Summary of the content on the page No. 1
iScrub
Operating Instructions (ENG)
CSX24
MODELS:
10061090
CSX26SP
10061160
Read these instructions before using the machine
86317500-A
11/15/08
Summary of the content on the page No. 2
MACHINE DATA LOG/OVERVIEW OVERVIEW The Chariot Scrubber is a battery powered, stand-on, hard floor scrubber intended for commercial use. The appliance applies a cleaning solution onto a hard floor, scrubs the floor with brushes or pads, and then vacuums the soiled water back into the recovery tank. 86317500 CHARIOT SCRUBBER 11/15/08 2
Summary of the content on the page No. 3
TABLE OF CONTENTS GROUP PARTS LIST Machine Data Log/Overview................................2 Table Of Contents ................................................3 Bumper ..............................................................5-1 Control Panel.....................................................5-3 HOW TO USE THIS MANUAL Control Panel Housing.......................................5-5 Decal..................................................................5-7 How To Use Thi
Summary of the content on the page No. 4
HOW TO USE THIS MANUAL This manual contains the following sections: The SAFETY section contains important information regarding hazard or unsafe practices of the - HOW TO USE THIS MANUAL machine. Levels of hazards are identified that could - SAFETY result in product or personal injury, or severe injury - OPERATIONS resulting in death. - MAINTENANCE - PARTS LIST The OPERATIONS section is to familiarize the operator with the operation and function of the The HOW TO USE THIS MANUAL
Summary of the content on the page No. 5
IMPORTANT SAFETY INSTRUCTIONS When using an battery powered appliance, basic precaution must always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS MACHINE. To reduce the risk of fire, electric shock, or injury: Use only indoors. Do not use outdoors or expose to rain. Use only as described in this manual. Use only manufacturer’s recommended components and attachments. If the machine is not working properly, has been dropped, damaged, left outdoors, or d
Summary of the content on the page No. 6
HAZARD INTENSITY LEVEL The following symbols are used throughout this guide as indicated in their descriptions: HAZARD INTENSITY LEVEL There are three levels of hazard intensity identified by signal words -WARNING and CAUTION and FOR SAFETY. The level of hazard intensity is determined by the following definitions: WARNING - Hazards or unsafe practices which COULD result in severe personal injury or death. CAUTION - Hazards or unsafe practices which could result in minor pe
Summary of the content on the page No. 7
SAFETY LABEL LOCATION NOTE: These drawings indicate the location of safety labels on the machine. If at any time the labels become illegible, promptly replace them. 86244300 PRV NO. 500955 WARNING LABEL 86252520 PRV NO. 80885 BATTERY CAUTION 2-3 86317500 CHARIOT SCRUBBER 11/15/08
Summary of the content on the page No. 8
TECHNICAL SPECIFICATIONS ITEM DIMENSION/CAPACITY Nominal power 1800 W Rated Voltage 36 Volts DC Rated Amperage 50 amps Batteries 3 X12 Volt 195-215 AH @ 20 hr. rate 21 in. x 16 in. x 17 in. tall Battery Compartment Dimensions (533mm x 406mm x 432mm) Scrub Brush Motors - Disk Machine 2 x .3 HP (190 W) Scrub Brush Motors - Cylindrical Machine 2 x .75 HP (560 W) Vacuum Motor(s) .63 HP (470 W) Maximum flow rate of vacuum motor 72 cfm (33.98 liters per second) Maximum suction of vacu
Summary of the content on the page No. 9
TECHNICAL SPECIFICATIONS ITEM MEASURE Height 50.6 inches (1285 mm) Length 52.5 inches (1330 mm) Width without squeegee 26.5 inches (670 mm) Width of squeegee - Disk Machine 32.7 inches (830 mm) Width of squeegee - Cylindrical Machine 37 inches (970 mm) Width of scrub path - Disk Machine 24 inches (610 mm) Width of scrub path - Cylindrical Machine 26 inches (650 mm) LENGTH WIDTH HEIGHT SPECIAL NOTES: This appliance is not intended for use by persons The sound pressure level
Summary of the content on the page No. 10
HOW THIS MACHINE WORKS The Chariot® is a battery powered, self-propelled, The scrub deck side squeegees control the cleaning hard floor scrubber intended for commercial use. solution on the floor so that the squeegee can pick it The appliance applies a cleaning solution onto a up. hard floor, scrubs the floor with brushes, and then vacuums the soiled water back into the recovery The function of the recovery system is to vacuum tank. the soiled water back into the recovery tank. The
Summary of the content on the page No. 11
COMPONENTS 7 2 1 11 3 5 6 8 12 10 4 9 7. Recovery Dome 1. Control Panel-Drive 8. Recovery Drain Hose 2. Control Panel-Scrub 9. Scrub Deck Aqua-Mizer™ 3. Control Housing 10. Scrub Deck Skirts/Side Squeegees 4. Pedal Platform 11. Solution Cover 5. Rear Cover 6. Tank 12. Solution Drain Hose 86317500 CHARIOT SCUBBER 11/15/08 3-4
Summary of the content on the page No. 12
DRIVE CONTROLS 7 8 9 5 2 3 1 6 4 86317500 CHARIOT SCRUBBER 11/15/08 3-5
Summary of the content on the page No. 13
DRIVE CONTROLS 1. Key Switch 6. Steering Wheel 2. Emergency Stop/Brake Switch 7. Speed Control 3. Directional Control / Drive Reset Switch 8. Battery Discharge Indicator 4. Throttle Pedal 9. Hour Meter 5. Horn Button 1. KEY SWITCH Controls the power for machine functions. To turn the machine power on, rotate key clockwise. To turn the machine off, rotate key counterclockwise. When the key is turned on the battery symbol will flash while the system runs self-dia
Summary of the content on the page No. 14
DRIVE CONTROLS 5. HORN BUTTON The horn is activated by pressing the horn button. 6. STEERING WHEEL The steering wheel turns the front wheel causing the machine to change direction. 7. SPEED CONTROL Controls the maximum speed of the machine. There are two transport settings, slow and fast. To change speed, rotate the dial to either slow or fast position. The slow position is to the left (counterclockwise), fast to the right (top position). The throttle pedal will alw
Summary of the content on the page No. 15
DRIVE CONTROLS 8. BATTERY CHARGE LEVEL INDICATOR Indicates the charge level of the batteries. The meter display is divided into 10 vertical bars. Bars illuminated on the far right indicate full charge. Bars flashing near the left side indicate the batteries should be recharged. Further operation of the machine could damage the machine or the batteries. When the machine is left overnight with less than a full charge, the display may initially indicate a full charge. It will a
Summary of the content on the page No. 16
SCRUB CONTROLS A1 1 A2 A3 C B 1. FUNCTION MODE SWITCH The first two positions are for transport only. See drive controls section. A1 – Daytime cleaning/light cleaning This mode is used for light cleaning. In this mode the machine will propel at a maximum of medium speed. The scrub deck will automatically lower to a lower down pressure setting. The water will flow at a low rate. Water will automatically shut off in neutral and restart when pressure resumes. The squeegee
Summary of the content on the page No. 17
SCRUB CONTROLS A3 – Heavy scrub level cleaning This mode is used for heavy level cleaning. In this mode the machine will propel at a maximum of slow speed. The scrub deck will lower to a heavy down pressure. The water will flow at a high rate. The vacuum will flow at a high rate. B – Vacuum only mode This mode is used for picking up solution only. The brushes and water will both be up and off. In this mode the machine will propel at a maximum of medium speed. The squeegee will
Summary of the content on the page No. 18
SCRUB CONTROLS-SQUEEGEE 1 2 1. Squeegee Deflection Adjustment Knobs 2. Squeegee Pitch Adjustment Rod 86317500 CHARIOT SCRUBBER 11/15/08 3-11
Summary of the content on the page No. 19
SCRUB CONTROLS-SQUEEGEE 1. SQUEEGEE DEFLECTION ADJUSTMENT 3. SQUEEGEE DEFLECTION ADJUSTMENT KNOBS (DISK SCRUBBER) (CYLINDRICAL SCRUBBER) Adjusts the deflection along the entire length of Adjusts the deflection along the entire length of the squeegee. the squeegee. To increase squeegee blade deflection, turn the To increase squeegee blade deflection, loosen two knobs at the ends of the squeegee the bolt at the wheel axle and raise in the slots. counterclockwise. To decr
Summary of the content on the page No. 20
MACHINE OPERATION PRE-RUN MACHINE INSPECTION EMERGENCY STOP PROCEDURES Do a pre-run inspection to find possible problems 1. Push in emergency stop button. This will also that could cause poor performance or lost time from engage the parking brake and cause the breakdown. Follow the same procedure each time to machine to stop immediately. avoid missing steps. NOTE: See maintenance section for pre-run machine inspection checklist items. STARTING MACHINE NOTE: Perfo
