Grace TUNER GDI-IRDT200 user manual

Summary of the content on the page No. 1

TUNER
Internet Radio Tuner by Grace Digital









User’s Guide
Model No. GDI-IRDT200

____________________________________________________________

Summary of the content on the page No. 2

2 User’s Guide Table of Contents Important Safety Instructions and Warnings.....................................................................................4 Quickstart Guide (Wireless Connection) ..........................................................................................7 Contents.......................................................................................................................................9 Tuner controls & connections..................

Summary of the content on the page No. 3

3 Listening to a single shared track.................................................................................................32 Listening to a complete shared album .........................................................................................32 Arranging (Queuing up) tracks for playback later.........................................................................33 Arranging (Queuing up) albums for playback later .................................................

Summary of the content on the page No. 4

4 Important Safety Instructions and Warnings Please read before installation If this Internet tuner has been moved from a cold place to a warm place, DO NOT plug it in for 2-3 hours (e.g. from a cold car boot to a warm room). There is a possibility that moisture may have condensed in the Internet tuner, this can cause damage to your Internet tuner. To avoid damage please unpack your Internet tuner and allow it to stand at room temperature for 2-3 hours before use. This will help any

Summary of the content on the page No. 5

5 WARNING: • To reduce the risk of fire or electrical shock, do not expose the product to rain or moisture. • The product shall not be exposed to any dripping or splashing. Objects filled with liquids, such as vases, should not be placed on the product. • No open flame sources, such as lighted candles, should be placed on the product. • Keep the remote control battery away from children. It may cause a fire or chemical bum if mishandled. Do not recharge, disassemble, heat above 100°

Summary of the content on the page No. 6

6 ADVISORY This Product is intended for North American markets. The GRACE Wireless Internet Tuner GDI-IRDT200 is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC ADVISORY FCC Compliance and Advisory Statement: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, includi

Summary of the content on the page No. 7

7 st QUICKSTART   GUIDE - 1 time WIRELESS Set Up A broadband internet connection is required. You can connect to your broadband internet with: 1.) Wireless (Wi-Fi) modem or router connected to your broadband (cable or DSL) internet 2.) Wired LAN line connected to your broadband (cable or DSL) internet NOTE: IF your wireless (Wi-Fi) network is password (WEP or WPA) protected, please obtain your password before proceeding to Step 1. All passwords are UPPER and lower case sensitiv

Summary of the content on the page No. 8

8 st the 1 letter or number in your password is located and positioned in the center of the tuner’s st display. Press the dial inward to select the 1 letter. Continue this process until the final letter or number is selected. Once your password is entered, scroll, located and select ‘END’. NOTE: If you make a mistake at anytime, press the ‘back’ button to erase the letter(s) or number(s) and select then select the correct entry. After the final letter or number in your password is se

Summary of the content on the page No. 9

9 Contents TUNER GDI-IRDT200 Power Adapter Remote Control User’s Guide Tuner controls & connections 1. Power Button 2. Power LED Indicator 3. Remote Control Lens 4. LCD Display 5. Previous / Play Button 6. Mode Changing Button 7. Back Button 8. Tuning / Select Dial 9. 6.35 mm Headphone Jack 10. SD Card Slot 11. External Wifi Antenna 12. Ethernet Jack 13. Coaxial DigitalOutput 14. Toslink Digital Output 15-16. RCA analog Line

Summary of the content on the page No. 10

10 Tuner remote control functions and controls REMOTE CONTROL 1. MUTE: < Press to mute the voice of Earphone only> 2. POWER: 3. 0--9: 4. Back: 5. Select: . Under FM mode, long press this button to start auto scanning mode of the FM stations 6. UP\DOWN

Summary of the content on the page No. 11

11 Connect Your Tuner to Your Network Getting Started Step 1 - Power up the tuner Power your tuner by connecting to the Power Adapter with the socket labelled 5V 1.2A DC at the back of your TUNER. Turn the main power switch ON at the rear of the cabinet. CAUTION: Use only the power adapter supplied with this tuner. Connecting a power adapter other than the power adapter supplied is hazardous and may cause permanent damage to the unit, shock or fire. NOTE: Your Tuner ca

