Sanyo SC-B555 user manual

Summary of the content on the page No. 1

SPECIFICATION
Model Power Control
HOUSEHOLD USE ONLY
SC-B550
SC-B555/B555T
With power control/
Without power control/

Summary of the content on the page No. 2

NAME AND FUNCTION OF PARTS (Assemble as indicated in the center illustration.) / Vacuum Power Adjustment Ring / Dust Indicator / Extension Pipe/ Hose Stopper/ Unclogging the Hose / The full vacuum power of the cleaner may be too strong in certain The dust indicator shows the amount of dust that has been collected in the dust The pipe is adjustable according to the height o f the user. Insert the hose stopper all the way up to the air inlet. When the hose is clogged with dust, remove it in

Summary of the content on the page No. 3

DUST DISPOSAL / If there is a reduction in suction power, turn off the vacuum cleaner, disconnect the hose and proceed as follows: 1. To separate the dust compartment from the vacuum cleaner, push the clamp button as shown. Dust compartment Clamp button 2. To remove the filter. Caution: Remove the filter slowly to prevent the dust from falling out. 3. Removing the dirt. Caution: If the dust is packed tightly and difficult to remove, lightly tap the

Summary of the content on the page No. 4

Thank you for your purchase of the Sanyo Vacuum Cleaner. Please read these instructions carefully before using. A FEW PRECAUTIONS 1. Operation without the dust compartment and /or filters in place will allow dust to enter the motor and could damage the vacuum cleaner. 2 . Keep the vacuum cleaner away from stoves and other heat sources. Heat can deform and discolor the plastic parts of the unit. 3. Keep the vacuum cleaner free of insecticides. Do not wipe with benzine, thinner,

Summary of the content on the page No. 5

Summary of the content on the page No. 6

HOW TO USE THE HOSE STAND / 1 Shorten the extension Wind Hold here pipe. 2 2 Stand the vacuum cleaner up and insert t he pipe holder into the pipe-holder hole. Pipe holder 3 Hold the hose and 1 wind it around the pipe. Pipe holder hole Caution Do not carry the vacuum cleaner while it is in the storage position. (Injury or damage may result if the hose or coupling pipe becomes unattached.) FILTER CARE / When the suction power is low and the dust has been discarded, the filter still should b

Summary of the content on the page No. 7

TM CARE OF TURBO CLEAN / TM Before caring for the TURBO CLEAN , be sure to turn OFF the switch of the unit and disconnect the plug from the outlet. If needles, pins or waste paper get stuck in the suction inlet, remove them after going through the above procedure. Trying to remove them during operation is dangerous. TM EDGE GRABBER / The Edge Grabber system is designed to help clean all the way up to the baseboards. The suction shutter is opened when the floor nozzle is pushed against t