Summary of the content on the page No. 1
XDVD1002CM
INSTALLATION/OWNER'S MANUAL
Summary of the content on the page No. 2
XDVD1002CM PREPARATION Table of Contents DVD Operation............................................ 12-13 Safety Information...................................... 2-3 CD Operation............................................. 14 Before You Begin........................................ 3 MP3 Operation........................................... 15 Package Contents....................................... 4 DivX Operation............................................ 16 Wiring Diagram....................
Summary of the content on the page No. 3
XDVD1002CM PREPARATION Before You Begin Cautions To prevent damage or injury: 1. Make sure to ground the unit securely to the vehicle chassis ground. 2. Do not remove the top cover of the unit. 3. Do not install the unit in a spot exposed to excessive heat or the possibility of water splashing. 4. Do not subject the unit to excessive shock. 5. When replacing a fuse, only use a new one with the prescribed rating. Using a fuse with the wrong rating may cause the unit to malfunction. 6. To preve
Summary of the content on the page No. 4
XDVD1002CM PREPARATION Contents Main Unit Remote Control Mounting Bracket Wiring Harness and Hardware 2 Pair Headphones Recommended Tools and Equipment • Upholstery hook tool (for removal of panels, if necessary) • #1 and #2 Phillips screwdrivers • Utility knife, razor knife, or shears • Misc. electrical connectors (to connect to vehicle power source – requirement will vary form vehicle to vehicle) • Wire strippers • Electrical tape • Masking tape • Multi-meter (to verify correct voltages and co
Summary of the content on the page No. 5
XDVD1002CM INSTALLATION Wiring Diagram - Main Unit Yellow Connect to battery circuit or constant 12 volt source Black Connect to chassis ground Red Connect to ignition circuit or switched 12 volt source Brown Dome light - See notes below Brown/Black Dome light + See notes below A/V Output Green Dome light trigger See notes below AUX2 Input Aux 2 Input Connect to audio left, audio right, and composite video of external (Red Jacket) source Connect to audio left, audio right, A/V Output and com
Summary of the content on the page No. 6
XDVD1002CM INSTALLATION Mounting 1. Test fit the mounting bracket and unit on the ceiling of the vehicle, verify- ing that it is not going to interfere with the safe operation of the vehicle and is physically safe for the driver and passengers. 2. Once the mounting location is determined, carefully mark the location with masking tape. 3. Lower the vehicle's headliner down to see if a roof support beam is avail- able to screw the mounting bracket to. If a support beam is not available, use a
Summary of the content on the page No. 7
XDVD1002CM OPERATION Control Locations - Main Unit 1 12 11 2 10 3 9 4 5 8 6 7 Power Rear IR Sensor 1 7 Source Select Motorized Disc Slot 2 8 Chapter/Track Down Front IR Sensor/Transmitter 3 9 Dome Light Switch Chapter/Track Up 4 10 Screen Release Play/Pause 5 11 6 Aux1 Inputs 12 Disc Eject 7
Summary of the content on the page No. 8
XDVD1002CM OPERATION Control Locations - Remote Power 1 2 Return Fast Reverse 3 Enter 4 Chapter/Track Down 5 1 32 6 Root Menu 2 31 Setup Menu 7 Step 8 3 30 Subtitle 9 Dimmer 10 4 29 Angle 11 Shuffle 12 5 28 Goto 13 Video/Source 14 6 27 Repeat 15 LCD Screen Menu 7 26 16 Program 17 8 25 Screen Mode 18 Screen Zoom 19 9 24 FM Transmitter 20 Title 21 10 23 Repeat A-B 22 Mute 23 11 22 24 Audio 25 Volume Up/Down 12 21 26 Display 27 Stop 28 Play/Pause 13 14 15 16 17 18 19 20 29 Chapter/Track Up 30 Fast
Summary of the content on the page No. 9
XDVD1002CM OPERATION General Operation To turn on the unit, press the power button on the main unit or on the remote. Press Power On/Off again to turn the unit off. Pressing the screen release lock will unlock the LCD screen, and it will drop down Monitor Open/Close slightly. Move the screen to the desired viewing angle, and the internal hinge assembly will hold the screen in position. Remember to turn the unit off and move the LCD Screen into the closed position when not in use. The li
Summary of the content on the page No. 10
XDVD1002CM OPERATION General Operation - Setup Menu Press SOURCE on the main unit to select between the following sources: Selecting Sources - Main Unit AUX1 > AUX2 > DVD. Press SOURCE on the remote to select between AUX1 > AUX2 > DVD. Selecting Sources - Remote Adjust volume using VOLUME / on the remote (0-16). Volume Press MUTE on the remote to silence the audio. Press MUTE or VOLUME / to Mute cancel. Press DISPLAY on the remote to select the status of each operating mode (elaps
Summary of the content on the page No. 11
