Summary of the content on the page No. 1
™
S I M P L Y AMAZING
USER’S GUIDE
XL2800H2
HIGH SPEED UPRIGHT VACUUM
CLEANER WITH
™
CLEANING SYSTEM
•IMPORTANT•
SAVE THIS BOOKLET!
Includes:
• Safety Warnings
• Warranty
• Operating Instructions
• Trouble Diagnosis
• Accessories
Summary of the content on the page No. 2
IMPORTANT BEFORE OPERATING SAFETY INSTRUCTIONS CLEANER, READ ALL When using an electrical appliance, basic INSTRUCTIONS IN THIS precautions should always be followed, including the following: MANUAL CAREFULLY. READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER WARNING To reduce the risk of fire, Table of Contents electric shock, or injury: • Do not leave appliance unattended when plugged in. Unplug from outlet when not in use and before servicing. Table of Contents, • Do not use outdoo
Summary of the content on the page No. 3
ACCESSORIES Maintenance and SOLD SEPARATELY Customer Service USA: 1-800-989-3535 CANADA: 1-888-676-7325 Your ORECK vacuum cleaner is a product of precise engineering. The motor bearings are permanently lubricated and should not be ITEM PART NUMBER oiled. If you require additional information or have problems with your ORECK appliance, you may call ORECK customer service at: 1. Dust Bag, 8 Pack ™ Saniseal , ACDS, CCPK8DW - - In USA 1800989-3535 Hypo-Allergenic In Canada 1-888-676-7325 2. Belts
Summary of the content on the page No. 4
To Replace Filter Assembly Dust Bag To assist you in identifying 10 WARNING: Unplug cord from components of your vacuum, 11 electrical outlet before servicing. 9 the parts have been numbered BAG REMOVAL : as follows: 1 1 Handle section, upper 1. Unsnap bag door from base. 2 Tube, lower 2. Gently pull bag from 3 Power head cardboard collar upwards. 4 Outer bag 5 12 4 5 Paper filter dust bag 13 6 6 Power cord 7 Retaining spring 2 8 Bag tension bar 9 Zip fastener 15 7 10 On/off switch 14 11 C
Summary of the content on the page No. 5
Operating Instructions To Operate Be sure the disposable paper filter dust bag is installed Make sure the disposable paper filter dust bag is in place. properly. DO NOT operate the cleaner without a paper filter dust bag. Plug the power cord into an electrical outlet. Choose from the All paper dust bags are not the same. Your ORECK low and high speed settings by pressing the ON/LOW (l) disposable dust bags have been designed to be used with the ON/HIGH (ll) - OFF (O) switch on handle assembly
Summary of the content on the page No. 6
How to Replace a Worn Belt To Adjust or Replace Brush WARNING: Unplug cord from WARNING: Unplug cord from electrical outlet before servicing. electrical outlet before servicing. Remove the replacement To determine if the brush is belt from the storage worn, place a firm straight channel. edge across the nozzle opening. If brush bristles do not extend beyond base plate, brush should be adjusted. Remove the base plate by Remove the door by removing 5 screws. Then, removing the hold down remove th
Summary of the content on the page No. 7
4. To reassemble, check O-ring Fan on tube, and replace if Housing Bulb Replacement damaged. Vacuum will not operate properly without the tube O-ring. Slide O-ring to WARNING: Unplug cord from approximately 2" from base of tube. Replace tube by first electrical outlet before servicing. lining up slot at base of tube O-ring with inner tab inside fan • Remove lamp housing housing. Then reinsert tube by removing two (2) D and push down until the tube screws in the the top of is seated. Make sure O-
Summary of the content on the page No. 8
Troubleshooting Guide WARNING: Unplug cord from electrical outlet before servicing. SAVE SERVICE CALLS...CHECK THESE FIRST: • Is the disposable filter dust bag full? • Are pores of filter dust bag clogged with powder or fine dust? • Is anything clogging the revolving brush, lower tube, intake opening, fan housing or connector assembly opening? • Is the belt in place and turning the brush? • Are the brush ends in the proper location? • Does the brush turn freely? Are hair, string or rug fibers wo
