Summary of the content on the page No. 1
JCD3006
MOBILE CD PLAYER / RECEIVER
Installation and Operation Manual
JCD3006
Summary of the content on the page No. 2
JCD3006 SAFETY INFORMATION DISC NOTES When Driving Compatible Disc Types Keep the volume level Iow enough to be aware of the road and traffic conditions. Table 1: General Disc Information When Washing your Vehicle Do not expose the product to water or excessive moisture. Moisture can cause electrical Diameter/ shorts, fire or other damage. Disc Type Logo Playback Time Playable Sides When Parked Audio CD 12 cm single side 74 minutes Parking in direct sunlight can produce very high temperatures i
Summary of the content on the page No. 3
JCD3006 7. After completing the wiring connections, attach the front panel and turn the unit on to INSTALLATION confirm operation (vehicle ignition switch must be on). If the unit does not operate, Before You Begin recheck all wiring until the problem is corrected. Once proper operation is achieved, turn the ignition switch off and proceed with final mounting of the chassis. 1. Disconnect Battery 8. Carefully slide the radio into the mounting sleeve making sure it is right-side-up until it is
Summary of the content on the page No. 4
JCD3006 2. Carefully unsnap the plastic trim ring from the front of the new radio chassis. Remove and discard the trim ring. 3. Remove the factory mounting brackets and hardware from the existing radio and attach them to the new radio. Select a position where the screw Screws holes of the bracket and the screw holes of the main unit Dashboard are aligned (are fitted). Tighten the screws at 2 places on each side. Do not Factory exceed M5 x 9 MM maximum Mounting screw size. Longer scre
Summary of the content on the page No. 5
JCD3006 WIRING 688A ANTENNA JACK FUSE ANTENNA SOCKET 20-PIN AUDIO/POWER HARNESS (See Figure 1) RCA-TO-RCA CABLE (not supplied) WHITE REAR LINE OUT GREY RED AMP Figure 1: 20 PIN HARNESS PIN CHART 12 3 4 5 6 7 8 9 10 BLUE Power Antenna Connect to power antenna or amplifier, 11 12 13 14 15 16 17 18 19 20 If not used, tape bare end of wire. BLACK Ground PIN WIRE COLOR FUNCTION / LABEL Connect to ground terminal or clean 1 GREY / BLACK RIGHT FRONT SPEAKER ( ) unpainted metal part of chassis. 2 GREY R
Summary of the content on the page No. 6
RESET JCD3006 Display (D) BASIC OPERATION Press the D button (18) on the control panel (or the DISP button on the remote control) to view the clock. The LCD will display the clock for 5 seconds, then return to the previous display 3 7 4 19 22 2 mode. Clock Adjustment With the clock displayed, press the D button (18) until the LCD flashes. Press the up >>| (21) button to adjust the hours or the down |<< button (20) to adjust the minutes. (You can also use JCD3006 the U and D buttons on the re
Summary of the content on the page No. 7
JCD3006 Preset Stations TUNER OPERATION Six numbered preset buttons store and recall stations for each band. 3 7 4 19 22 2 Store a Station Select a band (if needed), then select a station. Hold a preset button (12-17) for three seconds. The preset number will appear in the display. Recall a Station Select a band (if needed). Press a preset button (12-17) to select the corresponding stored JCD3006 station. Automatically Store / Preset Scan (AS/PS, AMS) Automatically Store Select a band (if need
Summary of the content on the page No. 8
JCD3006 CD OPERATION 3 7 4 19 22 2 JCD3006 1 6 5 20 21 12 13 14 15 16 17 10 9 8 11 18 Insert and Eject Disc Insert a disc, label-side up, with the unit turned on. “S-CDP” will display on the LCD for about 2 seconds and the unit will play the first track on the disc. Press the eject button (2) to stop disc play and eject the disc. The unit does not have to be turned on to eject the disc. Controlling Disc Playback Track Select Press the up >>| (21) or down |<< button (20) on the control panel (o
Summary of the content on the page No. 9
JCD3006 SPECIFICATIONS TROUBLESHOOTING CD Signal to Noise Ratio. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . > 70dB Symptom Cause Solution Sampling Frequency . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 44.1Khz No power The vehicle’s ignition is not If the power supply is properly Quantization Bits . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 10
JCD3006 ASA Electronics Corporation www.asaelectronics.com © 2006 ASA Electronics Corporation v.071206 10
