Summary of the content on the page No. 1
MPA6611X
General
INTRODUCTION
• INTEGRATED SD CARD READER
Congratulations on your purchase of the Jensen MPA6611X Mobile Receiver. It’s a good idea
• Supports MP3 and WMA Playback
to read all of the instructions before beginning the installation. We recommend having your
• Supports up to 1GB SD card
Jensen MPA6611X installed by a reputable installation shop.
• INTEGRATED Front Panel USB Input
• USB 2.0 compatible
Features
• Supports up to a 1GB SD Card
XM READY
• Supports most standard "THUMB
Summary of the content on the page No. 2
H C R A E S MPA6611X COPY TUNE E MPA6611X PREPARATION Tools and Supplies The following tools and supplies are needed to install the radio. • Torx type, flathead and Philips screwdrivers • Wire cutters and strippers • Tools to remove existing radio (screwdriver, socket wrench set or other tools) • Electrical tape • Crimping tool • Volt meter/test light • Crimp connections • 18 gauge wire for power connections • 16-18 gauge speaker wire SPEAKER REQUIREMENTS: Only connect speakers rated in the load
Summary of the content on the page No. 3
MPA6611X WIRING Wiring with a Wiring Adapter (Purchased Separately) 15A Connect Wires You can make all these connections 11 RCA to 3.5MM cable without even being in the vehicle. 15 (is this right?) 1. Splice or crimp wires. 2. Attach wiring adapter to the car 14 wiring harness. Wiring Diagram / Color Codes 12 13 1. Power Antenna (dark blue wire) - Connect to the power antenna LINK * or a amplifier. If not used, tape jLink Side View the bare end of wire. 2. Ground (black wire) - Connect Re
Summary of the content on the page No. 4
MPA6611X Reconnect Battery INSTALLATION When wiring is complete, reconnect the battery negative terminal. This unit is designed for installation in cars, trucks and vans with an existing radio opening. In many cases, a special installation kit will be required to mount the radio into the dashboard. Technical Assistance These kits are available at electronics supply stores and car stereo specialty shops. Always If you require assistance, contact Technical Support at 1-800-323-4815 from 8:30am
Summary of the content on the page No. 5
H C R A E S MPA6611X U E COPY T N E S MPA6611X 5. Place the radio in front of the dashboard opening so the wiring can be brought through the Kit Installation mounting sleeve. If your vehicle requires the use of an installation kit to mount this radio, follow the instructions included with the installation kit to attach the radio to the mounting plate supplied with the kit. 1. Wire and test the radio as outlined in the Universal Installation instructions. 2. Install the radio/mounting plate as
Summary of the content on the page No. 6
H H C C R R A A E E S S MPA6611X Audio Menu if the sub-woofer function is activated by pressing the SUB-W button (5) on the OPERATION control panel. Power To adjust the sub-woofer level from “00” to “12”, press the volume control until “SUBWOOFER” Press the power button (1) or any other button on the front of the radio (except Eject) to turn appears in the display. Rotate the control clockwise to increase or counter-clockwise to the unit on. Press and hold the power button to turn the unit o
Summary of the content on the page No. 7
MPA6611X MID-CFQ (Middle Center Frequency) Equalizer Selector To adjust the Middle Center Frequency, press the volume control until “MID-CFQ” appears in The equalizer function applies preset sound effects to the unit’s audio output signal. Press the display. Rotate the control to select one of the following Middle Center Frequency options: IEQ5 (6) to step through the following equalizer options: “Pop”, “Jazz”, “Classic”, “Beat”, 500Hz, 1KHz, 1.5KHz, 2.5KHz. “Rock”, and “Off”. The equalizer
Summary of the content on the page No. 8
H C R A E S MPA6611X COPY CARD TUNE READER E MPA6611X TUNING (11) button to move to the next or previous option. Once the desired option appears in Illumination Color the display, adjust that option by rotating the volume control within five seconds. The “COLOR” option allows selection between two colors for the backlight illumination of the unit. “COLOR 1” is the default display and will illuminate the unit in blue backlight. Rotate the volume control to select “COLOR 2”, which will illumina
Summary of the content on the page No. 9
H C R A E S MPA6611X Reset Button TUNER OPERATION The reset button (23) is located on the front of the chassis and can only be accessed with the Select a Band front panel removed. The reset circuitry protects the microprocessor circuitry. Since resetting Press B (3) to change between three FM bands and two AM bands. Each band stores up to six the unit will erase the time and preset memories, it should only be activated upon initial preset stations. installation after all wiring is complete o
Summary of the content on the page No. 10
