Summary of the content on the page No. 1
GEAppliances.com
Safety Information . . . . . . . . 2, 3
Owner’s Manual and
Installation Instructions
Operating/Care and
Cleaning Instructions
JN327–Recirculation only
Charcoal Filter . . . . . . . . . . . . . . . . . . . .5
JV338*–Vent options only
Grease Filter . . . . . . . . . . . . . . . . . . . . .4
JV347*–Vent & Recirculation
Hood Light . . . . . . . . . . . . . . . . . . . . . . .5
options
Hood Surfaces . . . . . . . . . . . . . . . . . . .5
JV348*–Vent & Recirculation
Controls . . . .
Summary of the content on the page No. 2
IMPORTANT SAFETY INFORMATION. READ ALL INSTRUCTIONS BEFORE USING. SAFETY PRECAUTIONS WARNING – TO REDUCE THE RISK OF WARNING – TO REDUCE THE RISK FIRE, ELECTRIC SHOCK OR INJURY TO PERSONS, OF A RANGE TOP GREASE FIRE: OBSERVE THE FOLLOWING: A. Never leave surface units unattended at high A. Use this unit only in the manner intended settings. Boilovers cause smoking and greasy by the manufacturer. If you have questions, spillovers that may ignite. Heat oils slowly on low contact the manufacturer
Summary of the content on the page No. 3
Safety Instructions Operating Instructions Installation Instructions Consumer Support INSTRUCTIONS DE SÉCURITÉ IMPORTANTES. LISEZ TOUTES LES INSTRUCTIONS AVANT D’UTILISER. PRÉCAUTIONS EN MATIÈRE DE SÉCURITÉ AVERTISSEMENT – POUR AVERTISSEMENT – POUR RÉDUIRE LE RISQUE D’INCENDIE, DE SECOUSSE RÉDUIRE LE RISQUE D’UN FEU DE GRAISSE SUR ÉLECTRIQUE OU DE BLESSURE CORPORELLE, LA SURFACE DE CUISSON DE LA CUISINIÈRE : OBSERVEZ LES PRÉCAUTIONS SUIVANTES : A. Ne laissez jamais sans surveillance les unités
Summary of the content on the page No. 4
Using the hood controls. Throughout this manual, features and appearance may vary from your model. Control Knobs (on some models) Switch Pad Controls (on some models) ON HI OFF OFF OFF ON LO HI OFF LO MED NITE FAN Control LIGHT Control Turn to HI, MED or LO as needed. Press the pad at the top to turn the light ON. Continuous use of the fan system while cooking FAN Control helps keep the kitchen comfortable and less humid. It also reduces cooking odors and soiling moisture Press the pad at the t
Summary of the content on the page No. 5
Safety Instructions Operating Instructions Installation Instructions Consumer Support Charcoal Filter—Recirculating Installations Only The charcoal filter cannot be cleaned. To remove: It must be replaced. Order filter no. Pull down on the center of the front edge WB02X10700. Replacement filters of the filter. The filter will then slip out of can be ordered from your GE supplier. the retaining tabs on the back. If the hood is not vented to the outside, To replace: the air will be recirculated th
Summary of the content on the page No. 6
Installation Range Hood Instructions Questions? Call 800.GE.CARES (800.432.2737) or visit our Website at: GEAppliances.com DUCTWORK REQUIREMENTS BEFORE YOU BEGIN Read these instructions completely and carefully. NOTE: Read the ductwork sections only if you do not have existing ductwork. If you have existing ductwork, � IMPORTANT – Save these instructions skip to the “Damage” section and proceed. for local inspector’s use. The venting system must exhaust to the outside. � IMPORTANT – Observe all
Summary of the content on the page No. 7
Installation Instructions WORKSHEET—CALCULATE TOTAL EQUIVALENT DUCTWORK LENGTH DUCT EQUIVALENT NUMBER DUCT EQUIVALENT NUMBER PIECES LENGTH x USED = TOTAL PIECES LENGTH x USED = TOTAL 1 3 ⁄4″ x 10″ 1 Ft. x ( ) = Ft. 6″ Round 53 Ft. x ( ) = Ft. Rect., wall cap (39 ft. w/o straight with damper) x ( ) = Ft. damper 7″ Round, 1 Ft. x ( ) = Ft. straight 6″ Round 72 Ft. x ( ) = Ft. roof cap 6″ Round, 1 Ft. x ( ) = Ft. straight 6″ Round 3 Ft. x ( ) = Ft. to 1
Summary of the content on the page No. 8
Installation Instructions DAMAGE – SHIPMENT/INSTALLATION TOOLS YOU WILL NEED • If the unit is damaged in shipment, return the unit to the store in which it was bought for repair or replacement. • If the unit is damaged by the customer, repair or Flat-blade and Phillips Pencil replacement is the responsibility of the customer. screwdrivers Duct tape • If the unit is damaged by the installer (if other than the customer), repair or replacement must be made by arrangement between customer and inst
Summary of the content on the page No. 9
