Summary of the content on the page No. 1
Summary of the content on the page No. 2
Summary of the content on the page No. 3
MP6211 TABLE OF CONTENTS TABLE DES MATIÈRES Introduction ..............................................................................................1 Introduction ............................................................................................33 Preparation ..............................................................................................2 Préparation ............................................................................................34 Wiring .................
Summary of the content on the page No. 4
MP6211 ii
Summary of the content on the page No. 5
MP6211 • Selectable display priority INTRODUCTION • Switchable bi-color preset illumination – red or blue Congratulations on your purchase of the Jensen MP6211 Mobile Receiver. It’s a good idea to • Infrared remote control (included) read all of the instructions before beginning the installation. We recommend having your • IR30 Steering Wheel Remote Control compatible (sold separately) Jensen MP6211 installed by a reputable installation shop. • High contrast positive Liquid Crystal Display (LC
Summary of the content on the page No. 6
MP6211 Pre-installation PREPARATION 1. Disconnect Battery Tools and Supplies Before you begin, always disconnect the battery negative terminal. The following tools and supplies are needed to install the radio. 2. Remove Transport Screws • Torx type, flathead and Philips screwdrivers 3. Remove Radio from Sleeve • Wire cutters and strippers Lift latches on both sides of sleeve to remove half-sleeve from radio. • Tools to remove existing radio (screwdriver, socket wrench set or other tools) • Elec
Summary of the content on the page No. 7
MP6211 WIRING WIRING DIAGRAM Wiring with a Wiring Adapter (Purchased Separately) Connect Wires You can make these connections without being in the vehicle. 1. Splice or crimp wires. 2. Attach wiring adapter to car wiring harness. Wiring Diagram / Color Codes 1. Power Antenna (dark blue wire) - Connect to power antenna or amplifier. If not used, tape bare end of wire. 2. Accessory/Ignition (red wire) - Connect to existing radio wire or radio fuse. 3. Ground (black wire) - Connect to ground termi
Summary of the content on the page No. 8
MP6211 INSTALLATION This unit is designed for installation in cars, trucks and vans with an existing radio opening. In many cases, a special installation kit will be required to mount the radio to the dashboard. These kits are available at electronics supply stores and car stereo specialty shops. Always check the kit application before purchasing to make sure the kit works with your vehicle. If you have trouble locating a kit or need installation assistance, contact Technical Support at 1-80
Summary of the content on the page No. 9
MP6211 Kit Installation If your vehicle requires the use of an installation kit to mount this radio, follow the instructions included with the installation kit to attach the radio to the mounting plate supplied with the kit. 1. Wire and test the radio as outlined in the Universal Installation instructions. 2. Install the radio/mounting plate assembly to the sub-dashboard according to the instructions in the installation kit. 3. Attach the support strap to the radio and dashboard as described i
Summary of the content on the page No. 10
T T T T C C C C L L L L E E E E E E E E S S S S H H H H S S S S PU PU PU PU MP6211 Balance OPERATION To adjust the balance from “L12” (full left) to ”R12” (full right), press the volume control until Power “BAL” appears in the display. Rotate the control clockwise or counter-clockwise to adjust the Press the power button (1) or any other button on the front of the radio (except Eject) to turn balance between the left and right speakers. “C00” represents a center balance. the unit on. Press t
Summary of the content on the page No. 11
MP6211 Menu Operation A second function of DISPLAY / MENU, is to access a menu of radio options. Press DISPLAY / MENU for more than three seconds to access the menu. “Menu” will appear in the display. Navigate the menu by pressing DISPLAY / MENU to move forward to the next option. The menu can also be navigated by using the Up Tuning (10) or Down Tuning (11) button to move to the next or previous option. Once the desired option appears in the display, adjust that option by rotating the volu
Summary of the content on the page No. 12
