 At a Glance ............................................................................................................................ 2 1.2 Settings Menu Structure ........................................................................................................ 4 2 Installation .
Summary of the content on the page No. 7
User Manual 4.5 Presentation......................................................................................................................... 63 4.6 Lines..................................................................................................................................... 64 5 Peripheral Equipment............................................................................................................. 65 6 Appendices..................................................
Summary of the content on the page No. 8
Summary of the content on the page No. 9
1 Introduction This User Manual is provided to help you make the best use of your TANDBERG unit. The TANDBERG 550/770 MXP for Cisco CallManager offers superior audio and video quality in a fully-featured unit. Main features Delivers the ultimate visual communication experience, with video quality developed by TANDBERG for business video applications. Full range of Cisco IP telephony functions, including Directory and Call Control, as supported by the Cisco Call Manager.
Summary of the content on the page No. 10
Summary of the content on the page No. 11
Introduction Microphone The high quality table microphone is designed to use on a table during a videoconference. The ideal location for the microphone is on a flat surface at least 2m (6.5 ft) from the front of the system. The microphone should always be placed pointing away from the system with the cable towards the system. The system will automatically equalize sound levels. Loud and soft voices are picked up and transmitted to the far end at approximately the same level. 3
Summary of the content on the page No. 12
Summary of the content on the page No. 13
2 Installation Precautions Never install telephone wiring during a lightning storm. Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations. Never touch uninstalled telephone wires or terminals unless the telephone line has been disconnected at the network interface. Use caution when installing or modifying telephone lines. Avoid using a telephone (other than a cordless type) during an electrical storm. There may b
Summary of the content on the page No. 14
D1374201_User_Manual_T550_T770_MXP_CCM 2.1 Unpacking and Mounting Unpacking The TANDBERG 550/770 MXP for Cisco CallManager consists of the following items: Videoconferencing system Table microphone Remote control Batteries User manual on CD Cables Power supply Mounting Place the system centrally, on top of the monitor, close to the front and ensure it is stable. 6
Summary of the content on the page No. 15
Installation 2.2 Connecting Cables 1. Microphone Cable Connect the microphone to the microphone cable. Connect the microphone cable to microphone input 1 on the system. 2. Monitor Cable(s) Scart (Europe): Connect the Scart adapter to one of the Scart connectors on your monitor. Scart (Europe) & RCA/S-Video (US): Audio: The cable with one RCA connector on one side and two RCA connectors on the other side: Connect the two RCA connectors to your monitor (or S
Summary of the content on the page No. 16
Summary of the content on the page No. 17
Installation Note! Make sure you insert the card in the right direction (with the product logo pointing upwards). Push the card into the slot until the Eject button pops up. See chapter 4.2.2 Wireless LAN Settings for configuration. 9
Summary of the content on the page No. 18
D1374201_User_Manual_T550_T770_MXP_CCM 2.3 Monitor Configuration Power on Power on the monitor and use the monitor remote control to select the Audio/Video input used (refer to your monitor manual). If you are using S-video from the system, remember to select S- Video input to avoid a black and white picture. Select Audio/Video input on monitor Selection of Audio/Video input used is generally performed by pressing the 0/AV button on the TV remote control several times. Please
Summary of the content on the page No. 19
3 General Use Wake up the system When the system is not in use, it is in standby mode and the screen is black. Wake up the system by picking up the remote control. An incoming call or pressing any key on the remote control will also wake up the system. If the system does not respond Make sure that the system is switched on by using the On/Off switch located at the rear of the system. 11
Summary of the content on the page No. 20
D1374201_User_Manual_T550_T770_MXP_CCM 3.1 The Welcome Menu When the system is switched on, you will see the welcome screen. The welcome screen presents the Main menu and displays your Main Camera image in the background (Main Camera is system default). The following menu will appear when not in a call. Press OK or Cancel(X) to activate or hide the welcome menu. This screen provides you with the telephone number(s) assigned to your unit. 12