Installation Instructions 1 CHOOSE VENT OPTION Determine the vent option that your installation will IMPORTANT: If the hood is to be installed in a require and that is available for your model from the recirculating, non-vented, ductless manner, do not below choices. knock out any vent openings in the hood. Only an electrical access hole will be knocked out of the hood. Outside top exhaust Outside rear exhaust A C 1 1 (Vertical duct–3 ⁄4″ x 10″ Rectangular) (Horizontal duct–3 ⁄4″ x 10″ Rectangu
Summary of the content on the page No. 10
Installation Instructions 5 2 REMOVE EXHAUST ADAPTOR REMOVE WIRING COVER 1 If exhausting/venting using the 3 ⁄ 4″ x 10″ Remove the wiring cover from inside the hood. rectangular duct—optional for JV338, JV347, Set the cover and its mounting screws aside. JV348 and JV367 models only: Wiring Remove the exhaust adaptor from the inside of the hood. cover Set it aside along with its mounting screws. 1 3 ⁄4″ x 10″ rectangular exhaust adaptor and screws 6 REMOVE WIRING KNOCKOUT 3 REMOVE FILTER Remov
Summary of the content on the page No. 11
Installation Instructions 1 8 10 FOR RECESSED-BOTTOM CABINETS FOR 3 ⁄4″ X 10″ RECTANGULAR ONLY DUCTED DISCHARGE INSTALLATIONS ONLY: Attach exhaust adaptor/damper over the appropriate knockout opening (for vertical or horizontal, depending on installation) with two exhaust adaptor screws. Make sure damper pivot is nearest to top/back edge of hood. Remove tape from damper flap. Wood shims (minimum thickness 3/8″) Exhaust adaptor/damper (vertical discharge position) • If the cabinets have front, si
Summary of the content on the page No. 12
Installation Instructions 11 MARK HOLES C. Outside rear exhaust 1 Select the vent option that your installation will require (Horizontal duct–3 ⁄4″ x 10″ Rectangular) and proceed to that section: • Use the diagram or the hood as a template and mark the locations on the cabinet for ductwork, A. Outside top exhaust electrical wiring and keyhole screw slots. 1 (Vertical duct–3 ⁄4″ x 10″ Rectangular) • Use the diagram or the hood as a template and mark Wood shims (recessed-bottom cabinets only–s
Summary of the content on the page No. 13
Installation Instructions 14 SCREW IN PART WAY 17 SECURE HOOD Drive a mounting screw (from the hardware packet) Slide the hood back against the wall. Tighten the part way into each center of the narrow neck of the mounting screws. Be sure the screw heads are in keyhole slots marked on the cabinet bottom. the narrow neck of the keyhole slot. 15 OPTIONAL POWER CORD KIT JXHC1 Mounting screw (4) An optional Power Cord Connection Kit, model JXHC1, is available at extra cost from your GE supplier fo
Summary of the content on the page No. 14
Installation Instructions 22 19 REPLACE WIRING COVER INSTALL LIGHT BULB NOTE: A light bulb is not shipped with the hood. Obtain one locally. Purchase and install a type A15 incandescent light bulb with an ordinary screw base, not more than 60 Watts, or a type A17 or T2 Compact Fluorescent (CFL) light bulb with an ordinary screw base, not more than 13 Watts. NOTE: Use only incandescent bulbs in models RN328, JN327 and JV338. IMPORTANT: For installation, handling and disposal precautions, Wiring c
Summary of the content on the page No. 15
Safety Instructions Operating Instructions Installation Instructions Consumer Support GE Range Hood Warranty. All warranty service provided by our Factory Service Centers, or Staple your receipt here. ® an authorized Customer Care technician. To schedule service, Proof of the original purchase visit us on-line at GEAppliances.com, or call 800.GE.CARES date is needed to obtain service (800.432.2737). Please have serial number and model number under the warranty. available when calling for servic
Summary of the content on the page No. 16
Consumer Support. GE Appliances Website GEAppliances.com Have a question or need assistance with your appliance? Try the GE Appliances Website 24 hours a day, any day of the year! For greater convenience and faster service, you can now download Owner’s Manuals, order parts or even schedule service on-line. Schedule Service GEAppliances.com Expert GE repair service is only one step away from your door. Get on-line and schedule your service at your convenience any day of the year! Or call 800.G