XDVD1002CM OPERATION General Operation - Setup Menu Audio Setup In the AUDIO SETUP menu, the following menus are availble: Select SPDIF from the AUDIO SETUP menu. Press to make selection. Press or to adjust (ON/OFF). Select OP MODE from the AUDIO SETUP menu. Press to make selection. Press or to adjust (LINE OUT/RF REMOD). Select DUAL MONO from the AUDIO menu. Press to make selection. Press or to adjust (STERE/L-MONO/R-MONO/MIX-MONO). Select COMPRESSION from the AUDIO men
Summary of the content on the page No. 12
XDVD1002CM OPERATION DVD Operation DVD Mode Press SOURCE on the remote or the main unit to select DVD mode. Insert Disc Press EJECT on the remote control or on the main unit to open the motorized disc slot, insert disc. Eject Disc Press EJECT on the remote control or on the main unit to eject the disc. Selecting DVD Root Menu Press ROOT on the remote control to select DVD root menu. Press or or to select between menu settings. Press ENTER to select/confirm. Stop/Start Press
Summary of the content on the page No. 13
XDVD1002CM OPERATION DVD Operation Press A-B on the remote for more than 2 seconds to set point “A”. Repeat A-B Press A-B for more than 2 seconds to set point “B”. The points between “A” and “B” will continually repeat. Press A-B to cancel repeat A-B. Press ZOOM on the remote to select between ZOOM X1.5, X2, X3 and OFF (normal). Zoom Press AUDIO on the remote while playing to switch between available languages. Audio Language Notes: This function is only available when there are two or more audi
Summary of the content on the page No. 14
XDVD1002CM OPERATION CD Operation Press SOURCE on the remote or the main unit to select DVD mode. CD Mode Press EJECT on the remote control or on the main unit to open the motorized Insert Disc disc slot, insert disc. Press EJECT on the remote control or on the main unit to eject the disc. Eject Disc Press on the remote control to stop playback and retain last position memory. Stop/Start Press II on the remote or main unit to restart playback from the last position. Press twice to
Summary of the content on the page No. 15
XDVD1002CM OPERATION Additional MP3 Operation When an MP3 encoded disc is first inserted, SMART NAVI will show on screen. The MP3 Mode disc will automatically begin playback. NOTE: It may take a few seconds for the unit to read disc. Disc playback must be stopped by pressing on the remote. Press or or Selecting a File/Folder to select between ROOT, FOLDER, FILE or PLAY MODE. Press ENTER to select/confirm. Move cursor to desired file or folder and press ENTER or II to begin playback
Summary of the content on the page No. 16
XDVD1002CM OPERATION ® DivX Operation When a DivX encoded disc is first inserted, playback will begin with the first file auto- DivX Mode matically, To access the SMART NAVI menu screen, stop playback by pressing on the remote. Disc playback must be stopped by pressing on the remote. Press or or Selecting a File/Folder to select between ROOT, FOLDER, FILE or PLAY MODE. Press ENTER to select/confirm. Move cursor to desired file or folder and press ENTER or II to begin playback. Pre
Summary of the content on the page No. 17
XDVD1002CM WARRANTY Limited One-Year Warranty This warranty gives you specific legal rights. You may also What to do? have other rights which vary from state to state. 1. Before you call for service, check the troubleshooting guide in your owner’s manual. A slight adjustment of Dual Electronics Corp. warrants this product to the original any custom controls or connections discussed in your purchaser to be free from defects in material and work- instruction booklet may save you a service call.
Summary of the content on the page No. 18
XDVD1002CM OPERATION Troubleshooting Unit has no power at main unit 1. Verify +12VDC power at 20pin wire harness. 2. Verify ground connection by conducting a continuity test from known ground to ground wire at 20pin wire harness. Unit has power but no video 1. Verify that the correct A/V source is selected (DVD, AUX1, AUX2). 2. Verify connections at both ends of any external source component harness used. Picture has occasional distortion 1. A small amount of picture distortion may appear
Summary of the content on the page No. 19
XDVD1002CM OPERATION Specifications Player Signal-to-noise: >92dB Dynamic range: >85dB Frequency response: 20Hz-20kHz Panel size: 10.2” Diagonal measurement Monitor Format: Widescreen 16:9 View area: 8.74” x 5.24” (222 x 133 mm) Display system: Color TFT active matrix LCD View angle (up/down/left/right): 50/65/65/65 Resolution: 800 x 480 Pixel pitch: 0.278 mm Brightness (cd/m2): 450 Contrast ratio: 400:1 Left IR audio frequency: 2.3Mhz IR Headphones Right IR audio frequency: 2.8Mh
Summary of the content on the page No. 20
Dual Electronics Corp. 21318 64th Ave. South Kent, WA 98032 Toll Free: 1-866-382-5476 www.dualav.com ©2005 Dual Electronics Corp. All rights reserved. NSA0805-V01
