Summary of the content on the page No. 1
XHD6430
INSTALLATION/OWNER'S MANUAL
CD Receiver with Detachable Face
READY
Summary of the content on the page No. 2
XHD6430 INSTALLATION Preparation Please read entire manual before installation. Before You Start • Disconnect negative battery terminal. Consult a qualified technician for instructions. • Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration. Getting Started • Remove trim ring from unit, • Remove 2 transit screws located o
Summary of the content on the page No. 3
XHD6430 INSTALLATION Wiring Diagram RCA Preamp Output Connections REAR/SUB BLACK 8-pin Female Mini-DIN (selectable) BTM60 Connection (included) FRONT FRONT R/SUB L-CH R-CH REMOTE IN Antenna Connector Steering Wheel Interface Input (PAC SWI-PS required) FUSE When replacing the fuse, make sure new fuse is the correct type and amperage. Using an incorrect fuse could damage the radio. The XHD6430 uses one 10 amp ATM fuse located beside the wiring connector.
Summary of the content on the page No. 4
XHD6430 OPERATION Control Locations - Receiver 2 3 4 1 5 6 7 8 9 10 21 20 19 18 17 16 15 14 13 12 11 12 Auxiliary Input 1 Release Preset 6 / Folder Up 2 T alk 13 Preset 5 / Folder Down 3 Mode 14 Tune / Track Up 4 Power ( ) / Select 15 5 Display Tune / Track Down 16 6 Band / ESC Preset 1 / Repeat 17 7 Audio / Menu Preset 3 / Intro 18 8 Scan / HD Seek Preset 2 / Random 19 9 T ag Preset 4 / Play / Pause 20 10 Eject 21 Mute / End Call 11 USB Port The
Summary of the content on the page No. 5
XHD6430 OPERATION Control Locations - Remote 1 2 3 4 5 6 21 7 20 8 19 9 10 18 11 17 12 16 13 15 14 Mode Key 9 12 1 Power ( )/Select Mute / End Call 13 2 Volume Up 14 Key 0 / Display 3 Audio / Menu 15 T alk 4 Tune / Track Up 16 Key 8 / T ag 5 Volume Down Key 7 6 17 Scan / HD Seek / Key # Preset 4 / Play / Pause 7 18 8 Preset 3 / Intro 19 Preset 1 / Repeat 9 Preset 2 / Random Band / ESC / Key * 20 10 Preset 6 / Folder Up Tune / Track Down 21
Summary of the content on the page No. 6
XHD6430 OPERATION General Operation Faceplate Removal Press RELEASE and pull away from the left side to remove. To re-install, insert right side of faceplate first then push left side to secure. Semi-Permanent Remove trim ring and install supplied #1 x 7/32” Phillips Faceplate Installation head screw through left side of mounting frame into faceplate. Press or any other button (except eject) to turn the unit on. Power On/Off Inserting
Summary of the content on the page No. 7
XHD6430 OPERATION General Operation Press and hold AUDIO/MENU for more than 3 seconds to access the Setup Menu setup menu, then press AUDIO/MENU to cycle through menu options. When desired option appears in the display, rotate the volume knob left/right to adjust or activate the desired function. Press ESC to exit the menu at any time. Setup Menu Menu Function Options Action Auto Station Press SELECT to seek and save 6 strong sta
Summary of the content on the page No. 8
XHD6430 OPERATION General Operation Escape Press ESC to exit any menu adjustment mode. Audio Press AUDIO/MENU momentarily to select between Bass, Treble, Balance, Fader, EQ, Subwoofer* and Source Volume Level. BASS TREBLE BALANCE FADER EQ SUBWOOFER* SOURCE LEVEL Bass Press AUDIO/MENU until BASS appears, then rotate the volume knob left/right to adjust (-6 minimum / +6 maximum). Treble Press AUDIO/MENU until TRE
Summary of the content on the page No. 9
XHD6430 OPERATION HD Radio™ AM/FM Tuner Operation Analog and Digital Tuning The following tuning functions will access both analog and digital stations. Refer to the HD SEEK mode section on page 10 for instructions on tuning to only digital stations. Seek Tuning Press TUNE or TUNE for more than one second nn ll to seek the next strong station. When an HD Radio station is selected, an HD Radio logo will begin to flash on the dis
Summary of the content on the page No. 10
XHD6430 OPERATION HD Radio™ AM/FM Tuner Operation Display When the unit is tuned to an analog station , press DISP to toggle the display between the following options: (LINE 1) FREQUENCY FREQUENCY (LINE 2) BAND/PRESET CLOCK When the unit is tuned to an HD Radio station , press DISP to toggle the display between the following options: (LINE 1) FREQUENCY ARTIST PROGRAM TYPE FREQUENCY (LINE 2) BAND/PRESET SONG TITLE STATION NAME CLOCK When information is
Summary of the content on the page No. 11
