Summary of the content on the page No. 1
Radio / Cassette
Augsburg RCR 87
Essen RCR 127
Verona RCR 127
Operating instructions
Augs87/Es/Ver127 d® 1 15.05.2002, 11:14 Uhr
Summary of the content on the page No. 2
1 2 3 4 5 6 Verona RCR 127 Augsburg RCR 87 Essen RCR 127 13 12 11 10 9 8 7 2 Augs87/Es/Ver127 d® 2 15.05.2002, 11:14 Uhr
Summary of the content on the page No. 3
Contents Quick reference ............................ 21 Scrolling through the broadcasting DSC programming ....................... 33 networks................................................ 28 Overview of DSC factory settings ........ 35 Important notes ............................ 24 Changing the memory bank ................. 28 Appendix ....................................... 35 Precautions ........................................... 24 Storing stations .....................................
Summary of the content on the page No. 4
Quick reference Switching on with the ignition being 3 TS / FM (Augsburg RCR 87, Essen 1 On Off switched off: RCR 127) Volume To keep on operating the set when the Selector key to access the memory When switching the set on with the ignition is switched off (KeyCard is in- banks I, II and T. knob, the KeyCard has to be inserted. serted), proceed as follows: TS / BND (Verona RCR 127) The unit will play with the pre- Turn the knob to switch the unit off, Selector switch to access the FM adjusted
Summary of the content on the page No. 5
5 Cassette loading slot 8 1, 2, 3, 4, 5 - preset buttons Read also the information in chapter Insert the tape with side A or 1 facing You can store five stations for each of “KeyCard theft protection system”. up, the open side showing to the right. the memory banks I, II and T. To store a station: Press a preset Flashing KeyCard tongue 6 Reversing the tape / button during radio operation and hold When the radio is turned off and the Fast winding down until the set resumes play KeyCard removed, t
Summary of the content on the page No. 6
: Display ; Rocker switch < AUD To adjust the treble, bass, balance and Radio operation fader. a If the display shows “TRE” or “BAS”, you can adjust the reproduction of the treble and bass frequencies with the c d e f g h i rocker switch. If “BAL” or “FAD” is dis- played, you can set the balance (left/ b right) and fader (front/rear). Briefly press AUD as many times as / Station search required and make the setting using Up a) NDR1 NDS - Station name the rocker switch. Down b) TR 1 - Track (si
Summary of the content on the page No. 7
Important notes Extra function AUD Installation Precautions Loudness - When listening at a low Before starting to use your new car radio, If you would like to install your new car ster- level, the Loudness function creates a please read the following information care- eo yourself or add other audio components more natural sound by boosting fully. to existing ones, then please read carefully the low frequency range. the enclosed instructions on installation and Loudness on/off: Press AUD for ap-
Summary of the content on the page No. 8
KeyCard theft protection system This piece of equipment is supplied with one The system will switch off after approximate- • Push in the KeyCard. The card is re- KeyCard, though you can also operate the ly 10 seconds. leased and put in the proper position set with a second KeyCard. When inserting another card type (e.g. for being removed. If you have lost your KeyCard or if it was phone or credit card), the display will show • Remove the first KeyCard and insert damaged, you can buy a second / e
Summary of the content on the page No. 9
Selecting the audio source Short Additional Memory Optical indication of anti-theft Using the SRC button you can switch be- (S.A.M.) protection tween radio and tape operation. Tape operation is only available if a cassette Using the second KeyCard to be purchased Flashing KeyCard tongue is inserted. at any specialised dealership, you can pro- When the vehicle is stationary and the Key- To switch to another source, gram a short text by selecting the DSC menu Card removed, the KeyCard tongue can b
Summary of the content on the page No. 10
Radio operation with RDS (Radio Data System) The Radio Data System offers you more If “SEARCH” appears in the display when You can select REG ON or REG OFF in the convenience when listening to FM radio sta- switching on the radio or recalling one of the DSC menu. For more information, refer to tions. stored frequencies, the unit is automatically chapter “DSC programming - REG ON/ More and more radio stations have begun searching for an alternative frequency. OFF”. to broadcast RDS information al
Summary of the content on the page No. 11
