Summary of the content on the page No. 1
dlri’m$
DIGITAL AUDIO
ADC-M60Y”
COMPACT DISC CHANGER
CAMBIADOR DE DISCOS COMPACTOS
OWNER’S RECORD
For your convenience, record the model number
and serial number (you will find them on the rear of
your set) in the space provided below. Please refer
to them when you contact your AIWA dealer in
case of difficulty.
Model No. [ ADC-M60
‘eria’ ‘0 ~
Summary of the content on the page No. 2
Welcome Thank you for your purchasing this AIWA product. To optimize the performance of this unit, please read through this manual carefully. ●TABLE OF CONTENTS ~ FEATURES ● Tracks from 6 CDs stored in the disc magazine NOTE can be selected and played. This equipment has been tested and found to ● Horizontal, vertical, slanted or suspended comply with the limits for a Class B digital device, installation can be made. pursuant to Part 15 of the FCC Rules. These ● Through the window at the top of
Summary of the content on the page No. 3
■ PRECAUTIONS ● Do NOT install the unit in a location where it ● Clean the discs before inserting them into the may be subjected to: disc magazine. Always clean a disc from the — Direct sunlight or other sources of excessive center outward with a cleaning cloth. heat — Fluid, rain or moisture /. — Excessive dirt or dust — Excessive vibration ● This unit is designed to be operated on a 12-voit DC negative-ground electrical system only. ● Choose the mounting location carefully so that the unit wil
Summary of the content on the page No. 4
~ UNPACKING Compact disc magazine Connecting cable Compact disc changer Supplied mounting kit for the compact disc changer The letters are keyed to those in the instructions. Use only the supplied mounting hardware for safe and secure installation. @ Plate brackets @ Nuts (4 ea.) @ Brackets (1 pair) @ Washer screws (4 ea.) (2 ea.) e B @ e ) w ‘=.O -. / @ Adhesive label (1 sheet) Gig o ~ ENGLISH
Summary of the content on the page No. 5
■ INSTALLATIONS Precautions Mounting angle setting levers Select the mounting location very carefully, Be sure to change the position of both mounting referring to the following points. angle setting levers according to the angle at which the unit is to be installed. ● Make sure that there is no fuel tank, wiring or Mounting angla setting levers piping on the other side of the mounting surface. ● Make sure that the installation of the unit will not hinder the movement of the deck lid or interfer
Summary of the content on the page No. 6
h INSTALLATIONS Horizontal installation Construction For details on @@@..., see page 3. The effective angle of the unit. The position of the lever. Note If the mounting surface needs to be strengthened, secure the plate brackets @to the bottom surface of the car trunk, etc. with the tapping screws (not supplied). Deciding the position Making holes in the carpet 2 4 Removing temporarily Completion 3 5
Summary of the content on the page No. 7
Vertical installation Construction 1 For details on @@@..., see page 3. Note ● If the mounting surface needs to restrengthened, ● If installation space is narrow, bend the plate bracket secure the plate brackets @ to the bottom surface @ back and forth along the perforated line to break off of,the car trunk, etc. with the tapping screws (not the end. supplied). Deciding the position Making holes in the carpet 2 4 plate @if it n9. — Removing temporarily Completion 3 5 ENGLISH 6
Summary of the content on the page No. 8
~ INSTALLATIONS Suspended installation Caution Before drilling the holes, make sure that there is When installing the unit in the trunk below the nothing on the other side of the mounting surface. package tray, observe the following. ● Select the mounting location carefully so that the unit does not hinder the movement of the torsion bars of the deck lid. Construction 1 For details on @@@..., see page 3. The effective angle of the unit. The position of the lever. \’-=. “d: - 0 !“@@ ‘n — \ @Jw -’
Summary of the content on the page No. 9
~ CONNECTIONS This unit is designed only for AIWA brand car stereo. Therefore you can not use the unit with other brand’s equipment. + r to AIWA brand car stereo Caution Note Use only the supplied connecting cable. Using an Be sure to disconnect the ground wire terminal of unspecified connecting cable may cause background the car battery before making a connection in noise. order to prevent short circuiting. ENGLISH 8
Summary of the content on the page No. 10
, HOW TO USE How to use a compact disc magazine 1 . With the label side up, insert a disc all the way *& a 6 discs, one in t each disc tray To remove a disc, pull part@ in the direction Recorded side of the arrow aa illustrated. 2 Open the 3 A INSERT A (eject) button Dlac magazine To remove the magazine, press the ~ button Insert the magazme (which has tIeen taken and Pull out the disc magazme. out of the unit) fv’mly wkh the .4A mark visible on the top side. 4 Close
Summary of the content on the page No. 11