MP6211 character, press in on the volume control to move to the next space and select the next the unit. In these circumstances, pressing the RESET button will clear the system and return character. To leave a blank space, press the volume control again. the unit to normal operation. Greeting Note When the unit is powered on, one of three greetings is displayed based on the time of day: “Good Morning”, “Good Afternoon” or “Good Evening”. When the unit is powered off with the ignition on, the
Summary of the content on the page No. 13
MP6211 Automatically Store / Preset Scan (AS/PS) TUNER OPERATION Automatically Store The MP6211 comes equipped with a World Tuner, allowing you to receive channels in USA, Select six strong stations and store them in the current band using the Automatic Store feature. EUROPE, LATIN, & OIRT (Russia). See “Frequency Spacing” on page 7 to learn how to To enable this feature, press and hold AS/PS (21) for more than two seconds. The radio will change the World Tuner options. automatically scan th
Summary of the content on the page No. 14
MP6211 CD PLAYER OPERATION Insert and Eject CD Insert a CD label side up. To stop CD play and eject the CD, press the eject button (22). NOTE: The unit is designed for play of standard 5” (12 cm.) compact discs only. Do not attempt to use 3” (8 cm.) CD singles in this unit, either with or without an adaptor, as damage to the player and/or the disc may occur. Such damage will not be covered by the warranty on this product. Pause Press the pause button (12) to suspend disc play. Press the pau
Summary of the content on the page No. 15
MP6211 Entering ID3 Tag MP3/WMA OPERATION This unit supports ID3 tag versions 1.0 and 1.1. MP3 and WMA (Windows Media Audio) music files are digital audio files that are compressed For the character codes, refer to the table to the to allow more files on a single CD. This unit can play MP3/WMA directly from files contained on right. The unit also supports CD-TEXT encoded a CD-R/RW using the buttons on the receiver (or optional remote) as described below. Many discs for Album, Track and Art
Summary of the content on the page No. 16
MP6211 "99". For example, a medium with the following folder/file hierarchy is subject to Folder Search, Track Select File Search or Folder Select as shown below. Press the Up Tuning (10) or Down Tuning (11) button for less than one second to advance to the next track on the disc, or for more than one second to fast forward or fast reverse through the disc. Disc play starts when the button is released. Navigating Folders Press the Folder Down (16) button (also the “5” button) to skip to the n
Summary of the content on the page No. 17
MP6211 CD CHANGER OPERATION JPORT OPERATION Please call Jensen technical support at 1-800-323-4815 for a complete list of CD changers After the JPORT has been installed and connected, press the RESET button (24) to initialize compatible with this unit. The following Jensen CD Changers are compatible with this unit: the installation. The JPORT can be used to control your iPod or an optional CD Changer. JCH10RF and CH1001. Refer to the owner’s manual included with the JPORT for instructions rega
Summary of the content on the page No. 18
MP6211 REMOTE CONTROL CARE AND MAINTENANCE The remote control will allow you to control the basic functions of the MP6211. CD Player The remote control sensor is right of the IX-BASS (5) button. The following guidelines will help you extend the life of your CD player: 1. When cleaning the vehicle interior, do not get water or cleaning fluids on the unit. 2. The CD player will not operate properly in extreme hot/cold or under damp conditions. In case of such conditions, wait until the vehicle i
Summary of the content on the page No. 19
MP6211 TROUBLESHOOTING SPECIFICATIONS Problem Cause Corrective Action Does not operate No power to yellow wire; no Check connection with test light; (display does not light) power to red wire check vehicle fuse with test light Inline fuse blown Replace fuse No power to unit Inline fuse blown Check/replace fuse No speakers operate Speaker harness not Connect speaker harness; check (display lights normally) connected speaker wires Not all speakers Incorrect splices or Check all splices and conne
Summary of the content on the page No. 20
MP6211 12-MONTH LIMITED WARRANTY AUDIOVOX CORPORATION (the Company) warrants to the original retail purchaser of this product that should this product or any part thereof, under normal use and conditions, be proven defective in material or workmanship within 12 months from the date of original purchase, such defect(s) will be repaired or replaced with new or reconditioned product (at the Company's option) without charge for parts and repair labor. To obtain repair or replacement within the