Summary of the content on the page No. 12

12 Step 2 - Scan for a wireless network connection When the display shows , press the ‘Tuner/Select’ button. NOTE: IF you make an error at any point, press the ‘Back’ button to return the previous screen The TUNER will then scan for all available wireless networks and will display: Scanning IIIIIIIIIIIIIIIIIII IF the tuner does not find a wireless network router, the display will show: No networks Found If this happens after subsequent

Summary of the content on the page No. 13

13 Step 3 - Connect to the wireless network When the ESSID for the router you want to connect is displayed on the screen, press OK. IF your network is not configured to require an encryption code, the screen should display: Connecting to Network then: Network OK IF the screen displays either WEP or WPA, a password is required: Enter WEP key HINT: The password / encryption code (WEP or WPA code ) would have OR been set up by the person who set up and config

Summary of the content on the page No. 14

14 After approximately 3 seconds, the display goes into the password entry mode: █ To enter the password, use the Tuner/Select DIAL or the UP/DOWN buttons on the remote to select each letter/number/symbol of the password in turn, pressing OK after each letter. NOTE: WEP and WPA passwords are upper and lower case sensitive and MUST be entered exactly HINT: Use the ’Back’ button to erase incorrect characters as you may have entered. IF the display

Summary of the content on the page No. 15

15 Wired network connection & tuner settings Wired connection, settings & network configurations The ‘Settings’ section on your Tuner offers numerous sub-menus that allow you to set and modify Network configurations and other features and functions for your Tuner. In the main menu, you will find from where you can modify basic configurations and settings. Alarm Clock Settings Under ‘Settings’ select where you can then scroll to find a series

Summary of the content on the page No. 16

16 IF Auto is selected, your Tuner will detect automatically for either wired connection or wireless connection. IF Wired Only is selected, your Tuner will only connect through a Wired connection. IF Wireless Only is selected, your Tuner will only connect through Wireless Wi-Fi connection. Configuring the radio to only use a Wired Ethernet connection Selecting ‘Wired Only’ will cause the radio to reboot and then only use its Ethernet connection to communicate with the network.

Summary of the content on the page No. 17

17 Listening to Your Internet Radio Tuner Settings & Network Configurations Changing the volume – headphone connection The volume control on the unit is just for adjusting the volume for the headphone. You can change the volume by turning the Tuner/Select Dial clockwise to increase the volume and counter-clockwise to decrease the volume. The display will show the volume bar. You cannot change the volume when you are in a menu or when the radio is connecting to a station. To change

Summary of the content on the page No. 18

18 allows you to choose stations starting with the geographical area allows you to choose stations according to their content, for example Classic Rock, Sport, News, etc. If you are an active Sirius subscriber with a package that includes the ability to listen to Sirius internet tuner on a non computer based product you will be able to listen to those stations on the Grace Digital tuner. You can either enter your Sirius user name and password onto the

Summary of the content on the page No. 19

19 NOTE some tuner stations do not broadcast 24 hours per day, and some stations are not always on-line. If this station has on-demand content (that is, it gives the option of listening to programmes which have already been broadcast), see “Stations which enable you to choose what you listen to”. Choosing a Pandora tuner station (Personal Tuner) This section allows for the new Grace Digital Personal tuner services. The current service is Pandora. Prior to this feature working you m

Summary of the content on the page No. 20

20 1. When a station is playing, press the and hold one of the numbers (1-10) on the remote control. 2. Select a number to assign the station to (1-10). * Please note presets 1-5 are the same for the remote & tuner and can be stored using either the tuner or remote. Playing a preset tuner station When your tuner is powered on and connected to your Wi-Fi network, briefly press the preset button (1-5) on the tuner, or 1-10 on the remote control, for the station you want to listen t