~ SPECIFICATIONS Notes on the disc magazine Compact disc changar System Compact disc digital audio ● Be sure to place a disc on the disc tray with the system label side up. If a disc is not set properly, it may Frequency response 5 Hz – 20 kHz cause damage to the unit. Wow and flutter Below measurable limit Si9naI to nOiSe ratio 91 dB or more outputs Line output (for changer Disc magazine connector only) Operating temperature –1 o “c to 55 “c Dimensions 244 x63x 169 mm (w/h/d) (9 5/8X 2 1/2 x 6
Summary of the content on the page No. 12
Bienvenidos Muchas gracias por su compra de este producto AlWA. Para utilizar este aparato en Ias mejores condlclones posibles, lea cuidadosamente Ias instrucciones de este manual. ~ INDICE EDETALLES ● Sepueden seleccionar yreproducir canciones PRECAUTION de 6 discos compactoscolocados en el cargador Las modificaciones y ajustes de este producto de discos. que no han sldo autorizadas a tkulo expreso por ● Se puede instalar horizontalmente, el fabricate pueden anularel derecho o autoridad vertica
Summary of the content on the page No. 13
■ PRECAUCIONES ● NO instale la unidad en un Iugar donde pueda ● Limpie Iosdiscos antes de colocarlos en el cargador quedar expuesto a: de discos. Empiece siempre por el centro y vaya — Ios rayos del sol o a temperatures muy altas. hacia afuera Iimpiando con un paho Iimpiador, — Iiquido, Iluvia o humedad. — demasiada suciedad o polvo — vibration excesiva ● Este aparato funciona solo con CC de 12 voltios con conexion a tierra negativa. ● Seleccione cuidadosamente el Iugar para la instalacion de ta
Summary of the content on the page No. 14
■ DESEMBALAJE Cambiador de discos Cargador de discos Cable de conexion compactos compactos @ Qq.j Juego de montaje suministrado para el cambiador de discos compactos Las Ietras en circulos tienen sus referencias a 10Iargo de Ias instrucciones. Utilice solo Ias piezas para montaje suministradas para que la instalacion sea segura. @ Mensulas (1 par) @ Tornillos con @ Mensulas de @ Tuercas (4 c/u) arandela (4 c/u) placa (2 c/u) e B @ 8 %.= . R @ Etiqueta adhesiva (1 hoja) UD G 3 ESPAfiOL
Summary of the content on the page No. 15
●INSTALACIONES Precauciones Instalacion de Ios herrajes de angulo Seleccione cuidadosamente el Iugar donde se Cambie la position de instalacion de Ios herrajes vaa instalar, teniendo encuenta lossiguientes de anguio de acuerdo al angulo en el que desea puntos. instalar el aparato. Angulo de instalacion ● Confirmeque nohayauntanque decombustible detrasde Iasupetficie de montaje yquetampoco haya cables o caries. ● Lainstalacion delaunidad nodeberaimpedirel movimiento de la tapa del haul ni el desm
Summary of the content on the page No. 16
n INSTALA(.YONES Instalacion horizontal Disetio 1 Angulo efectivo del aparato. Para mas detalles de @@@..., lea la pagina 3. Position del ojete protector. ‘m 4!$ H-L Nota r Si fuera necesario reforzar la auperticie de instalacion, aaegure Ias mensulas de placa @ en la superficie inferior del bad del coche con tornillos autoterrajantes (no inciuido). Decida la position Abra orificios en la alfombra 2 Desmontaje provisorio Fin 3 ~ ESPA)iOL
Summary of the content on the page No. 17
Instalacion vertical Diseho 1 Para mas detalles de @@@..., lea la pagina 3. aparato. \ ojete protector. Nota ● Si fuera necesario reforzar la superficie de instalacion, c El espacio para su instalacion es angosto, doble la asegure Ias mensulas de placa @ en la Supetilcie mensula @ hacia atras y hacia adelante a 10Iargo de la I[nea peforada para romper la punta. inferior del haul del coche con tornillos autoterrajantes (no incluido), Abra orificios en la alfombra Decida la position 4 2 / nsula si
Summary of the content on the page No. 18
~ INSTALACIONES Precaution Instalacion colgada Verifique que no haya nada detras del Iugar de la Cuando se instala la umdad en el batil, debajo de instalacion antes de abnr Ios orificios. la bandeja para paquetes, tenga en cuenta 10s siguientes puntos. ● Selecclone cuidadosamenteel Iugardondese vaainstalar launidad, paraqueno impidael movimlento de Ias barras de soporte de la tapa del batil. Dkeiio 1 Para mas detalles de @@)@..., lea la pagina 3. Angulo efectwo del aparato. Ill v 30” 15“ Posic\o
Summary of the content on the page No. 19
●CONEXIONES Este aparato fue diseriado solo para Ios estereos de coche AlWA. Por 10 tanto, no utilice este aparato con equipos de otra marca. + Jr al estereo de coche de la marca A compactoa Nota Precaution Utilice solo el cable de conexion suministrado. El uso de Desconecte el terminal del cable a tierra de la un cable de conexion no especificado puede provocar bater(a del coche antes de hater Ias conexiones, ruidos de fondo. para evitar un cortocircuito. ESPAifOL 8
Summary of the content on the page No. 20
●UTILIZATION Utilization del cargador de discos compactos Coloque el disco compacto hasta el fondo 1 conel Iadodela etiqueta haciaarriba. e& e 6 discos, uno en t Para sacar un disco compacto, tire de la parte @ en cada bandeja de Lado grabado el sentido de la flecha, tal como se puede apreciar en discos la figura. 2 Abra la pu 3 A lN~RT Cargador de discos Boton de expulsion A Coloque el cargador, (despues de sacarlo) Presione el boton A y tire del cargador de discos. conelladodela marca &haciaar