H H C C R R A A E E S S MPA6611X Preset Scan ® XM RADIO OPERATION Scans stations stored in the current band. Select a band (if needed). Press AS/PS (21) for less ® than three seconds. The unit will pause for ten seconds at each preset station. Press AS/PS Listeners can subscribe to XM Radio on the Web by visiting www.xmradio.com, or by again to stop scanning when the desired station is reached. calling (800) 967-2346. Customers should have their Radio ID ready (see “Displaying the Identific
Summary of the content on the page No. 11
MPA6611X Tuner Modes CD PLAYER OPERATION Press the AS/PS button (21) to change the tuner mode to the following options in the order Insert CD listed. Press the EJECT button (22) and the motorized front panel will slide down automatically to • Channel Name display the disc slot. With the label surface facing up, fully insert a compact disc into the slot • Genre (News, Sports, Hits, Kids, etc.) until the mechanism engages and pulls the disc in. After inserting a disc, the unit will pause for •
Summary of the content on the page No. 12
H C R A E S MPA6611X MP3/WMA OPERATION 22 10 11 MP3 and WMA (Windows Media Audio) music files are digital audio files that are compressed to allow more files on a single CD. This unit can play MP3/WMA directly from files contained on a CD-R/RW using the buttons on the receiver (or optional remote) as described below. Many MPA6611X types of software are available for converting audio files into MP3/WMA formats. Jensen recommends Nero, MusicMatch Jukebox or Roxio Easy CD Creator. Depending on
Summary of the content on the page No. 13
MPA6611X Entering ID3 Tag For example, a medium with the following folder/file hierarchy is subject to Folder Search, File Search or Folder Select as shown below. This unit supports ID3 tag versions 1.0 and 1.1. For the character codes, refer to the table to the right. The unit also supports CD-TEXT encoded discs for Album, Track and Artist Title information. Entering File and Folder Names Names using the code list characters are the only file names and folder names that can be entered an
Summary of the content on the page No. 14
MPA6611X Navigation Search Accessing the ID3 Tag Press B (3) twice. The LCD will display "Navigate", and the illumination around the ENTER Press AS/PS (21) repeatedly during MP3/WMA play to access the ID3 information manually. button (rotary encoder) (4) will blink. Rotate the knob to navigate through all folders and sub- The display will show any of the following information that is programmed on the disc: Folder folders on the disc. The folder names will be displayed on the LCD. Press the s
Summary of the content on the page No. 15
H C R A E S MPA6611X Track Selection Using a USB Device or SD Card Select a Track Press the UP TUNING button (10) or DOWN TUNING button (11) for < 1 second to advance to NOTE: Media (Multimedia Card / CD-R) with a ROOT directory containing only music, the next song in the current folder. movie or JPEG files may cause the RANDOM / REPEAT function to work incorrectly. To ensure the proper playback of music, movie, and JPEG files, place all media files inside Audible Fast Forward / Fast Revers
Summary of the content on the page No. 16
MPA6611X Navigating Files REMOTE CONTROL Please refer to “MP3/WMA Operation” on page 12 for information regarding directory The remote control will allow you to control the basic functions of the MPA6611X. navigation and file searching. The remote control sensor is at the top left of the SUB-W button (5). NOTE: The MPA6611X will recognize MOST flash memory based storage devices. The MPA6611X does not support USB multi-card or all-in-one card readers with a flash memory device inserted. Up to
Summary of the content on the page No. 17
MPA6611X CARE AND MAINTENANCE TROUBLESHOOTING CD Player Problem Cause Corrective Action The following guidelines will help you extend the life of your CD player: Does not operate No power to yellow wire; Check connection with test light; 1. When cleaning the vehicle interior, do not get water or cleaning fluids on the unit. (display does not no power to red wire check vehicle fuse with test light 2. The CD player will not operate properly in extreme hot/cold or under damp conditions. In light)
Summary of the content on the page No. 18
MPA6611X SPECIFICATIONS 12-MONTH LIMITED WARRANTY AUDIOVOX CORPORATION (the Company) warrants to the original retail purchaser of this product that should this product or any part thereof, under normal use and conditions, be proven defective in material or workmanship within 12 months from the date of original purchase, such defect(s) will be repaired or replaced with new or reconditioned product (at the Company's option) without charge for parts and repair labor. To obtain repair or replace
Summary of the content on the page No. 19
MPA6611X Audiovox Electronics Corporation Hauppauge, NY 11788 Technical Assistance: 1-800-323-4815 www.jensen.com © 2006 Audiovox Ver. 062106 Printed in China 19
Summary of the content on the page No. 20
MPA6611X 20
