Pioneer DEH-P3370XM user manual

Summary of the content on the page No. 1

T
T
R
R
A
A
T
T
INSTALLATION MANUAL
S
S
N
N
O
O
C
Connecting the Units
Note:
Connecting the Tuner Unit (Fig. 2)
• This unit is for vehicles with a 12-volt battery and • When an external power amp is being used with
negative grounding. Before installing it in a recre- this system, be sure not to connect the blue/white
ational vehicle, truck or bus, check the battery lead to the amp’s power terminal. Likewise, do not
voltage. connect the blue/white lead to the power terminal
• To avoid shorts in t

Summary of the content on the page No. 2

Connecting the Units Connecting the Head Unit (Fig. 3) Protect the Antenna Connector This Product Connecting cords with RCA pin plugs (sold separately) Power amp (sold separately) Rear or Subwoofer output Blue/white Screw (3 · 6 mm) Fuse To system control terminal of the power amp or Auto-antenna relay control terminal Antenna jack (max. 300 mA 12 V DC). System remote control IP-BUS input (Blue) Fig. 4 IP-BUS cable To Tuner unit (Refer to Fig. 2.) Yellow To terminal always supplied with power Wh

Summary of the content on the page No. 3

Installation Note: Removing the Unit (Fig. 7) (Fig. 8) DIN Front/Rear-mount • Before finally installing the unit, connect the • When mounting this unit, make sure none of the wiring temporarily, making sure it is all connected leads are trapped between this unit and the sur- 5 This unit can be properly installed either from “Front” (conventional DIN Front-mount) or Frame up properly, and the unit and the system work rounding metalwork or fittings. “Rear” (DIN Rear-mount installation, utilizing t

Summary of the content on the page No. 4

Installation Installing the Tuner Unit DIN Rear-mount Fixing the Front Panel Mounting with Brackets (Fig. 15) If you do not operate the Detaching and Replacing the Front Panel Function, use the sup- plied fixing screws and holder to fix the front panel to this unit. Installation using the screw holes on the side of the unit 1. Attach the holder to the front panel. (Fig. 12) 1. Remove the frame. (Fig. 9) Tapping screw (4 · 12 mm) Frame 8 Insert the release pin into the hole in 9 the bottom of the