Summary of the content on the page No. 1
XDVD8265
INSTALLATION/OWNER’S MANUAL
DVD Multimedia Receiver with 6.5” Touch Screen Display
Safety Note:
The DVD video display of the in-dash unit will not operate while the vehicle is moving. This is a safety feature to
prevent driver distraction. In-dash DVD video functions will only operate when vehicle is in Park and the parking
brake is engaged. It is illegal in most states for the driver to view video while the vehicle is in motion.
Summary of the content on the page No. 2
XDVD8265 PREPARATION Table of Contents Page DVD Region Management . . . . . . . . . . . . . . . . . . . . . . .. . . . . . . . . . . . . . . . . 2 Safety Information/Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Mounting/Wiring . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-8 Control Locations -Receiver . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Control Locations - Remot
Summary of the content on the page No. 3
XDVD8265 PREPARATION Safety Information Please read all instructions carefully before attempting to install or operate. Due to its technical nature, it is highly recommended that your DUAL XDVD8265 is installed by a professional installer or an authorized dealer. This product is only for use in vehicles with 12VDC negative ground only. Safety Notes: The DVD video display of the in-dash unit will not operate while the vehicle is moving. This is a safety feature to prevent driver distraction. I
Summary of the content on the page No. 4
XDVD8265 INSTALLATION Preparation Please read entire manual before installation. Before You Start • Disconnect negative battery terminal. Consult a qualified technician for instructions. • Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration. Getting Started Insert the supplied keys into the left and right sides as shown, and slide the unit out of the mounting sleeve. Mounting O
Summary of the content on the page No. 5
XDVD8265 INSTALLATION Mounting Options TYPICAL REAR-LOAD ISO-DIN MOUNTING Mount factory radio brackets to the chassis using the supplied M5 x 6 mm screws. TYPICAL REAR-LOAD MOUNTING USING UNIVERSAL MOUNTING BRACKETS TYPICAL FRONT-LOAD MOUNTING USING MOUNTING SLEEVE AND TRIM RING 5
Summary of the content on the page No. 6
XDVD8265 INSTALLATION Wiring Diagram - Inputs/Outputs Wiring Notes: Center channel output The center channel audio output (Blue RCA) must be connected to an external amplifier (not included) to hear center channel audio. Subwoofer output The subwoofer audio output (Black RCA) is active in all audio modes. Video output The video output (Yellow RCA) provides composite video output for rear monitors, etc. Rear view camera The rear camera input (Black RCA) can be connected to an optional rear
Summary of the content on the page No. 7
XDVD8265 INSTALLATION Wiring Diagram - Power/Speakers Connecting the parking brake lead (Yellow/Blue - ) The Yellow/Blue lead MUST be connected for the in-dash monitor to operate properly. The DVD video display of the in-dash unit will not operate while the vehicle is moving. This is a safety feature to prevent driver distraction. In-dash DVD video functions will only operate when vehicle is in Park and the parking brake is engaged. It is illegal in most states for the driver to view vide
Summary of the content on the page No. 8
XDVD8265 OPERATION Wiring Diagram - Optional A/V Connections The diagram above illustrates the connection capabilities of the XDVD8265. Two separate Audio/Video inputs allow the connection of a DVD player or game console. A dedicated video output provides video signal for external monitors while a rear view camera can be connected to provide assistance when backing up your vehicle. Visit your local DUAL dealer for more details. * All items shown above are optional and sold separately. 8
Summary of the content on the page No. 9
XDVD8265 OPERATION Control Locations - Receiver 1 2 3 4 5 6 7 8 9 Eject - Press to allow the front panel to slide down to insert/eject discs. 1 10 Reset - Press and hold the RESET button to reset the main unit upon initial 2 installation or if abnormal operation occurs. The reset button is located to the right side of the disc slot. Angle - Press to select between 4 different monitor view angles. 3 Mute - Press to silence the audio, press again to cancel. 4 Mode - Press to select between va
Summary of the content on the page No. 10
XDVD8265 OPERATION Control Locations - Remote 1 37 2 36 3 35 4 34 5 33 6 32 7 8 31 9 10 30 11 12 29 13 14 28 15 16 27 26 17 18 25 19 24 20 23 22 21 Power Mute Subtitle 1 14 27 Preset #3 Volume Up Volume Down 2 15 28 Preset #4 Title Fast Forward/Manual Tune Down 3 16 29 Preset #7 Repeat/Random 4-Way - Left 4 17 30 Preset #8 Navi Play/Pause 5 18 31 Key #0 Aux 1 Angle 6 19 32 BSM (Best Station Memory) Band Key #9 7 20 33 4-Way - Up Display Preset #5 8 21 34 Stop Aux 2 Preset #6 9 22 35 OK/Enter Se
Summary of the content on the page No. 11