XHD6430 OPERATION ® iTunes Tagging Overview The iTunes T agging feature of the XHD6430 allows the user to "T ag" songs that are playing on HD Radio™ stations and ® enables them to be purchased later through iTunes . With the touch of a button the unit will remember the title and artist song information, and then transfer that information to your iPod device the next time you connect it to the XHD6430. A new list called "T agg
Summary of the content on the page No. 12
XHD6430 OPERATION ® iTunes Tagging Troubleshooting Description Displayed Message There is a compatibility issue with the iPod device that is connected. Check the list of compatible iPod devices below. CHECK iPod VER If the attached iPod device is compatible, update the firmware to ® the latest version using iTunes . T ags are being sent to the iPod device. This process can take SENDING TAGS several minutes depending on the number of T
Summary of the content on the page No. 13
XHD6430 OPERATION CD Player Operation Insert CD With the label facing up, insert a standard size CD into the CD slot. The CD will automatically begin playback. Eject CD Press EJECT to eject the CD. The unit will change to previous mode of operation (AM/FM, AUX, USB, operation of iPod or Bluetooth). If the disc is not removed within 10 seconds, the unit will reload the disc. The unit does not have to be turned on to eject C
Summary of the content on the page No. 14
XHD6430 OPERATION CD Player Operation - MP3/WMA Files Playing an MP3/WMA Disc When an MP3/WMA encoded disc is first inserted, “CD PLAY” will appear in the display. Depending on the number of files and folders, this may take several seconds. Displaying Information Press DISP to select between the following: (LINE 1) FILE NAME ARTIST ELAPSED TIME TRACK NUMBER (LINE 2) FOLDER NAME SONG TITLE CLOCK TOTAL TRACKS “NO ID3 TAG” will be displayed if the
Summary of the content on the page No. 15
XHD6430 OPERATION CD Player Operation - MP3/WMA Files Folder/File Search Mode Press SELECT to enter the folder/file search mode. The head unit will read the CD, and a list of folders and files from the CD will be displayed. The search will always begin from the current directory. Folder/File Navigation When searching the contents of a folder or subfolder, press ESC to navigate up one folder level. Turn the volume knob to cycle
Summary of the content on the page No. 16
XHD6430 OPERATION CD Player Operation - MP3/WMA Files Folder Access Press to select the previous folder. Press to select the next folder. Note: Folder access is only available on MP3/WMA discs recorded with more than one folder. Repeat Press RPT to enter the Repeat menu, then turn the volume knob to select one of the following options: • OFF - Plays all tracks on CD. • TRACK - Continuously repeats selected track.
Summary of the content on the page No. 17
XHD6430 OPERATION CD Player Operation - MP3/WMA Files Media Compatibility The following types of discs/files are compatible: • CD-ROM (ISO), CD-R, CD-RW • CD-D A • MP3 data • WMA data The following types of discs/files are not compatible: • WMA files that are protected by DRM (Digital Rights Management). • WMA lossless format • Discs recorded with Track At Once or packet writing • MP3 PRO format • MP3 playlists • WAV format Playb
Summary of the content on the page No. 18
XHD6430 OPERATION CD Player Operation - MP3/WMA Files Additional MP3/WMA An internal buffer provides ESP (Electronic Skip Protection) Information to virtually eliminate skipping. When playing a disc recorded with regular audio files (CD-D A or .WAV) and MP3/WMA files, the unit will play the MP3/WMA files only. Only MP3 files with filename extension (.mp3) can be played. O n l y W M A f i l e s w i t h f i l e n a m e e x t e n s i o
Summary of the content on the page No. 19
XHD6430 OPERATION USB Operation - MP3/WMA Files Connecting a USB Device Play MP3/WMA files from most mass storage devices by (sold separately) connecting them to the XHD6430's USB port. Playing Music When a USB device is first connected, “READING” will appear in the display and playback will begin momentarily. Depending on the number of files and folders, it may take several seconds for the device to begin playing. If no valid MP
Summary of the content on the page No. 20
XHD6430 OPERATION USB Operation - MP3/WMA Files Displaying Information When a file is accessed, the clock and elapsed time will be displayed. Press DISP momentarily to select file name (default), song title, artist, track number or clock & elapsed time. (LINE 1) FILE NAME ARTIST ELAPSED TIME TRACK NUMBER (LINE 2) FOLDER NAME SONG TITLE CLOCK TOTAL TRACKS "NO TITLE" will be displayed if no song title information is available. "NO ARTIST" will
