Summary of the content on the page No. 1
XD5110
INSTALLATION/OWNERS MANUAL
AM/FM/CD Receiver
Summary of the content on the page No. 2
XD5110 INSTALLATION Preparation Please read entire manual before installation. Before You Start • Disconnect negative battery terminal. (consult a qualified technician for instructions) •Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration. Getting Started • Remove 2 transit screws located on top of the unit. • Remove trim ring by pulling up gently in the center. • Insert the su
Summary of the content on the page No. 3
XD5110 INSTALLATION Installation TYPICAL MOUNTING METHOD 3
Summary of the content on the page No. 4
XD5110 INSTALLATION Wiring Antenna Diagram Connector RCA Cable (sold separately) GRAY Rear Preamp Output Connect to amplifier RCA Input BLUE Remote Turn-On Connect to amplifier or power antenna. Insulate wire if not used. AMP BLACK Ground Connect to vehicle chassis ground. 1 AMP AGC Fuse RED Accessory Connect to existing ignition circuit or switched 12 volt source. 5 AMP FUSES AGC Fuse When replacing fuses, YELLOW Memory make sure new fuse is the Connect to battery circuit or constant 12 volt so
Summary of the content on the page No. 5
XD5110 OPERATION Control Locations 1 2 3 4 12 10 9 8 7 6 5 13 11 1 8 Power Play/Pause 2 Volume 9 Bass Boost/CD Random 3 Track Up/Down 10 Mono/Stereo/CD Intro 4 Eject 11 Reset 5 12 Band Audio 6 13 Display Tuning 7 Local/Distance/CD Repeat 5
Summary of the content on the page No. 6
XD5110 OPERATION General Operation Power On/Off Press PWR to turn the unit on. Inserting a CD will turn the unit on automatically. Press PWR to turn the unit off. CD Mode Insert a CD or press / II to begin or resume l playback. Tuner Mode Press PWR or BAND to begin or resume tuner operation. Bass Boost Press BASS to activate and deactivate bass boost curve. Activating this feature will enhance the bass frequencies when listening to music at low volumes. Volume Adjust volume using VOL ▲ or VOL▼ (
Summary of the content on the page No. 7
XD5110 OPERATION General Operation Reset Press and hold for more than 2 seconds to RESET the unit upon initial installation or if abnormal opeartion occurs. Audio Press AUD to select between Volume (default), Bass, Treble, Balance & Fader. Bass Press AUD until BAS appears Press VOLUME ▼ or ▲ to adjust (7 maximum / -7 minimum) Treble Press AUD until TRE appears Press VOLUME ▼ or ▲ to adjust (7 maximum / -7 minimum) Balance Press AUD until BAL appears Press VOLUME ▼ (LEFT) or ▲ (RIGHT) to adjust (
Summary of the content on the page No. 8
XD5110 OPERATION Tuner Operation Tuning Turn TUNE knob to select desired station. FM Mono/Stereo Press MONO during FM tuner operation to select mono or stereo (default) reception of the broadcast signal. Local/Distance Press LOC to activate local tuning for strong station reception only. Press LOC again to cancel and resume Distance tuning (default). Band Press BAND to select between FM and AM bands. 8
Summary of the content on the page No. 9
XD5110 OPERATION CD Player Operation With the label facing up, insert a standard CD into the Insert CD CD slot. The CD will automatically begin playback. Press the EJECT button to stop and eject the CD. The Eject CD unit will change to tuner mode. If the disc is not removed within 10 seconds, the unit will reload the disc. Press TRACK >> to skip to the beginning of the next Track Select track. Press TRACK << to return to the beginning of the current track. Pressing TRACK << again skips to the be
Summary of the content on the page No. 10
XD5110 WARRANTY Limited One-Year Warranty This warranty gives you specific legal rights. You installation/removal costs, damage resulting may also have other rights which vary from from accident, misuse, abuse, neglect, product state to state. modification, improper installation, incorrect line voltage, unauthorized repair or failure to Namsung America Inc. warrants this product to follow instructions supplied with the product, or the original purchaser to be free from defects in damage occurrin
Summary of the content on the page No. 11
XD5110 OPERATION Specifications CD Player Signal-to-noise: >86dB Frequency response: 20Hz-20kHz Channel separation @ 1kHz: >65dB D/A converter: 1 Bit FM Tuner Tuning range: 87.5MHz-107.9MHz Usable sensitivity: 12dBf 50dB quieting sensitivity: 16dBf Stereo separation @ 1kHz: 40dB Frequency response: 30Hz-13kHz AM Tuner Tuning range: 530kHz-1720kHz AM sensitivity: 30uV Frequency response: 80Hz-2kHz General Total power output: 100 Watts Peak Power output: 25Wx4 @ 4 ohms, 14.4 VDC Operating voltage
Summary of the content on the page No. 12
XD5110 OPERATION Troubleshooting Problem Cause Action Unit will not Yellow or red wire not connected or Check connections for proper incorrect voltage voltage (11~16VDC) turn on (no power) Black wire not connected Check connection to ground Fuse blown Replace fuse Unit has power Speaker wires not connected Check connections at speakers (but no sound) One or more speaker wires touching Insulate all bare speaker wires each other or touching chassis from each other and chassis ground ground Unit b