Station tuning Manual tuning: Changing the memory bank • Press << >>. The frequency will Automatic tuning / You can shift between the memory banks I, change in short intervals in downwards II and T in order to store stations and recall • Press / ; the car radio will automati- or upwards direction. them later. cally search for the next station. When holding the right or left part of the rock- The currently selected memory bank is in- When keeping the upper or lower part / er switch depressed, the
Summary of the content on the page No. 12
Notice: Recalling stored stations Selecting the seek tuning sensi- Should you tune in a station which has al- tivity You can recall any stored station at the touch ready been stored before, then the corre- of a button. You can alter the automatic seek tuning sponding preset position will briefly flash in sensitivity. • Select the memory bank with TS/FM or the display. If “lo” is displayed, the radio will only pick up TS/BND. strong, local stations. • Press the corresponding preset button Automat
Summary of the content on the page No. 13
Receiving traffic programme stations with RDS-EON Loudness EON stands for Enhanced Other Networks, Traffic announcement priority meaning the exchange of information with- on/off Adjusts the low bass frequencies for a more in a radio network. natural sound. If the priority for traffic announcement pro- Many FM broadcasters offer traffic messag- grammes is activated, “TA” will light up in Switching Loudness on/off: es for their service area at regular intervals. the display. • Press the AUD button
Summary of the content on the page No. 14
Switching off the beep tone Adjusting the volume for traffic announcements and the beep a) Tune into another station offering traf- tone fic information: This volume was preset at the factory, • Press the rocker switch or though you can alter the value using the • press a preset button which has a DSC function (see “DSC programming – TA traffic programme station allocated VOL”). to it. You can also change the announcement and Alternatively: beep volume for the current message only. b) Switch off
Summary of the content on the page No. 15
Cassette operation To stop fast forward Notice: The car stereo has to be switched on. If there is too much tension on the tape dur- • press FR. The unit will automatically switch to tape ing playback, the set may reverse the direc- operation when inserting a cassette. tion by itself before having reached the end Fast rewind of the tape side. In this case check the con- • Press FR (fast rewind). Inserting a tape dition of the cassette tape. Sometimes it At the beginning of the tape the unit helps
Summary of the content on the page No. 16
DSC programming Care notes Refer to “Radio operation DSC (Direct Software Control) allows you with RDS / REG - regional to customise certain programmable, basic To avoid possible problems, we recommend programme”. settings to suit your personal needs and you to use C-60/C-90 type cassette tapes preferences and then store them. only. Store your tapes in a cool place away The basic settings for this audio equipment RM ON/OFF (Radio Monitor) from dirt, dust and temperatures exceeding were made at t
Summary of the content on the page No. 17
LEARN KC To “train” a second Key- volume adjusted for the pro- LO/DX To adjust the seek tuning Card. gram is lower. sensitivity for local or distant Please read the information If the program volume is stations. in chapter “KeyCard theft higher than the TA VOL lev- LO - local stations protection system - Training el, the traffic report will be LO 1 - high sensitivity a second KeyCard”. played slightly louder. LO 3 - normal sensitivity DX - distant stations LED ON/OFF You can choose between LOUDN
Summary of the content on the page No. 18
Appendix Overview of DSC factory set- FM sensitivity: 1.0 µV at 26 dB Specifications tings signal-to-noise ratio Amplifier REG OFF Output power: 4 x 23 W RMS power FM frequency response: RM OFF acc. to DIN 45324 at 35 - 16 000 Hz READ KC - 14.4 V LEARN KC - 4 x 35 W max. power Tape player LED ON Frequency response: BEEP 4 Augsburg RCR 87: 40 - 15 000 Hz TA VOL 35 4 x 19 W RMS power LOUDNESS 3 acc. to DIN 45324 at STEREO 14.4 V DX 1 4 x 20 W max. power (Verona RCR 127): Tuner AM ON Wavebands: FM
Summary of the content on the page No. 19
Blaupunkt telephone hotline Address of the next service centre in your vicinity (only for Germany) If you would like to know the address of the next Blaupunkt service centre of your area without having our service list at hand: - Find out your area code. - Then call the following chargeable phone number: 01 80 / 5 25 56 66. - Using the area code to be entered you will be automatically given the address and phone number of the next Blaupunkt service centre. You can also request this information b
Summary of the content on the page No. 20
Blaupunkt-Werke GmbH Bosch Gruppe 12/96 Pf K7/VKD 8 622 400 990 20 Augs87/Es/Ver127 d® 20 15.05.2002, 11:15 Uhr
