Summary of the content on the page No. 1
MXD40
INSTALLATION/OWNERS MANUAL
AM/FM/CD Marine Receiver with Detach Face
MARINE
Summary of the content on the page No. 2
MXD40 INSTALLATION Preparation Please read entire manual before installation. Before You Start • Disconnect negative battery terminal. (consult a qualified technician for instructions) • Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration. Getting Started • Remove 2 transit screws located on top of the unit. • Insert the supplied keys into the slots as shown, and slide the unit
Summary of the content on the page No. 3
MXD40 INSTALLATION Wiring Diagram Antenna Connector RCA Cable (sold separately) GRAY Rear Preamp Output Connect to amplifier RCA Input BLUE Remote Turn-On Connect to amplifier or power antenna. Insulate wire if not used. AMP BLACK Ground Connect to 5 AMP chassis ground. AGC Fuse YELLOW Memory Connect to battery circuit or constant 12 volt source. 0.5 AMP AGC Fuse FUSES When replacing fuses, make sure new fuse is the RED Accessory correct type and amperage. Connect to existing ignition circuit o
Summary of the content on the page No. 4
MXD40 OPERATION Control Locations 1 2 3 4 5 6 18 17 16 15 14 13 12 11 10 9 8 7 Release Preset 6 1 10 Volume Preset 5 2 11 Tune/Track Up Preset 4/CD Random 3 12 Band Preset 3/CD Repeat 4 13 Bass Boost Preset 2/CD Intro 5 14 Eject Preset 1/CD Top 6 15 Display Audio 7 16 8 Play/Pause 17 Power 9 Auto Store/Preset Scan 18 Tune/Track Down MARINE The MXD40 Marine Receiver features UV resistant faceplate construction and clear-coated circuit boards for long lasting protection against the elements in the
Summary of the content on the page No. 5
MXD40 OPERATION General Operation Faceplate Removal Press REL and pull away from the left side to remove. To re-install, insert right side of faceplate first then push left side to secure. *For semi-permanent faceplate installation, remove trim ring and install supplied Phillips head #1 screw through left side of mounting frame into faceplate. Power On/Off Press PWR to turn the unit on. Inserting a CD will turn the unit on automatically. Press PWR to turn the unit off. CD Mode Insert a CD or pre
Summary of the content on the page No. 6
MXD40 OPERATION General Operation Reset Press and hold for more than 2 seconds to RESET the unit upon initial installation. The RESET button is located behind the faceplate. Audio Press AUD to select between Volume (default), Bass, Treble, Balance & Fader. Bass Press AUD until BA appears Press VOL or to adjust (6 maximum / -6 minimum) Treble Press AUD until TR appears Press VOL or to adjust (6 maximum / -6 minimum) Balance Press AUD until B appears Press VOL (LEFT) or (RIGHT)
Summary of the content on the page No. 7
MXD40 OPERATION Tuner Operation Seek Tuning Press TUNE or momentarily to seek the next strong station. Manual Tuning Press TUNE or for more than 2 seconds, then press TUNE or momentarily to move radio frequency up or down one step at a time. Press and hold to advance quickly. If tuning is not adjusted for 2 seconds, the unit will return to seek tuning mode (default). Band Press BAND to select between FM1, FM2, FM3 and AM1, AM2 bands. Storing and Recalling Station Up to 18 FM stations and 12 AM
Summary of the content on the page No. 8
MXD40 OPERATION CD Player Operation Insert CD With the label facing up, insert a standard 5" CD into the CD slot. The CD will automatically begin playback. Eject CD Press the EJECT button to stop and eject the CD. The unit will change to tuner mode. Track Select Press TRACK to skip to the beginning of the next track. Press TRACK to return to the beginning of the current track. Pressing TRACK again skips to the beginning of the previous track. Fast Forward and Reverse
Summary of the content on the page No. 9
MXD40 WARRANTY Limited One-Year Warranty This warranty gives you specific legal rights. What to do? If the product requires warranty You may also have other rights which vary from service, you must prepay the initial shipping state to state. charges. DUAL will pay the return shipping charges if the product is returned to an address Namsung America Inc. warrants this product to within the USA. the original purchaser to be free from defects in material and workmanship, under normal Namsung Americ
Summary of the content on the page No. 10
MXD40 OPERATION Specifications CD Player Signal-to-noise: >86dB Frequency response: 20Hz-20kHz, ±3dB Channel separation @ 1kHz: >65dB D/A converter: 16 Bit FM Tuner Tuning range: 87.5MHz-107.9MHz FM mono sensitivity: 12dBf 50dB quieting sensitivity (stereo): 16dBf Stereo separation @ 1kHz: 40dB Frequency response: 30Hz-13kHz, ±3dB AM Tuner Tuning range: 530kHz-1710kHz AM sensitivity: 30uV Frequency response: 80Hz-2kHz, ±3dB General Total system power: 100 Watts Peak Power output: 25Wx4 @ 14.4
Summary of the content on the page No. 11
MXD40 OPERATION Troubleshooting Problem Cause Action Yellow wire not connected or incorrect voltage Check connections for proper voltage Unit will not turn on Red wire not connected or incorrect voltage (11~16VDC) (no power) Black wire not connected Check connection to ground Fuse blown Replace fuse Speaker wires not connected Check connections at speakers Unit has power (but no sound) One or more speaker wires touching each Insulate all bare speaker wires from other or touching chassis ground
Summary of the content on the page No. 12
Namsung America Inc. 21318 64th Ave. South Kent, WA 98032 Toll Free: 1-866-626-7863 ©2003 Namsung America, Inc. EVOK0603-V01
Summary of the content on the page No. 13
DMP65 INSTALLATION/OWNERS MANUAL 6.5" Dual Cone Marine Speakers MARINE
Summary of the content on the page No. 14
DMP65 INSTALLATION Preparation/Installation Please read entire manual before installation. Before You Start • Disconnect negative battery terminal. (consult a qualified technician for instructions) • Use extreme caution when drilling holes to avoid damaging fuel lines, hydraulic lines or existing wiring. Getting Started • Determine where the speakers will be mounted. Ensure an area large enough for the speaker to mount evenly. Be sure the mounting location is deep enough for the speaker to fit
Summary of the content on the page No. 15
DMP65 WARRANTY Limited One-Year Warranty This warranty gives you specific legal rights. You may What to do? If the product requires warranty service, also have other rights which vary from state to state. you must prepay the initial shipping charges. DUAL will pay the return shipping charges if the product is Namsung America Inc. warrants this product to the returned to an address within the USA. original purchaser to be free from defects in material and workmanship, under normal conditions, for
Summary of the content on the page No. 16
DMP65 SPECIFICATIONS Specifications 7.13" Outside Diameter 2.5" Mounting Depth .88" Mounting Height 5.13" Cut-out Diameter 45Hz-18kHz, ±3dB Frequency Response 90dB 1W/1M Sensitivity 4 ohms Impedance 20 Watts RMS Power 60 Watts Peak Power Specifications subject to change without notice Namsung America Inc. 21318 64th Ave. South Kent, WA 98032 Toll Free: 1-866-626-7863 ©2003 Namsung America, Inc. EVOK0603-V01
