Aiwa CDC-Z127 user manual

Summary of the content on the page No. 1

OPERATING INSTRUCTIONS
MANUAL DE INSTRUCCIONES
CDC-Z127 YU
MODE D’EMPLOI
STEREO CAR CD RECEIVER
RADIO-TOCADISCOS DE CD ESTEREOFONICO PARA
AUTOMOVIL
ENGLISH
ESPAÑOL
FRANÇAIS
OWNER’S RECORD
For your convenience, record the model number and
serial number (you will find them on the bottom side of
your set) in the space provided below. Please refer to
them when you contact your AIWA dealer in case of
difficulty.
Model No. CDC-Z127
Serial No.
8C-KCH-901-01
011120ATM-OX

Summary of the content on the page No. 2

PRECAUTIONS TABLE OF CONTENTS • Use only in a 12-volt DC negative-ground electrical BASIC OPERATION, AUDIO AND CLOCK system. ADJUSTMENT ..................................................... 2 •Disconnect the vehicle’s negative battery terminal RADIO OPERATION ................................................. 3 while mounting and connecting the unit. CD PLAYER OPERATION ........................................ 4 • When replacing the fuse, be sure to use one with an AUXILIARY EQUIPMENT ...........

Summary of the content on the page No. 3

ENGLISH 1 Press SEL repeatedly to select the mode to be BASIC OPERATION, adjusted. AUDIO AND CLOCK Pressing SEL cycles through the modes. The selected mode’s indicator flashes. ADJUSTMENT 2 Turn AUDIO CONTROL to increase/decrease the level or to select on/off for the selected mode. PWR/MUTE SEL Note AUDIO CONTROL Adjust the level or select on/off within 5 seconds, or the selected mode will return to previous state. Aligning the source levels (Source Level Adjuster) i/k DISP SRC Volume may vary e

Summary of the content on the page No. 4

Setting the clock Monaural mode When signals become weak, or reception becomes 1Press and hold DISP until the clock indicator poor, the unit automatically switches to Monaural mode flashes in the display. to reduce noise. 2 Press i (to set hour) or k (to set minute), and Local mode then turn AUDIO CONTROL. 3 Press DISP. Local mode allows you to tune in only to strong stations during Seek Tuning. 1 Press LO before you start seek tuning. Displaying the clock “LO” appears in the display. To return

Summary of the content on the page No. 5

Presetting stations manually Labeled-side up (Manual Memory) 1 Press BAND repeatedly to select the desired band (FM1, FM2, FM3, AM1, or AM2). 2 Press i or k to tune in to a desired station (see “Tuning in to a station” as well for another tuning method). Track number 3 Press and hold the desired preset station button until the unit beeps. Note A newly preset station replaces the station on the same band that was previously stored on that preset station CD indicator Elapsed playing time button. T

Summary of the content on the page No. 6

Random Play TROUBLESHOOTING You can play all the tracks in random order. 1 Press RNDM during CD play. Error code “RANDOM” appears in the display. In the following cases the corresponding error code To cancel Random Play, press RNDM again. indication appears. Follow the suggestions below to solve such problems. If the error code indication does Note not disappear, consult an AIWA service center. During Random Play, pressing r allows you to skip only to the beginning of the current track, not to t

Summary of the content on the page No. 7

SPECIFICATIONS RADIO SECTION (FM) Frequency Range: 87.5 MHz – 108 MHz Usable Sensitivity: 12.7 dBf 50 dB Quieting Sensitivity: 17.2 dBf IF Rejection: 100 dB Frequency Response: 30 Hz – 15,000 Hz S/N Ratio: 70 dB Stereo Separation: 35 dB at 1 kHz Alternate Channel Selectivity: 90 dB Capture Ratio: 3 dB (AM) Frequency Range: 530 kHz – 1,710 kHz Usable Sensitivity: 30 µV (30 dB) CD SECTION Frequency Response: 17 Hz – 20 kHz +0/–3 dB Dynamic Range: More than 85 dB Channel Separation: More than 60 dB

Summary of the content on the page No. 8

Printed in Indonesia