XDVD8265 OPERATION General Operation Power On/Off Press to turn the unit on/off. Due to its use of advanced microprocessors, if the unit is on, then turned off, it can not be turned on again for 18 seconds (microprocessor sleep/boot time). Eject Press to allow the front panel to slide down and access the disc slot. Monitor Angle Position Press ANGLE momentarily to select between 4 different monitor view angles. Press ANGLE for more than 1 second to return the monitor to the fully open
Summary of the content on the page No. 12
XDVD8265 OPERATION OSD Menu/General Setup Menu OSD (On Screen Display) Menu Bar Volume/Mute Icon Radio Mode DVD/CD Mode Navigation Mode Auxiliary Mode Setup Mode Volume Level Bar Auxiliary Mode Selection Setup Menu Back OK General Setup Menu Gently press the upper right corner of the screen to display the OSD menu bar. Press the SETUP icon to enter general setup menu. Press BACK or OK to exit the general SETUP menu. The OSD menu bar appears all the time in radio mode. 12
Summary of the content on the page No. 13
XDVD8265 OPERATION General Setup Menu Screen Menu Page Press SCREEN to access screen menu page and adjust the following screen settings. Press or to adjust settings and levels. When selected, the menu item will be highlighted in blue. The current level setting is indicated by a red bar. Brightness Press BRIGHT to adjust the brightness (-15 minimum / +15 maximum). Contrast Press CONT to adjust the contrast (-15 minimum / +15 maximum). Sub-Red (Color) Press S-RED to adjust the sub-red co
Summary of the content on the page No. 14
XDVD8265 OPERATION General Setup Menu Press AUDIO to access audio menu page and press BASS/TREBLE to access Audio Menu Page bass/treble adjustment page. Press or to adjust bass/treble levels. When selected, the menu item will be highlighted in blue. The current bass/treble level is indicated by a red bar. Press BASS to adjust the bass (-6 minimum / +6 maximum). Bass Press TREBLE to adjust the treble (-6 minimum / +6 maximum). Treble Press BACK to return to the previous menu page. Pr
Summary of the content on the page No. 15
XDVD8265 OPERATION General Setup Menu Balance/Fader Press BAL/FAD to access balance/fader adjustment page. Press F-L to hear Front Left output only. Press F-R to hear Front Right output only. Press R-L to hear Rear Left output only. Press R-R to hear Rear Right output only. Press ALL to hear all channels (default setting). Press BACK to return to the previous menu page. Press OK to save settings and exit the system setup menu. Optional Adjustment Method Use the OSD 4-way navi to adjust the bala
Summary of the content on the page No. 16
XDVD8265 OPERATION General Setup Menu Equalizer Press EQUALIZER to access equalizer adjustment page. Press desired preset EQ curve - POP, JAZZ, CLASSIC, ROCK or FLAT. Confirmation Beep Press BEEP to access the beep adjustment page. Press ON to hear confirmation beeps. Loudness Press LOUDNESS to access the loudness adjustment page. Press ON to activate the loudness curve at low volumes. Press BACK to return to the previous menu page. Press OK to save settings and exit the system setup menu. Equal
Summary of the content on the page No. 17
XDVD8265 OPERATION DVD Setup Menu DVD Menu Page Press DVD to access DVD menu page. DVD Audio Press DVD AUDIO to access DVD audio adjustment page. Downmix Press DOWNMIX to access audio downmix adjustment page. Press adjustment bar to select between LO/RO, LT/RT, 3D SURROUND and OFF. SPDIF Press SPDIF to access SPDIF adjustment page. Press desired digital output mode - OFF, RAW or PCM. Press BACK to return to the previous menu page. Press OK to save settings and exit the system setup menu. DVD
Summary of the content on the page No. 18
XDVD8265 OPERATION DVD Setup Menu DVD Preference Press PREFERENCE to access DVD preferences page. Disc Audio Press desired disc audio language - ENGLISH, FRENCH, SPANISH, CHINESE, JAPANESE, KOREAN, RUSSIAN or THAI. Disc Menu Press desired disc menu language - ENGLISH, FRENCH, SPANISH, CHINESE, JAPANESE, KOREAN, RUSSIAN or THAI. Notes: Some DVD discs can be played only in certain playback modes according to the intentions of the software. As the XDVD8265 plays discs according to their intenti
Summary of the content on the page No. 19
XDVD8265 OPERATION DVD Setup Menu Parental Control Press PARENTAL and enter the 4-digit password to access the parental control settings. Press desired parental control level - Kid Safe, G, PG, PGB, PGR, R, NC17 or ADULT. The default password is 1234. Change Password Press PARENTAL then N to change the password. 1. Enter old 4-digit password then enter a new 4-digit password. 2. Enter the new 4-digit password again to confirm. Press C to clear the entry. Press BACK to return to the previous m
Summary of the content on the page No. 20
XDVD8265 OPERATION System Setup Menu System Menu Page Press SYSTEM to access system preferences page. Rear View Camera Press REAR VIEW to access rear view camera adjustment page. Press ON to automatically select rear view mode and display the image on screen when the vehicle is in reverse. Mirror Image Press MIRROR to access mirror image (rear view camera input) adjustment (Rear View Camera Input) page. Press ON to mirror the image displayed on screen when the vehicle is in reverse. Revision
