JVC GET0632-001A user manual

Summary of the content on the page No. 1

INFORMATION (For U.S.A.)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no g

Summary of the content on the page No. 2

Listening to the radio Listening to the disc ~ Ÿ ~ Ÿ ] “FM” or “AM” ] Turn on the power. “ST” lights up when receiving an FM stereo broadcast with sufficient signal strength. All tracks will be played repeatedly until you change the source or eject the disc. Manual search Selecting a preset station “M” flashes, then press the Stopping playback and ejecting the disc Selecting the playback modes 1 button repeatedly. You can use only one of the following playback “NO DISC” appears. [Hold] mode

Summary of the content on the page No. 3

Selecting a preset sound mode You can select a preset sound mode suitable for the music genre. Storing your own sound mode Sound element Tone FLAT = NATURAL = DYNAMIC = You can store your own adjustments in memory. Frequency Level Q VOCAL BOOST = BASS BOOST = BASS 60 Hz, 80 Hz, 100 Hz, –06 to +06 Q1.0, Q1.25, 1 USER = (back to the beginning) [Hold] 200 Hz Q1.5, Q2.0 MIDDLE 0.5 kHz, 1.0 kHz, –06 to +06 Q0.75, Q1.0, While listening, you can adjust the tone level of the selected sound 2 1.5 k

Summary of the content on the page No. 4

Installation Electrical connections IMPORTANT: A custom wiring harness (separately purchased) which is suitable for your car is recommended This unit is designed to operate on 12 V DC, NEGATIVE ground Prepare these before installation.... for connection between the unit and your car. electrical systems. If your vehicle does not have this system, a • Consult your JVC car audio dealer or a company supplying kits for details. voltage inverter is required, which can be purchased at JVC car audio

Summary of the content on the page No. 5

Troubleshooting More about this unit General • This unit can recognize a total of 512 files, 255 Symptom Remedy/Cause folders, and 8 hierarchical levels. • If you turn off the power while listening to a track, Sound cannot be heard from the • Adjust the volume to the optimum level. • This unit can play back files recorded in VBR playback will start from where it had been stopped speakers. • Make sure the unit is not muted/paused. (See page 1.) (variable bit rate). previously next time you t

Summary of the content on the page No. 6

Maintenance Specifications CD PLAYER SECTION How to clean the connectors To play new discs AUDIO AMPLIFIER SECTION Type: Compact disc player Wipe the connectors with a cotton swab or cloth Remove any rough areas from the Power Output: Signal Detection System: Non-contact optical pickup moistened with alcohol. inner and outer edges of the disc. 20 W RMS × 4 Channels at 4 Ω and (semiconductor laser) ≤ 1% THD+N Number of channels: 2 channels (stereo) Signal-to-Noise Ratio: Frequency Response: