Summary of the content on the page No. 1
Radio / Cassette
Wiesbaden
RCM 85
Operating instructions
Summary of the content on the page No. 2
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 20 19 18 17 16 3 Wiesbaden RCM 85 PORTUGUÊS ESPAÑOL SVENSKA NEDERLANDS ITALIANO FRANÇAIS ENGLISH DEUTSCH
Summary of the content on the page No. 3
Contents Short instructions ........................ 20 Sampling stored stations briefly DSC programming........................ 31 (Preset Scan) ........................................ 27 Overview of the DSC factory settings ... 32 Important notes ............................ 23 Scanning stations with CD changer control (optional) ..... 33 Radio-Scan ........................................... 27 Precautions ........................................... 23 Selecting the seek tuning sensitivity .
Summary of the content on the page No. 4
Short instructions 1 On Off 2 LD Volume Loudness - When listening at a low level, the Loudness function creates a more natural sound by boosting the low frequency range. To switch the Loudness on/off: Fader front Press LD. Fader rear For more information, read chapter Balance left This unit can also be switched on and “DSC programming”. Balance right off with the KeyCard C. Also, when being connected correctly, To alter a setting, you may turn the radio on and off via 3 AUD/GEO • press AUD or
Summary of the content on the page No. 5
5 AF - Alternative frequency during RDS 7 B/MTL Repeat titles: Press FR. operation Dolby B-NR* Skip titles: Press FF. When “AF” lights up in the display, the Press this button to play back a tape radio will automatically search for a which has been recorded with Dolby-B. 9 Cassette removal frequency offering better reception of When this button is pressed, “B” lights Press . the same RDS programme. up in the display. * Noise Reduction system manufactured under To switch AF on/off: Press AF brief
Summary of the content on the page No. 6
Tape operation: = SC/MIX @ TA (priority for traffic announcements) Radio operation If “TA” is displayed, the system will play traffic stations only. Scan (sampling all stations to be recei- ved): Press SC/MIX briefly. TA on/off: Press button. TR1--PLAY - Side 1 (or 2) Preset Scan (sampling all stations A TS - Travelstore MTL - Metal stored on the preset buttons): Press To store the six most powerful stations B- Dolby B-NR SC/MIX for approximately 2 seconds. automatically with Travelstore: CD cha
Summary of the content on the page No. 7
Important notes Precautions C KeyCard theft-protection system D Rocker switch To operate the set it is necessary that Seek tuning Before starting to use your new car radio, you have inserted the KeyCard. please read the information on “Traffic safe- ty” and “Anti-theft protection” carefully. KeyCard Traffic safety As the driver of a motor vehicle, it is your Up responsibility to pay attention to the traffic Down For this, introduce the KeyCard into the / Up/down in short intervals situation at
Summary of the content on the page No. 8
KeyCard theft-protection system Do not connect the loudspeaker outputs to This car radio is supplied with one KeyCard After approximately 10 seconds, the display ground! as standard. will show “TURN OFF”. Now turn off the set. Textteile A - E Casablan- Use only the accessory and replacement However, the unit can also be operated with When inserting a card of a different kind (like ca RCM 85 parts approved by Blaupunkt. a second card. for example a credit card), the display will If you have lost
Summary of the content on the page No. 9
Radio operation with RDS (Radio Data System) The display will switch to “CHANGE”. The Radio Data System offers you more If “SEARCH” appears in the display when convenience when listening to FM radio sta- switching on the radio or recalling one of the • Press the KeyCard in, which releases tions. stored frequencies, the unit is automatically the card and puts it in the proper positi- More and more radio stations have begun to searching for an alternative frequency. on for being removed. broadcast
Summary of the content on the page No. 10
If you leave the service area of the regional Manual tuning << >> If “AF” does not light up, programme tuned into, or if you would like to • press AF. (prerequisite: AF is switched off!) take advantage of the full RDS service, switch With this, the requirements for selecting sta- • Press << >>; the frequency will change to “REG OFF”. tions with << >> are fulfilled. in short intervals in downwards or up- • Press the AF button for approximately wards direction. 2 seconds until “REG OFF” appears. C
Summary of the content on the page No. 11
Notice: Sampling stored stations briefly To select a station currently being scan- Should you tune in a station which has alrea- (Preset Scan) ned and switch off the scan function: dy been stored before, the corresponding • Press SC/MIX briefly. With this function you can briefly sample all preset button and the memory bank will briefly If no station is selected, the scan function will SC/MIX stations. flash in the display if you have selected be automatically switched off after the fre- • Press
Summary of the content on the page No. 12
Receiving traffic programme stations with RDS-EON Switching from stereo to mono Many FM broadcasters offer traffic messa- To switch the priority on or off: ges for their service area at regular intervals. • Press the TA button. If reception is poor, you may get better sound All traffic programme stations transmit a spe- When pressing TA while a message is being quality by switching to mono: cial carrier signal alongside their program- broadcast, this message will be interrupted. • Press the lo b
Summary of the content on the page No. 13
Tape operation Automatic seek tuning start Inserting a tape Fast Forward/Rewind (tape operation) • Turn on the set. Fast Forward When leaving the reception area of the tuned • Press FF. • Insert a tape. in traffic programme station while listening to At the end of a tape side, the mecha- a tape, the system will automatically start nism changes directions automatically Insert the tape with side A or 1 showing up, the searching for a new TA programme. to play the other side. open side facing to th
Summary of the content on the page No. 14
by” and the double-D symbol are trademarks of Dolby PROG selector To switch the function on/off: Laboratories Licensing Corporation. (To change the tape direction during • Press CPS. cassette playback) “CPS ON” or “CPS OFF” will light up in the MTL display for approximately 2 seconds. • Press FR and FF simultaneously. Switch on the MTL function to select the best equalisation response when using metal or At the end of a tape side, the mechanism With “CPS ON”: CrO tapes. “MTL” will light up in th
Summary of the content on the page No. 15
DSC programming Tape care DSC (Direct Software Control) allows you to DIS (dx) customise certain programmable, basic set- To adjust the seek tuning To avoid possible problems, you should not tings to suit your personal needs and prefe- sensitivity for distant recep- use cassette tapes longer than 60 or 90 rences and then store them. tion. minutes (C60/C90). Store your tapes in a The basic settings for this audio equipment DIS. 1- high sensitivity cool place away from dirt, dust and tempera- were
Summary of the content on the page No. 16
BEEP Confirmation tone for all LOUD Loudness - When listening Overview of the DSC factory functions which require a at a low level, the Loud- settings button to be pressed for ness function creates a LOCAL : 1 more than 2 seconds. more natural sound by DIS : 1 The volume can be adju- boosting the low frequency TIME : OFF sted from between 0 to 9. range. TA VOL : 4 (0 = off) LOUD 1 - Low boost Each alteration of this va- BEEP : 3 LOUD 6 - Max. boost lue is confirmed by a beep LED (Code) : 1 tone
Summary of the content on the page No. 17
CD changer control (optional) You can operate the Blaupunkt CD changer Selecting a disc/track using the To stop the SCAN: CDC-A05 in combination with this car radio. rocker switch • Press the SC/MIX button briefly once again. The system will continue to play the currently scanned track. Switching to changer operation with SRC on the car radio MIX Make sure that a magazine is inserted. Press SRC to switch between the different Use the MIX function to play the tracks of the audio sources (radio -
Summary of the content on the page No. 18
Appendix Specifications Amplifier Output power: 4 x 19 W RMS power acc. to DIN 45324/3.1 or 4 x 20 W max. power acc. to DIN 45324/3.2 FM waveband Sensitivity: 1,0 µV at 26 dB signal-to-noise ratio Frequency response: 35 - 16 000 Hz Tape player Frequency response: 35 - 16 000 Hz Subject to modifications! 34 Wiesbaden RCM 85
Summary of the content on the page No. 19
Blaupunkt-Werke GmbH Bosch Gruppe 5/95 Pf K7/VKD 3 D95 173 012 (SF) PM 18 Wiesbaden RCM 85
