Summary of the content on the page No. 1
LDCS 91
OWNER'S MANUAL
Mobile Video System
CAR DVD/VCD/CD/MP3 CASSETTE RECEIVE
ST
TAPE IN
MODE CLK POWER
STOP PLAY/PAUSE MUTE
SETUP
BAND ST/MO ANGLE REPEAT
OSD 3 IN 1
TITLE/PBC LO/DX
SEL EQ
A/P
DVD & CASSETTE & RADIO
+
UP
F.FWD
VOL
NEXT
ENTER
VOL F.BWD
PREV.
DN
-
1 2 34
5 6 7 8
SW
MENU 9 0 +10
DVD/VCD/CD/MP3 PLAYER WITH
AUTO REVERSE CASSETTE WITH
AM/FM-STEREO DIGITAL PLL TUNING RADIO
WITH ANTI-THEFT FLIP DOWN DETACHABLE PANEL
Summary of the content on the page No. 2
CONTENTS Safety Information ........................................................................................2 Disc Notes .....................................................................................................3 Tape Notes.....................................................................................................4 Installation .....................................................................................................5 Electric Connection ...................
Summary of the content on the page No. 3
SAFETY INFORMATION CAUTION: THIS DVD PLAYER IS A CLASS I LASER PRODUCT. HOWEVER THIS DVD PLAYER USES A VISIBLE/INVISIBLE LASER BEAM WHICH COULD CAUSE HAZARDOUS RADIATION EXPOSURE IF DIRECTED. BE SURE TO OPERATE THE DVD PLAYER CORRECTLY AS INSTRUCTED. USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. DO NOT OPEN COVERS AND - DO NOT REPAIR YOURSELF. REFER SERVICINGTO QUALIFIED PERSONNEL. WARNING: TO RED
Summary of the content on the page No. 4
DISC NOTES Disc formats supported by this player Label side up DVD 12 cm disc (Single-sided disc only) Video CD 12 cm disc Do not touch CD the underside 12 cm disc of the disc MP3 12 cm disc Discs which cannot be played with this Do not bend player • DVD-ROM • DVD-R/DVD-RAM • CDV • CD-G Wipe the disc from center Handling and Cleaning toward the outside edge • Dirt, dust, scratches and warping disc will cause misoperation. • Do not place stickers or make Preparing New Discs with Rough scratches
Summary of the content on the page No. 5
TAPE NOTES 1. Take care of your tape cassette to preserve the quality of the recordings. Do not allow them to be exposed to direct sunlight. Store them in a place protected from dirt and dust and avoid handing with greasy or oily hands. Also, keep the away from magnets, and motors of the permanent magnet type. 2. It is not advisable to use cassette tapes longer than C-60 (30 minutes per side) in automobile players, since the tape is too thin and tends to become easily entangled. Always remove
Summary of the content on the page No. 6
INSTALLATION NOTES: Choose the mounting location where the unit will not interfere with the normal driving function of the driver. Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly. Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions. Consult with your nearest dealer if installation requires the drilling of holes or
Summary of the content on the page No. 7
INSTALLATION 1. Install brackets and screws removed from your old radio (not provided with this unit). 2. Slide unit and frame into dash opening. 3. Trim ring has precutgrooves on the back of it. The size of the trim ring can be reduced (made smaller) for different types of installations. Hold the trim ring firmly in one hand, and using a pair of pliers, grasp the trim ring above the score line (groove) and bend gently back and forth a couple of times. Then the piece should break away. 4. Ins
Summary of the content on the page No. 8
INSTALLATION CAUTION: DO NOT INSTALL THE DETACHABLE PANEL BEFORE CONNECTING THE WIRE. 1. The unit is designed for negative terminal of the battery which is connected to the vehicle metal. Please confirm it before installation. 2. If the car interior is extremely hot, as after being parked in the sun, do not use the player until the car has been driven for a while to cool off the interior. 3. Press the REL button to take away the front panel (see fig.1), and put it in the protective case (see f
Summary of the content on the page No. 9
ELECTRIC CONNECTION MAIN UNIT ANTENNA CONNECTOR FUSE RED IGNITION SWITCH (B+) FUSE MEMORY YELLOW BACK-UP (B+) BLACK GROUND (B–) FUSE POWER BLUE ANTENNA WHITE GREY FRONT Lch FRONT Rch SPEAKER SPEAKER WHITE/BLACK GREY/BLACK GREEN VIOLET REAR Lch REAR Rch SPEAKER SPEAKER GREEN/BLACK VIIOLET/BLACK DESCRIPTION OF RCA JACK (ON THE BACK OF THE UNIT) FRONT RCA OUTPUT AUXILIARY IN V. OUT = VIDEO OUT V. IN = VIDEO IN FL OUT = FRONT LEFT AUDIO OUT L. IN = LEFT AUDIO IN FR OUT = FRONT RIGHT AUDIO OUT R. IN
Summary of the content on the page No. 10
REMOTE CONTROL 11 1 12 MODE CLK POWER 2 13 STOP PLAY/PAUSE MUTE SETUP 14 3 BAND ST/MO ANGLE REPEAT OSD 4 15 5 TITLE/PBC LO/DX 16 EQ SEL A/P 6 17 18 7 + 8 19 UP F.FWD VOL NEXT ENTER 20 F.BWD VOL PREV. DN - 9 1 2 34 21 5 6 7 8 SW 10 MENU 9 0 +10 22 1. CLK Press it to change the display to clock display. 2. MODE Press it to change between radio or disc mode. 3. SETUP Display the SETUP menu. 4. OSD (BAND) Display statistical disc information during playback (To change the band in radio stations) 5.
Summary of the content on the page No. 11
REMOTE CONTROL Preparing the Remote Control Inserting the Batteries 1. Open the battery compartment cover. 2. Insert the new batteries.Make sure that the positive and negative terminals of the batteries are oriented indicated. 3. Close the cover Using the Remote Control Face the remote control towards the player front face IR mark (remote control signal receiver). Operation angle: About ± 30 degree in each the direction of the front of the IR mark. To prevent damage to the unit, be sure to follo
Summary of the content on the page No. 12
BASIC OPERATION 1 16 5 19 13 CAR DVD/VCD/CD/MP3 CASSETTE RECEIVE ST TAPE IN 2 18 3 6 7 8 14 15 12 9 10 11 4 20 17 26 24 25 23 21 22 11
Summary of the content on the page No. 13
BASIC OPERATION 1. OPEN BUTTON Press it to flip down the front panel then you can insert the TAPE into the tape compartment. 2-3. VOL +/ VOL- & SEL BUTTON Press it to change audio mode through volume, bass, treble, balance, and fader modes. Use VOL +/ VOL- buttons to adjust the selected mode. When mode has not been adjusted for several seconds, display returns to normal radio or CD display. VOL BAS TRE BAL FAD A. Volume: Adjust volume level by using VOL +/ VOL- buttons. Note:The unit is initia
Summary of the content on the page No. 14
BASIC OPERATION a. Continuously repeat at the current chapter/track, when selected REP-ONE mode. b. Select REP-ALL mode to continuously repeat all chapter/track on the current disc. c. REPEAT feature does not support VCD2.0 (with PBC ON). E. Press 3/INT button to scan disc. a. In the state of VCD/CD disc playing, press the 3/INT button on the front panel to play the previous 10 seconds part of each track/chapter on disc (depend on the disc used for VCD). b. In the state of DVD/MP3 disc playing,
Summary of the content on the page No. 15
BASIC OPERATION 17. / BUTTONS A. When long pressing the / button (more than 2 seconds) during play, the speed of rapid forward/reverse changes according to the disc as follow. DVD: VCD/CD: Normal Playback 2X 4X 6X 8X Normal Playback 2X 3X 4X MP3: Normal Playback 2X 4X B. Shortly press the / button during playback to skip to next track or back one track. Note: For some VCD2.0 discs (PBC-playback control), and buttons may be unavailable. C. Press UP or DN button on the remote cont
Summary of the content on the page No. 16
BASIC OPERATION 24. FLASHING LED If the front panel is not on the main unit, LED will be flashing. 25. RESET BUTTON RESET button is placed on the housing and must be activated with either a ballpoint pen or thin metal object. The RESET button is to be activated for the following reasons: A. Initial installation of the unit when all wiring is completed. B. All the function buttons do not operate. C. Error symbol on the display. Note: If press RESET button, the unit can’t work yet, please use a
Summary of the content on the page No. 17
BASIC OPERATION c. Press OSD for the third time: On-Screen Display Function Press the OSD button during playback to T:01/18 P: 00:00:25 LR DISC display the contents of the current disc TOTAL ELAPSED on the screen. A. Example for DVD: d. Press OSD for the fourth time: a. Press OSD for the first time: T:01/18 P: 00:00:25 LR DISC TOTAL REMAIN TITLE 01/03 CHAPTER 002/025 P:00:00:25 TITLE ELAPSED e. Press OSD for the fifth time: The message on the screen will be Title N
Summary of the content on the page No. 18
BASIC OPERATION Multi-subtitle Language Function Multi-audio Language Function (For DVD only) A. DVD: Press AUDIO during Press SUBTITLE during playback. Each playback. time the button is pressed, number of the Each time the button is pressed, subtitle language changes in sequential number of the audio soundtrack order. language changes on sequential order. Notes: The language number is different Notes:The language number is according to the disc. Some discs only different according to the
Summary of the content on the page No. 19
SETUP INITIAL SETUP GENERAL SETUP --- MAIN PAGE--- --- GENERAL PAGE --- GENERAL SETUP TV DISPLAY NORMAL/PS SPEAKER SETUP PIC MODE NORMAL/LB AUDIO SETUP ANGLE MARK WIDE PREFERENCES OSD LANG CAPTIONS SCR SAVER EXIT SETUP 1. Press SETUP in the stop mode. MAIN PAGE (Press the stop button twice to ensure the player under STOP mode.) TV Screen 2. The initial SETUP menu is displayed. 4:3 Wide (16:9) Video Material Normal Pan Scan Letter-box 4:3 3. Select the preferred item by using the / buttons. 16:
Summary of the content on the page No. 20
SETUP --- GENERAL PAGE --- --- GENERAL PAGE --- TV DISPLAY TV DISPLAY PIC MODE AUTO PIC MODE ANGLE MARK HI-RES ANGLE MARK OSD LANG N-FLICKER OSD LANG ENGLISH CAPTIONS CAPTIONS SCR SAVER SCR SAVER MAIN PAGE MAIN PAGE 2. PIC MODE SETUP 4. OSD LANG TYPE SETUP Select AUTO, the player PIC mode will Select the preferred OSD language by depend on DVD disc. using the / buttons. Select HI-RES format for best image resolution. Select N-FLICKER format on format on image or picture under noise affect. -
